Search
55 articles for “Soil Sampling”
-
Prevalence and Risk Factors of Neglected Tropical Diseases Among Women and Children in Rural Liberia: A Regional Perspective
Abstract: Neglected Tropical Diseases (NTDs) remain a critical public health challenge in Liberia, disproportionately affecting women and children in rural regions due to systemic inequities in water, sanitation, and healthcare access. This cross-sectional study assessed the prevalence and risk factors of NTDs among 1,000 participants (600 children above 15 years and 400 women aged 15–49) in rural Liberia using stratified and cluster sampling. Laboratory diagnostics, including Kato-Katz stool analysis, urine filtration, …
Published in Recent Trends in Infectious Diseases · Vol. 2, Issue 2, 2025 · pp. 1–7 Read article
-
Comparison of Percentage Removal of Petroleum Hydrocarbon on the Effect of Biostimulant in Polluted Soil Environment Using Chromolaena odorata
Abstract: The investigation on the comparison of percentage reduction on polluted soil environment using chromolaena odorata as a bio-stimulant upon the effect of contact time revealed increase in percentage removal of total petroleum hydrocarbon (TPH). The rate of total petroleum hydrocarbon (TPH) removal was discovered to have been influenced y the mas of bio-stimulant dosage immersed or introduced into each of the bioreactor. However, as the mass of the bio-stimulant dosage …
Published in International Journal of Advance in Molecular Engineering · Vol. 2, Issue 2, 2024 · pp. 27–32 Read article
-
Development and Performance Evaluation of GO–ZnO/PU Hybrid Nanocomposite Coatings for Improved Optical Transmission, Cooling, and Self-Cleaning in PV Systems
Abstract: The performance of solar photovoltaic (PV) modules with time is affected by thermal heating, dust buildup, and exposure to ultraviolet (UV) light; as a result, the power loss increases rapidly during the use condition. In this study, a polyurethane (PU) nanocomposite, fabricated with graphene oxide and zinc oxide (GO–ZnO), is invented and examined. Improvements in heat management, light transmission, and dirt resistance are planned for PV glass surfaces. The nanocomposite …
Published in Journal of Polymer & Composites · Vol. 14, Issue 2, 2026 · pp. 243–249 Read article
-
E-Waste Toxicity and Its Environmental Impact, Challenges, and Solutions for Sustainable Waste Management in India
Abstract: Introduction: E-waste describes any electronic component that is obsolete or no longer functional. The ever-increasing public concern of e-waste in India stems predominantly from the aggressive expansion of the electronics industry along with insufficient recycling and disposal practices. Lead, mercury, and cadmium in e-waste pose serious risks to human health and the environment by polluting air, soil, and water. Informal recycling methods further exacerbate these hazards through unsafe practices. This …
Published in Research and Reviews: A Journal of Toxicology · Vol. 15, Issue 2, 2025 · pp. 1–11 Read article
-
Regional Variation in Amino Acid Composition, Antioxidant and Antimicrobial Activity of Tasar Sericin from North and South Bihar
Abstract: This study investigates geographical differences in biochemical and functional characteristics of sericin obtained from Antheraea mylitta cocoons sourced from two regions of Bihar, India: Bhagalpur (North) and Banka (South). Sericin was isolated via an alkali-assisted autoclaving process. Amino acid profiles were determined using HPLC. Free radical scavenging capacity was measured through DPPH, ABTS, and hydrogen peroxide assays. Antibacterial and antifungal effects were tested against Staphylococcus aureus, Escherichia coli, and Candida …
Published in Research and Reviews : A Journal of Life Sciences · Vol. 16, Issue 2, 2026 Read article
-
Qualitative and Quantitative Assessment of Water Resources at Moradabad District (UP), India
Abstract: Moradabad district houses several medium and small-scale industrial units: such as alloy manufacturing, chrome plating, electroplating, and metal extraction from e-waste. The city is known for its export of brass handicrafts to various countries across the world including North America and Europe and is popularly known as Peetal Nagri (Brass City). Heavy metals like lead, copper, arsenic and iron used in alloy manufacturing and nickel and chromium used in plating …
Published in Journal of Water Pollution & Purification Research · Vol. 11, Issue 2, 2024 · pp. 1–9 Read article
-
Tackling Water Hardness: Understanding the Issue for Sustainable Development
Abstract: Hard water poses a serious threat to human health and industrial operations. The pervasiveness of water hardness, characterized by elevated concentrations of calcium and magnesium ions, originates from seepage and runoff from soils, as well as polyvalent metallic ions from sedimentary rocks. These minerals, while essential in moderate amounts, can become problematic when consumed in excess. Epidemiological studies have established correlations between excessive consumption of calcium and magnesium and increased …
Published in Journal of Water Pollution & Purification Research · Vol. 12, Issue 2, 2025 · pp. 73–79 Read article
-
Elemental Mobility and Provenance in Sediments: A Geochemical Study of Deccan Basalts, Bay of Bengal, and Northern China
Abstract: Twenty-eight sediment samples from seventeen rivers, including the Krishna headwaters and the west-flowing Western Ghat rivers, draining the Deccan Trap basalts, were analyzed for major elements (Na, Ca, Mg, K, Al, Ti, Fe) and trace elements (Sr, Ba, Mn, P, V, Cr, Ni, Cu, and Zn). The mobility of these elements, especially Na, Ca, Mg, and Sr, was assessed by comparing their abundances in sediments and dissolved phases. Approximately 60% …
Published in International Journal of Minerals · Vol. 1, Issue 2, 2024 · pp. 19–27 Read article
-
Geotechnical Influence Factors in Empirical Design of Highway Pavement: The A123 Ilorin – Lokoja Highway, Nigeria Case Studies
Abstract: Site investigation and application of geological and geotechnical influence factors on the highway were investigated. Method involved field sampling, geotechnical laboratory and x-ray diffraction analysis and use of SRTM extracted slope and drainage parameters; and their integration in a GIS based multi-criteria decision analysis to derive a subgrade suitability map as a design tool. The suitability criteria classified the highway into four (4) design sections. Section one for very low …
Published in Journal of Geotechnical Engineering · Vol. 11, Issue 3, 2024 · pp. 53–70 Read article
-
Physicochemical Parameters for Water-Environment Quality Testing: A Review
Abstract: The increasing threat posed by contaminants in air, water, and soil is a pressing issue globally, exacerbated by population growth, industrialization, and agricultural practices. These factors contribute to significant water pollution, introducing harmful substances that compromise human health. Natural processes, such as weathering and soil leaching, alongside mining activities, further degrade water quality. Regular monitoring of drinking water is essential, as contaminated sources can lead to a variety of waterborne …
Published in International Journal of Pollution: Prevention & Control · Vol. 3, Issue 1, 2025 · pp. 08–12 Read article
-
Evaluation and Study of The chemical Pollution Ratio of Dams Water in Najaf Governorate and The surrounding Environments
Abstract: The importance of water and the urgent need for a clean environment free from pollutants has drawn our attention and focused in this study on estimating and evaluating ionic pollutants of elements (iron, chromium, lead, manganese) in the water of dams in Najaf Governorate and the surrounding areas. The study included four dams, namely ()Al-Mushkhab Dam, Al-Hindiya Dam, Shatt Al-Kufa, and Umm Abbasiyat Dam)( to determine the percentage of pollution …
Published in Emerging Trends in Chemical Engineering · Vol. 12, Issue 3, 2025 Read article
-
Corn Husk Fiber–Reinforced PLA Biocomposites: Mechanical, Thermal, and Biodegradation Performance
Abstract: The increasing environmental burden caused by conventional petroleum-based plastics has driven significant interest in the development of sustainable polymer composites reinforced with renewable natural fibers. In the present work, corn husk fiber (CHF), an agricultural waste by-product, was utilized as a reinforcing phase in a polylactic acid (PLA) matrix to fabricate eco-friendly biocomposites. Composite samples with varying fiber loadings (0–40 wt.%) were produced through twin-screw melt blending followed by compression …
Published in Journal of Polymer & Composites · Vol. 14, Issue 2, 2026 · pp. 312–327 Read article
-
Persistent Atmospheric and Ecosystem Impacts of Enteric Methane Emissions from Intensive Livestock Production Systems
Abstract: Enteric methane emissions from intensive livestock production systems exert a significant long-lasting influence on atmospheric stability and ecosystem integrity. Recent observations confirm that global methane emissions continued to rise through the early 2020s, with total emissions exceeding 620 teragrams per year by 2024, driven by expanding ruminant production and associated feed systems. Anthropogenic sources accounted for more than 330 teragrams per year, reflecting sustained growth in agricultural and fossil fuel …
Published in International Journal of Atmosphere · Vol. 2, Issue 2, 2025 · pp. 18–38 Read article
-
Labeling transparency and heavy metal contamination in commercial protein powders: A case study
Abstract: With the recent surge in market demand, health supplements particularly protein powders, have become increasingly vulnerable to quality deterioration, adulteration, and unethical marketing practices. Non-compliance with labeling regulations is on a rise. Moreover, research indicates that heavy metals absorbed from contaminated soil often accumulate in the protein fractions of crops, thereby elevating the risk of heavy metal contamination in protein powders. These issues highlight the urgent need to systematically assess …
Published in International Journal of Nutritions · Vol. 3, Issue 1, 2026 Read article
-
Physicochemical Analysis of Groundwater Quality In Owerri Municipal, Imo State, Nigeria Using MATLAB and ANN Models.
Abstract: The physicochemical analysis of groundwater quality in Owerri Municipal council, Imo state, Nigeria was carried out. Fifteen water samples were randomly selected from the five villages that make up Owerri municipal council were anlayzed for physicochemical parameters using standard methods. The results from the study area showed that the temperature ranged between 26.5-28.0oC; рH ranged between 4.80-5.32. Electrical conductivity ranged between 77-166 µЅ/cm. The total dissolved solids were between 35.4-168.4mg/l; …
Published in Emerging Trends in Chemical Engineering · Vol. 11, Issue 1, 2024 Read article