Search
345 articles for “micro-simulation”
-
Total-internal-reflection-based optical rotation quasi-phase-matching for efficient second-harmonic generation in Cadmium Germanium Arsenide crystal
Abstract: This study investigates a total-internal-reflection (TIR)-based optical rotation quasi-phase-matching (ORQPM) approach for second harmonic generation within a cadmium germanium arsenide crystal slab. The crystal is coated with a thin film of yttrium oxide to facilitate precise control over phase shifts between p- and s-polarized light upon reflection at the slab-film interface. By leveraging the interplay between TIR- induced optical rotation and fractional QPM effects at designated bounce points, the configuration …
Published in International Journal of Crystalline Materials · Vol. 3, Issue 1, 2026 · pp. 01–09 Read article
-
Binary GA for Sidelobe Reduction and Null Steering in 5G Array
Abstract: This paper presents a comprehensive performance evaluation of a Binary Genetic Algorithm (BGA) for optimizing radiation characteristics of an active phased array antenna used in fifth-generation (5G) wireless communication systems. The primary objective is to achieve effective null steering while maintaining the desired main beam direction and simultaneously reducing the side lobe level (SLL). These improvements are essential for minimizing co-channel interference, enhancing spatial selectivity, and improving the Signal-to-Interference-plus-Noise Ratio …
Published in International Journal of Radio Frequency Innovations · Vol. 4, Issue 2, 2026 Read article
-
Advancing Asthma Management: The Synergy of Systems Biology, Artificial Intelligence, and Next-Generation Therapeutics
Abstract: Asthma is an inflammatory disorder of the respiratory tract that is chronic and heterogeneous in nature and has various effects on millions of people. Being a chronic inflammatory disease, asthma remains incurable and the major conventional treatments offer limited success due to the mask nature of its pathophysiology. Systems biology/(AI), and next-generation has greatly enhanced knowledge and the management of asthma. The approaches based on gene, transcript, protein, and metabolite …
Published in Research and Reviews : A Journal of Medical Science and Technology · Vol. 14, Issue 2, 2024 · pp. 1–12 Read article
-
Speed Control of PMSM using Optimization Methods
Abstract: AbstractThis paper represents a modelling and optimized design of speed control for a permanent magnet synchronous motor (PMSM). The PI controller of inner current loop is optimized using evolutionary algorithm like Particle Swarm Optimization (PSO) method. To illustrate effect of proposed method, the performance of evaluationary algorithm is compared with traditional optimization method i.e., Ziegler-Nichols method. The main objective of the proposed work are, develop mathematical modelling of PMSM motor …
Published in Journal of Microcontroller Engineering and Applications · Vol. 6, Issue 2, 2019 · pp. 8–16 Read article
-
Influence of Graded Channel on Performance of Symmetric Double Material Gate Insulator FDSOI MOSFET
Abstract: Abstract: In this paper, we investigate the effect on the linearity, analog and RF performance of graded channel in case of hetero-gate-dielectric FDSOI MOSFET with higher doping at source end and low doping at drain end. The major figure of merits (FOMs) studied are on-state drive current (ION), transconductance (gm), total gate capacitance (Cgg), cut-off frequency (fT), higher order derivative of transconductance (gm’, gm’’), intermodulation distortion (IMD3) and third- order …
Published in Journal of Microelectronics and Solid State Devices · Vol. 6, Issue 1, 2019 · pp. 12–17 Read article
-
Influence of Mechanical Parameters on Corrosion Behavior of Metal Coupons in Simulated Environmental Conditions
Abstract: This study investigates the influence of mechanical parameters—namely applied stress, surface roughness, and deformation history—on the corrosion behavior of metal coupons exposed to corrosive environments. Mild steel and aluminum alloy specimens were prepared with controlled variations in tensile stress, polishing grades, and cold-working levels to simulate real-world mechanical influences. These coupons were immersed in a 3.5% NaCl solution under ambient conditions, and their corrosion rates were monitored over a 30-day …
Published in International Journal of Fracture Mechanics and Damage Science · Vol. 3, Issue 2, 2025 · pp. 6–12 Read article
-
Analysis and Design of Frequency Reconfigurable Microstrip Patch Antenna using PIN Diode
Abstract: A reconfigurable antenna provides modify dynamically its frequency and radiation properties, which will provides the intentional redistribution of the RF currents over the antenna surface. Also this type of antennas provides the dynamical response. The difference between the smart antennas is its lies inside the antenna rather than in an external beamforming network. The proposed structure was simulated by using the High Frequency Structure Software (HFSS) version 15.0. The simulated …
Published in Journal of Mechatronics and Automation · Vol. 5, Issue 1, 2018 · pp. 17–23 Read article
-
Material-Level Degradation of Magnetorheological Fluids Under Long-Term Cyclic Shear
Abstract: The long-term functional stability of magnetorheological fluids (MRF) remains a key limitation for their reliable use in adaptive systems and continuously operated magnetorheological devices. In this study, the intrinsic evolution of rheological properties in a commercial MRF (MRC-C1L) is systematically examined under prolonged cyclic loading, with the aim of isolating material-level degradation mechanisms independent of device-related effects. The fluid was subjected to 120,000 low-strain oscillatory shear cycles under a constant …
Published in Journal of Polymer & Composites · Vol. 14, Issue 2, 2026 · pp. 101–112 Read article
-
Stable control of the motion of gas bubbles dissolved in a vibrating fluid in microgravity conditions
Abstract: Previous theoretical and experimental studies of the effect of vibration on gas bubbles, dissolved in a fluid, permitted to establish the localization and stable position of a “swarm” of gas bubbles at a certain level of fluid in the vessel corresponding to a certain frequency and vibration acceleration, aswell as to the volume of a swarm of gas bubbles. The control of a “swarm“ of gas bubbles in a fluid …
Published in Recent Trends in Fluid Mechanics · Vol. 8, Issue 1, 2021 · pp. 34–44 Read article
-
Influence of Agricultural Waste Materials in Concrete: A Sustainable Approach
Abstract: Urbanization and resource depletion have intensified the need for sustainable alternatives to traditional construction materials. The concrete industry, a major contributor to environmental issues due to cement production, is turning to waste materials to mitigate its impact. This review paper focuses on the use of agricultural waste as a partial replacement for cement and aggregates in high-strength concrete (HSC), with an emphasis on its influence on both fresh and hardened …
Published in Recent Trends in Civil Engineering & Technology · Vol. 16, Issue 1, 2026 · pp. 26–32 Read article
-
A Novel Technique for Improvement in Front-to-Back Ratio of MSA for WLAN/WiMAX using Corrugated Dielectric Substrate as a Reflector
Abstract: In this paper the design of a microstrip antenna (MSA) with corrugated dielectric reflector is proposed to improve the front-to-back ratio (FBR) and reduce the back lobes in radiation pattern of the antenna. The designed antenna operates at 5.8 GHz and simulated on CSTMWS’10 software. Simulation results show that proposed antenna has 21.8 dB higher FBR than that of conventional MSA.
Published in Journal of Electronic Design Technology · Vol. 6, Issue 1, 2015 · pp. 25–29 Read article
-
Analysis and Characterization of Circuits for Leakage Power Reduction at Sub-50 nm in CMOS Circuits
Abstract: This paper analyzes various techniques to decrease leakage power in complementary metal oxide semiconductor (CMOS) very large scale integration (VLSI) circuits, because due to continuous scaling of CMOS technology there is improvement in speed of semiconductor devices and the side effect of this scaling is leakage power. With the development of technology in CMOS VLSI Circuit, length of transistors has been reduced and speed of operation is increasing simultaneously. As …
Published in Journal of Electronic Design Technology · Vol. 13, Issue 2, 2022 · pp. 11–22 Read article
-
A Review on Energy Efficiency Challenges and Techniques for EE in 5G Network
Abstract: AbstractThis paper includes the survey of Energy Efficiency challenges and need in 5G network and D2D technique to improve energy efficiency without comprising the user experience. Improving the energy efficiency is important part while designing a network. The cellular systems must be energy efficient, especially in mobile communication which has made the battery constraint a major issue. This has motivated optimization of energy for the use of mobile devices. Mobile …
Published in Journal of Microwave Engineering and Technologies · Vol. 7, Issue 2, 2020 · pp. 21–29 Read article
-
Analysis of Modulation Response of a 450 nm True Blue Semiconductor Laser by Varying Differential Gain
Abstract: AbstractIn this work the analysis of modulation response of a 450 nm InGaN based multi-quantum well (MQW) true blue semiconductor laser have been presented. The internal designing of 450 nm blue laser has been done before. but the desired wavelength of 450 nm was obtained by adjusting the exact concentration of In0.211Ga0.789N/Al0.07Ga0.93N in this work. The effects on modulation response by varying the differential gain have been observed. Also, the …
Published in Trends in Opto-electro & Optical Communication · Vol. 5, Issue 1, 2015 · pp. 1–8 Read article
-
Recent Trends in Rotary Kiln and Refractory Material Patterns in Cement Production: A Review Approach
Abstract: The manufacturing of cement and other industrial operations depend heavily on rotary kilns, which use refractory materials to endure high temperatures and challenging chemical conditions. With an emphasis on their effects on durability and operating efficiency, this study looks at the most recent developments in rotary kiln technology and refractory material choices. Various rotary kiln designs, typical refractory material patterns, and the difficulties posed by kiln failures are all covered. …
Published in Journal of Experimental & Applied Mechanics · Vol. 16, Issue 2, 2025 · pp. 27–34 Read article
-
A New Analytical Expression of ASEP with MRC Diversity Over Composite Model of α-μ/Inverse Gaussian Fading Distribution
Abstract: AAbstract: Average Symbol Error Probability (ASEP) is an important performance metrics to evaluate the performance of any wireless communication system, under different modulation schemes over a fading channel. The phenomenon of shadowing and multipath fading are the two important factors which affect wireless communication. Composite modeling is an approach to accustom the effects of both simultaneously. This paper analyzes the performance of a wireless communication system over a composite model …
Published in Journal of Microelectronics and Solid State Devices · Vol. 6, Issue 1, 2019 · pp. 1–6 Read article
-
Plant-Derived Fiber-Reinforced Polymer Composites: The Impact of Compatibilizer on the Fundamental Characteristics and Degradation Properties
Abstract: By using compression molding, unidirectional polypropylene (PP) composites reinforced with banana fiber were created both with and without the use of stearic acid (SA) as a coupling agent. Four filler loading levels (10%, 20%, 30%, and 40% by weight) were employed during the composite manufacturing process, using raw banana fiber. The resulting composites underwent mechanical testing (tensile, bending, and impact characteristics). The ideal combination of mechanical properties was found in …
Published in Journal of Materials & Metallurgical Engineering · Vol. 15, Issue 1, 2025 · pp. 27–37 Read article
-
Understanding of optical power in semiconductor based SOI Structure at the signal 1550 nm
Abstract: A silicon-on-insulator (SOI) structure consists of a single crystalline silicon layer separated from the bulk substrate by a thin insulator layer. The insulator in SOI wafers is usually always a thermal silicon oxide (SiO2) layer, with a silicon wafer as the substrate. The silicon sheet can be very thin (50 nm for fully depleted transistors) or tens of micrometres thick, depending on the application. Similarly, the thickness of buried oxide …
Published in Trends in Opto-electro & Optical Communication · Vol. 12, Issue 1, 2022 · pp. 19–23 Read article
-
Networked Embedded Systems Eliminate Safety Hazards in Rail Journey
Abstract: ABSTRACT Introducing R&D into Rail transport is a good way to make sure that Railway decisions reflect the needs of passengers. Putting in place a foolproof security architecture and best brand components in the design of a safety system can ensure railway commutation in a high security environment. Managing security through proactive monitoring and event management is the key for achieving desired results. Safety and Punctuality — the two watch …
Published in Journal of Communication Engineering & Systems · Vol. 1, Issue 1-3, 2011 · pp. 34–43 Read article
-
Investigations on Piezoactuator-Based Active Vibration Isolation for Tool-Based Micromachining Applications
Abstract: Stacked piezoactuators are suitable actuators for active vibration isolation systems due to their high stiffness and fast response. However, they exhibit hysteresis nonlinearity between applied voltage and the resulting displacement. In this paper, Bouc-Wen model is used to model the hysteresis nonlinearity of stacked piezoactuator. The model parameters are estimated from the experimental voltage-displacement data of a stacked piezoactuator using “Trust-region nonlinear least square method” in MATLAB Simulink. The resulting …
Published in Journal of Mechatronics and Automation · Vol. 2, Issue 1, 2015 · pp. 41–49 Read article