Search
24 articles for “Tap water”
-
Is Bottled Water Better than Tap Water?
Abstract: Objective: There has been a persistent rise in bottled water consumption over the last two decades. Little is known about the health benefits of bottled water. The purpose of this study was to improve understanding of the public's health believes concerning bottled mineral water, and to know whether these believes influence water consumption habits. Method: Extensive review of literature was done to compare bottled water and tap water and also …
Published in Research and Reviews: A Journal of Toxicology · Vol. 10, Issue 1, 2020 · pp. 30–33 Read article
-
Corrosion inhibitors of steel applicable by green but toxics
Abstract: Inhibitors in detergent and alkali based chemicals are used in various media for steels. Toxicity has induced pharmaceutical compounds as better inhibitors to restrict pollutant gases emissions after reaction with alkaline inhibitors. Green in origin inhibitors are toxin free to use with detergents for inhibition of both pollutant gases and corrosion of processing machineries made of metals. Eco-friendly inhibitors have appeared for steel corrosion being embedded in concrete i.e. alkaline …
Published in Journal of Thin Films, Coating Science Technology & Application · Vol. 6, Issue 2, 2019 · pp. 38–47 Read article
-
Water Comparative Study of Water Quality
Abstract: Water quality plays a vital role in safeguarding human health, maintaining environmental balance, and supporting socio-economic progress. For drinking purposes, water must satisfy established physical and chemical criteria to minimize health hazards and ensure the efficient functioning of biological processes. This research focuses on a comparative assessment of drinking water quality by analyzing key parameters such as pH, Total Dissolved Solids (TDS), hardness, and fluoride levels in both tap water …
Published in Journal of Water Pollution & Purification Research · Vol. 13, Issue 1, 2026 · pp. 85–98 Read article
-
Comprehensive Thermal and Environmental Investigation of An Enhanced Evacuated Tube Solar Water Heater with Wavy Tape and Latent Heat Storage
Abstract: Evacuated tube solar collectors (ETSCs) are widely used for thermal energy applications; however, enhancing their thermal and exergetic efficiency remains a challenge. This study investigates performance enhancements through structural and material alterations. Four ETSC cases were tested experimentally, case-1: a standard ETSC, case-2: Wavy tape (WT) inserted ETSC, case-3: Phase change material (PCM) integrated ETSC, and case-4: Dual-Enhanced ETSC (PCM + WT). A binary eutectic PCM was utilized for latent …
Published in Journal of Refrigeration, Air conditioning, Heating and ventilation · Vol. 12, Issue 2, 2025 · pp. 1–16 Read article
-
Prevalence of Dental Fluorosis in Area of Yemen with Above Optimal Level of Fluoride in Drinking Water: An Exploratory Survey
Abstract: Dental Fluorosis is a developmental defect in enamel formation. It is caused by excessive fluoride intake while teeth are developing; during this period (before teeth erupt) dental tissue is very sensitive to fluoride, typically during a child’s first eight years. The aim of this study is to provide the community with sufficient knowledge about the problem and suggest solutions for prevention from it in future. This study was conducted from …
Published in Research and Reviews: A Journal of Dentistry · Vol. 6, Issue 2, 2015 · pp. 15–25 Read article
-
Design and Implementation of a Smart Automatic Water Dispensing System
Abstract: Water is a precious resource, and its wastage is a growing problem. This project focuses on creating an automatic water tap to save water in homes and public places. The system uses an ultrasonic sensor to detect hand movements and a solenoid valve to control the flow of water. A microcontroller manages the entire process, ensuring water flows only when needed. During testing, the system reduced water wastage significantly, making …
Published in Journal of Microcontroller Engineering and Applications · Vol. 12, Issue 1, 2025 · pp. 22–30 Read article
-
Antibiotic Resistance Profiles of Salmonella Isolated from Al-Gharraf River and Iraqi Sewage
Abstract: Salmonella is a Gram-negative bacterium belonging to the Enterobacteriaceae family. It has a rod-shaped (bacillus) structure. Salmonella is a prominent contributor to gastrointestinal sickness worldwide. In addition, it is the causative agent of more systemic severe disorders such as typhoid and paratyphoid fevers. Salmonella is primarily recognized as pathogens transmitted by water and food to people and animals. Salmonella is often found in water-related epidemics, even though it is routinely …
Published in Recent Trends in Infectious Diseases · Vol. 2, Issue 1, 2025 · pp. 1–10 Read article
-
Physiochemical and Microbiological Analysis of Drinking Water from Public Places of Bhimdatta Municipality
Abstract: People on globe are under tremendous threat due to undesired changes in the physical, chemical and biological characteristics of air, water and soil. Due to increased human population, industrialization, use of fertilizers and man-made activity water is highly polluted with different harmful contaminants. Diseases caused by contaminated drinking water and poor hygiene practice are the leading cause of death among human population worldwide. In order to understand the quality of …
Published in Research and Reviews: A Journal of Microbiology and Virology · Vol. 11, Issue 1, 2021 · pp. 18–24 Read article
-
An Experimental Study on Effect of Seawater on Strength of M30 Grade Concrete
Abstract: The concrete structures constructed near the coastal areas may deteriorate due to the action of sea salts present in seawater on hardened concrete surface with passage of time. The strength decreases due to the formation of complex ions when chloride and sulphate ions, react with cement hydration products. In this study, experiments were carried out to get the effect of seawater on the strength of M30 grade concrete in laboratory …
Published in Journal of Structural Engineering and Management · Vol. 3, Issue 3, 2016 · pp. 55–59 Read article
-
Properties of Biostimulant of Ponderosa Lemon for Crude Oil Remediation in Soil Environment
Abstract: The effect of petroleum hydrocarbon on soil environment contributes to low performance of microbes and plant yield. This study investigates the potential of grape leaf (Ponderosa lemon) on hydrocarbon constituents of crude oil contaminated soil. Freshly harvested grape leaf was washed thoroughly with tape water thereafter rinse with distilled water, some portions kept for room-dried and another for sundried to vary the composition. Fixed masses of loamy soil samples of …
Published in Emerging Trends in Chemical Engineering · Vol. 12, Issue 2, 2025 · pp. 35–42 Read article
-
influence of effluent on soil properties
Abstract: Today India is rapid developing country. Industries are playing a major role in country development. According to environmental concern, the waste products must be treated. But the treatment process is little costly. So to reduce the cost of the investment industries are releasing a lot of refuse which with less treating, which affects the environmental as well as the properties of the soil. The physiochemical parameters such as PH, electrical …
Published in Journal of Geotechnical Engineering · Vol. 5, Issue 2, 2018 · pp. 28–34 Read article
-
Productivity of Hydraulically Fractured Calcite Rich Shale Reservoirs Enhanced by Acid
Abstract: The current low oil prices have highlighted the need for enhancement to current production from shale formations. Prolonging the production life and increasing productivity of the fracture network in the shale plays can be a way to improve the economics. Many shale wells, drilled and completed based on current completion strategies, show sharp decline after initial flash production. One of the reasons behind this can be attributed to closure of …
Published in Journal of Petroleum Engineering & Technology · Vol. 6, Issue 1, 2016 · pp. 54–68 Read article
-
Performance Analysis of Abrasive Water Jet Machining Process for AISI 304 Stainless Steel
Abstract: Abrasive waterjet machining (AWJM) is a non-conventional machining process capable to machine wide range of difficult-to-cut materials such as ceramics, alloys, composite materials, etc. This paper investigates the effect of various process parameters on kerf taper, surface roughness and power consumption which are important performance measures in abrasive waterjet machining. The variable process parameters considered here include water pressure, traverse speed, stand-off distance and abrasive flow rate. Experiments were conducted …
Published in Journal of Experimental & Applied Mechanics · Vol. 8, Issue 2, 2017 · pp. 53–55 Read article
-
Fresnel Lens with Advanced Fabricated Setup for Day Long Production of Hot Water
Abstract: AbstractThis work has been aimed to tap the solar energy source from Fresnel lens and utilize it to produce hot water or steam. The fabricated setup consists of a large spot Fresnel lens which concentrates the sun's rays into a 1 cm2 square spot onto a copper tube with temperature reaching up to 200°C. This concentrated heat is focussed on copper tube absorber to heat the water, the hot water …
Published in Journal of Alternate Energy Sources & Technologies · Vol. 9, Issue 1, 2018 · pp. 15–19 Read article
-
Isolation and Characterization of Dioscorea Dumentorum and ICACINIA Trichantha Starch for Possible Industrial Utilization
Abstract: The study was focused on finding alternative use for underutilized icacinia trichantha (gbegbe) and dioscorea dumentorum (esuru-igbo) for possible industrial utilization. Starches were isolated through aqueous method. The parameters determined are pH, ash and moisture contents, amylose content, gelatinization temperature, water absorption capacities, bulk density, tapped density and true density. The results showed that percentage yield was 70% for dioscorea dumentorum and 64.6% for icacinia trichantha. The physicochemical properties of …
Published in Emerging Trends in Chemical Engineering · Vol. 8, Issue 3, 2021 · pp. 1–7 Read article
-
BisGMA/Thermoplastic Polymer Blends: A Study of Mechanical and Corrosive Properties
Abstract: AbstractThe objective of this work is to synthesize various blends of Bisphenol-A-glycidyldimethacrylate (BisGMA) resin with different proportions of thermoplastic polymers like poly-N-vinylpyrrolidone (PVP) and poly-ethyleneoxazoline (PEOZ) and to study their mechanical and corrosive properties. The experimental results showed that BisGMA/PVP and BisGMA/PEOZ blends displayed an improvement in the mechanical properties over unmodified BisGMA resin and the 50:50 blend system is the optimum blend composition in both BisGMA/PVP and BisGMA/PEOZ blends. …
Published in Journal of Polymer & Composites · Vol. 1, Issue 2, 2013 · pp. 1–14 Read article
-
Rejuvenation and Beautification of River and Nala
Abstract: Nowadays almost all water bodies in India are getting more and more polluted and facing with three major problems which are likely to be Untreated Sewage, Solid waste and abetting encroachment or slums areas along the bank of River, nala or any water body. Due to population development, outdated storm water drainage systems, climate change, and poor management of utility infrastructures, significant damage has recently been done to urban areas, …
Published in Journal of Water Resource Engineering and Management · Vol. 9, Issue 2, 2022 · pp. 1–12 Read article
-
Design and Estimation of Concrete Gravity Dam using STAAD.Pro and MS Excel
Abstract: Aim of current project is to propose a gravity dam across river Tapi, Amravati district in Maharashtra. Many Talukas in nearby areas are facing severe water shortage for major part of a year as there are no other perennial water resource. Agriculture is solely dependent on monsoon. Ground water table is very low. Scope of project includes site selection, collection of rainfall data, planning, design and estimation analysis of the …
Published in Journal of Construction Engineering, Technology & Management · Vol. 12, Issue 2, 2022 · pp. 20–29 Read article
-
Fabrication and Characterization of Jute Fiber Reinforced PP-Clay-based Nanocomposites
Abstract: AbstractNanocomposite is a new concept in the field of plastic-based composites. Jute fabric (hessian cloth)-reinforced polypropylene (PP) composites with different nanoclays were prepared by compression molding. Jute fiber content in the composites was approximately 50%. Mechanical properties of PP-clay blend and PP-clay/jute fiber composites were characterized. It was found that 5% clay containing PP-clay/jute composites showed the best results. Tensile strength (TS), elongation at break (EB) and tensile modulus (TM) …
Published in Journal of Polymer & Composites · Vol. 2, Issue 1, 2023 · pp. 19–29 Read article
-
The Tapper Approach: An Integrated Framework for Land Degradation, Restoration, and Climate-Conflict Dynamics
Abstract: Land systems across the globe are increasingly exposed to multiple and interacting pressures, including land degradation, climate change, biodiversity loss, unsustainable land-use practices, rapid population growth, and socio-economic conflicts. These challenges not only reduce ecosystem productivity and resilience but also threaten food security, water availability, rural livelihoods, and long-term environmental sustainability. Despite the growing recognition of these interconnected issues, most existing conceptual and analytical frameworks continue to address them in …
Published in Research & Reviews : Journal of Ecology · Vol. 15, Issue 2, 2026 · pp. 24–30 Read article