FTIR
22 articles · search the full text for this term
-
An Investigation on Influence of Gamma Irradiation and Doping on Chemical Structure and Optical Properties of Conducting Polypyrrole
Abstract: In this study the authors report on effect of gamma irradiation and doping (bromine, iodine and sulfate ion) on chemical structure and optical, electronic properties of poly pyrrole. Optical absorption spectrum of PPY shown absorption bands centered around 36.2.5nm (peak 1), 450 nm (peak2) and 525 nm (peak 3) positions Gamma irradiation resulted in broaden of peak A together with a band shift of 45- 525 nm and disappearance peaks …
Published in Journal of Polymer & Composites · Vol. 14, Issue 5, 2026 Read article
-
Bioscouring And Anionization of Waste Cotton Fabric for Efficient Removal of Malachite Green Dye
Abstract: Adsorption is an efficient method for dye removal but the high cost of adsorbents limits its use, emphasizing the need for sustainable, low-cost alternatives. This study explores the usage of modified cotton fabric for the treatment of malachite green (cationic dye) from wastewater. Cellulase extracted from Raphanus sativus and Daucus carota were evaluated for bioscouring potential which was confirmed by scanning electron microscopy. Further, cotton fabric was chemically modified using …
Published in Journal of Water Pollution & Purification Research · Vol. 13, Issue 1, 2026 · pp. 53–68 Read article
-
Gamma Irradiation Effects on Structural and Optical Properties of PVA/Al₂O₃/TiC Polymer Nanocomposites for Optoelectronic Applications
Abstract: PVA/TiC/Al2O3 nanocomposite (PTA) films were successfully prepared via the solution casting method. The impact of high-dose gamma (γ) irradiation (30 kGy) on the structural and optical properties of PVA/TiC/Al2O3 nanocomposites was systematically explored using X-ray diffraction (XRD), Fourier-transform infrared spectroscopy (FTIR), scanning electron microscopy (SEM), and UV–Visible spectroscopy. XRD analysis confirmed the semi-crystalline nature of the nanocomposites, which was found to decrease upon incorporation of Al₂O₃ nanoparticles and exposure to …
Published in Journal of Polymer & Composites · Vol. 14, Issue 2, 2026 · pp. 717–729 Read article
-
Growth, Structural and Optical characteristics of Citric Acid Doped Copper Sulphate Single Crystals Polymer Composites Photonic Applications
Abstract: The organic material Citric Acid doped Copper Sulphate single crystals (CACS) was synthesized and single crystal was grown by slow evaporation method. The incorporation of citric acid, an organic compound, introduces polymer-like functional behavior into the crystal matrix, forming an organic-inorganic hybrid composite with enhanced optical and structural characteristics. Single crystal XRD confirmed the triclinic system with unit cell parameters: a = 5.96 Å, b = 6.11 Å, c = …
Published in Journal of Polymer & Composites · Vol. 14, Issue 1, 2026 · pp. 482–488 Read article
-
Chemical Modifications of Polymer for Improved Anti-Microbial Action
Abstract: Infections caused by pathogenic microorganisms are a significant concern. Polymers, large molecules formed by chemically connecting monomers, have acquired significant interest due to their intrinsic properties. Polymers function as a matrix for the components that contain antibacterial agents. Developing polymers with antibacterial activity is a crucial research area that aims to alleviate the problem of microbe contamination. The antibacterial polymers typically exhibit prolonged effectiveness. Modification of polymers enhances their anti-microbial …
Published in Journal of Polymer & Composites · Vol. 14, Issue 1, 2026 · pp. 1919–1931 Read article
-
Facile Synthesis of SnO2/g-C3N4 nanocomposite for the photocatalytic degradation of Methylene Blue dye under visible light irradiation
Abstract: This work reports the nanoscale samples of pure tin dioxide (SnO₂), graphitic carbon nitride (g-C₃N₄), and their composite (SnO₂/g-C₃N₄) were successfully synthesized using the co-precipitation technique. The synthesized materials were extensively analyzed using multiple characterization techniques such as Powder X-ray Diffraction (PXRD), High-Resolution Scanning Electron Microscopy (HR-SEM), Energy-Dispersive X-ray Spectroscopy (EDAX), Fourier Transform Infrared Spectroscopy (FTIR), UV-Visible Spectroscopy, and High-Resolution Transmission Electron Microscopy (HR-TEM). Results from PXRD and EDAX confirmed …
Published in Journal of Polymer & Composites · Vol. 14, Issue 1, 2026 · pp. 1835–1845 Read article
-
Synthesis, Characterization and Dielectric Properties of Polymer Materials for Microwave Communication Applications
Abstract: The rapid advancement in wireless communication technologies has necessitated the development of advanced materials with tailored dielectric properties. Polymer materials, because of their flexibility, lightweight nature, and processing ease, are currently being used in initiatives to formulate low-dielectric materials specifically tailored for microwave communication applications. In the current investigation, the authors concentrate on the synthesis, characterization, and dielectric properties of five distinct novel polymer materials. The synthesized polymers are characterized …
Published in Journal of Polymer & Composites · Vol. 14, Issue 1, 2026 · pp. 1482–1495 Read article
-
Bio Materials and Nanotechnology: Green Tea (Waste)– Aluminium Nanoparticles (Gt-Al Nps) For Methylene Blue Adsorption
Abstract: This study examines the adsorption of Methylene Blue (MB) dye from aqueous solutions using Aluminium Nanoparticles synthesized with green tea powder as a biological reducing agent. Methylene Blue, an aromatic phenothiazine dye, is widely applied in medical diagnostics and various industrial processes, but its uncontrolled release into water bodies leads to environmental pollution due to its intense colour, stability, and potential toxicity. Therefore, identifying an efficient and eco-friendly adsorbent for …
Published in Journal of Materials & Metallurgical Engineering · Vol. 15, Issue 3, 2025 · pp. 96–107 Read article
-
Adsorptive Removal of Rhodamine-B Using Eco- Synthesized Green Tea–Aluminium Nanoparticles
Abstract: This study examines the use of Green Tea–Aluminium Nanoparticles (GT-Al NPs), a unique and eco-friendly adsorbent, to remove the dangerous Rhodamine-B dye from water. For characterisation, SEM, FTIR, TGA, and EDX were employed. We evaluated the effects of pH, temperature, dosage, contact time, and initial dye concentration on adsorption efficiency. First- and second-order pseudo models were used to characterize adsorption kinetics, and the Langmuir model explained equilibrium, as well as …
Published in Emerging Trends in Chemical Engineering · Vol. 12, Issue 3, 2025 · pp. 61–72 Read article
-
Comparative Analysis of Pond Ash as a Partial Replacement of Sand as Subbase Material for Concrete Paver Block Hardstand sustaining storage of Bulk Cargo
Abstract: This work presents an industrial waste-derived subbase material that can take the place of conventional granular material for subbase in hardstand foundation construction. This industrial waste hugely deposited in the ash lagoons namely Pond Ash (PA) which is globally generated at an amount of 780 Metric Tons from thermal power plants annually ,as foundation material for hardstand construction, will not only help the cause of residual waste disposal problems but …
Published in Journal of Geotechnical Engineering · Vol. 12, Issue 3, 2025 · pp. 32–45 Read article
-
Preparation and characterization of High-performance ZnO/PVB Nanocomposite films for UV-shielding and Optoelectronics
Abstract: Zinc oxide nanoparticles can be incorporated into polymer matrices to create materials for various high-performance engineering applications. In this study, zinc oxide nanoparticles were reinforced at different loadings (0.5, 1.0, 0.5, 1.0, 1.5, and 2.0 wt.%) in polyvinyl butyral matrix to synthesize nanocomposite films using the solution casting method. The impact of zinc oxide nanofiller on the morphology and ultraviolet-shielding performance of polyvinyl butyral nanocomposite films was evaluated using various …
Published in Nano Trends – A Journal of Nano Technology & Its Applications · Vol. 27, Issue 3, 2025 · pp. 35–53 Read article
-
Effect of Steam Flash Explosion Conditions on Preparation of Reed Pulp
Abstract: The effects of different steam explosion conditions on preparation of reed pulp by steam flash explosion were analyzed. Because the main factors affecting steam explosion are steam pressure, retention time and liquid-to-reed ratio, so that the effects of these conditions on the steam explosion pretreated reed straw, and constituent of reed pulp were analyzed. Reed straw samples, 2~3cm in length, were loaded into a 5L stainless steel reactor and treated …
Published in Journal of Modern Chemistry & Chemical Technology · Vol. 16, Issue 2, 2025 · pp. 115–128 Read article
-
Synthesis and Characterization of Polymer-Based Benzamide Derivatives with Potential Biomedical Applications
Abstract: The present study explores the synthesis and characterization of polymer-supported benzamide derivatives, focusing on their potential biomedical applications. The use of polymer-supported synthesis offers several advantages, including improved reaction efficiency, ease of purification, and reusability of the support material, making it an environmentally friendly and cost-effective approach. The synthesis involved a stepwise reaction sequence, with polymeric supports facilitating controlled functionalization and ensuring high product purity. These materials have been widely …
Published in Journal of Polymer & Composites · Vol. 13, Issue 5, 2025 Read article
-
Green Synthesis and Evaluation of Electronic and Optical Properties of CdS/CdTe Quantum Dots
Abstract: The CdS/CdTe quantum dots (QDs), with altered concentrations of CdS, were synthesized using straightforward precursors through an environmentally friendly green method. The synthesized quantum dots were characterization by UV–visible absorption spectroscopy, Photoluminescence (PL), and Fourier Transform Infrared Spectroscopy (FTIR) to understand their electronic and structural properties. The average particle size is nearly consistent with the values derived from Brus's formula. The UV–visible spectra show a blueshift compared with pure sample, …
Published in Journal of Polymer & Composites · Vol. 13, Issue 2, 2025 · pp. 185–194 Read article
-
Experimental Investigation and Surface Morphology Study on Areca Fiber Composite Material
Abstract: Composites manufactured from areca fibers had their characteristics assessed in recent research. Shape and size were determined by cutting the stem. It takes six months to dry the fibers once they are taken from the tree stem. Because pectin, cellulose, hemicellulose, and lignin make up the bulk of it. It has great regeneration capacity and is a resource material made of wood fibers. The untreated and chemically treated fibers are …
Published in Journal of Polymer & Composites · Vol. 13, Issue 1, 2025 · pp. 459–468 Read article
-
Effect of Radiation Dose, Dose Rate and Annealing Temperature on Edible Potato Starch by Spectroscopic Methods
Abstract: Potato starch (PS) is a favorite food choice in different forms. During its storage and applications the PS is exposed to different radiations. In the present study the authors attempt to compare radiation effects (gamma and Electron beam of same radiation dose) in PS by Electron spin resonance (ESR) and Fourier transform infrared (FTIR) methods. ESR spectra of gamma irradiated PS appeared to have resolved shapes than the electron beam …
Published in Journal of Polymer & Composites · Vol. 13, Issue 1, 2025 · pp. 198–209 Read article
-
Properties of ZnO Thin Film deposited on Flexible Substrate using RF Sputtering
Abstract: Semiconductor materials demand is increased in recent years, due to new emerging technologies. There is need to find the alternate for silicon in electronics industry, as silicon is brittle in nature and has low efficiency, which makes it unsuitable for transparent and flexible device. Zinc oxide (ZnO) is emerging as popular choice of researchers due to its wide range of properties, abundancy and non-toxicity. This work explores the properties of …
Published in Journal of Polymer & Composites · Vol. 12, Issue 4, 2024 · pp. 50–56 Read article
-
Synthesis and Characterization of VO 2+ doped SrMg 2 (PO 4 ) 2 Nanopowder by Solid State Reaction technique suitable for White LED material
Abstract: VO2+ doped SrMg2(PO4)2 nanopowder was synthesized by using solid state reaction (SSR) technique. Various experimental techniques have been performed on prepared sample. XRD analysis has revealed that prepared nanopowder is in monoclinic phase. The average crystallite size, micro strain and dislocation density evaluated and make an analogy with W-H plot method. SEM micrographs shows that agglomerated stone like structure and EDS spectrum shows elemental compositions of synthesized sample. FTIR spectrum …
Published in Journal of Polymer & Composites · Vol. 12, Issue 4, 2024 · pp. 95–110 Read article
-
Influence of Agitation and Static Cultivation on Physicochemical Characteristics of Bacterial Cellulose Produced by Gluconacetobacter liquefaciens MTCC 3135
Abstract: Bacterial cellulose (BC) a with applications spanning biomedical, food, paper, electronics, and diverse industrial processes. Its unique properties include high purity, biocompatibility, and flexibility. BC is a versatile natural biopolymeric material, secreted by certain acetic acid bacteria. BC has numerous benefits over plant cellulose due to distinctive features, e.g., higher polymerization degree and purity, superior crystalline structure, water retention, biocompatibility, and biodegradability, which make BC a valuable material in creating …
Published in Research and Reviews : A Journal of Biotechnology · Vol. 14, Issue 2, 2024 · pp. 1–11 Read article
-
Characterization of Cellulose Producing Bacterial Isolates from Rotten Fruits
Abstract: Cellulose, the most abundant natural polymer, is predominantly sourced from plant wood but can also be synthesized by certain bacteria in the form of bio-cellulose. The potential applications of bio-cellulose are extensive, particularly in the biomedical field for tissue engineering, drug delivery, and more. The distinct properties and purity of bacterial cellulose, in contrast to plant-derived cellulose, underscore its importance and drive further research in the area. This study focuses …
Published in Research and Reviews : A Journal of Biotechnology · Vol. 14, Issue 1, 2024 · pp. 38–45 Read article