Search
22 articles for “vibrations measuring”
-
Human Deep Skin Surface Vibration Frequency Detection from CT and DT Signals Using Genetic Algorithms
Abstract: To diagnose respiratory problems early on, a contactless, non-invasive, real-time assessment of human vibration is a crucial prerequisite. Optoelectronic plethysmography (OEP) and the forced oscillation technique (FOT), are two widely utilized methodologies, depending on variations in each patient’s local chest impedance. Calibration of the devices before each measurement is hence the primary problem of these approaches. This report presents a simulation-based analysis to assess the effectiveness of the CT and …
Published in International Journal of Algorithms Design and Analysis Review · Vol. 2, Issue 1, 2024 · pp. 9–16 Read article
-
Parameter Identification of Vibrating MIMO Mass-Spring-Damper Mechanical Systems with Coulomb Friction
Abstract: This study presents a time-domain method for identifying parameters in multi-degree-of-freedom (DOF) linear mass-spring-damper systems that include Coulomb friction, where the friction coefficient varies within a limited range, using measurements of position and control force. For mass identification in single-degree-of-freedom (DOF) vibrating mechanical systems with stiffness and no damping but Coulomb friction, the friction term is eliminated by first derivative processing. In addition, the identification of the coefficient of friction …
Published in International Journal of Mechanical Dynamics and Systems Analysis · Vol. 3, Issue 1, 2025 · pp. 20–34 Read article
-
Aluminium-Doped Zinc Ferrite Nanoparticles Synthesized by Combustion Method for Polymer Composite Applications
Abstract: ZnFe₂₋xAlₓO₄ (x = 0 and 0.5) nanoparticles were synthesized via a combustion method owing to its simplicity, cost efficiency, and ability to produce highly crystalline nanomaterials. Powder X-ray diffraction (XRD) analysis confirmed the formation of a single-phase cubic spinel structure without detectable secondary phases, indicating high phase purity. The average crystallite size was estimated to be in the range of 14–20 nm, confirming the nanocrystalline nature of the samples. Field-emission …
Published in Journal of Polymer & Composites · Vol. 13, Issue 6, 2025 · pp. 272–282 Read article
-
AI-Driven Predictive Maintenance Framework for Intelligent Vehicle Health Monitoring
Abstract: The accelerated development of smart and connected car systems made the necessity to find the accurate and real-time predictive maintenance solutions which would minimize the number of unexpected failures as well as increase the cars on-road safety. The current paper proposes an artificial intelligence-based hybrid predictive maintenance system that combines Long Short-Memory (LSTM) networks and the XGBoost predictor to provide a potent vehicle fault diagnosis, Remaining Useful Life (RUL) prediction, …
Published in Trends in Machine design · Vol. 13, Issue 1, 2026 · pp. 1–17 Read article
-
INDUCTION MOTOR FAULT DETECTION USING IoT
Abstract: The induction motor failure detection system proposed in this research is based on the Internet of Things and uses an ESP32, vibration, current, temperature, IR, and Blynk app. An Internet of Things (IoT)-based fault detection system uses sensors to monitor the motor's condition and transmits the information to a cloud-based platform. The cloud-based software may then analyze the data to identify issues and alert maintenance personnel.An overview of an Internet …
Published in Recent Trends in Sensor Research & Technology · Vol. 11, Issue 1, 2024 Read article
-
Occupational Exposure to Vibration—Hazards, Evaluation and Control
Abstract: Mechanical vibration is known to cause occupational health hazards. Exposure to vibration has potential to cause musculoskeletal disorders. Chronic exposure to hand-transmitted vibration causes occupational disease like vibration induced white finger (VWF). This article describes the harmful health effects caused due to exposure to hand-transmitted vibration (HTV) and whole-body vibration (WBV) and the control measures to minimize the exposure. Specifically, focus is kept on the evaluation of vibration exposure to …
Published in Journal of Industrial Safety Engineering · Vol. 8, Issue 2, 2021 · pp. 29–35 Read article
-
Optical Along with Magnetic Properties of Doped Nano-Structured Mos2 Nano-Films by Spin Coating
Abstract: The supernatant containing 2D nano-flakes of Molybdenum di-sulphide (MoS2) are synthesized and collected using wet chemical synthesis process. The dispersed MoS2 nano-flakes solution is having strong absorbance values at 627 nm and 690 nm conforming to an energy band gap BG of 1.79 eV and 1.98 eV. Thereafter, MoS2 thin films with and without magnetic doping (cobalt) are deposited on n type silicon by spin coating technique. These samples are …
Published in Journal of Polymer & Composites · Vol. 13, Issue 1, 2025 · pp. 297–302 Read article
-
A Review on Two-Wheeled Self-Balancing Robot Using Spartan-3E FPGA for Sensor Fusion and Real-Time Motor Control
Abstract: Two-wheeled self-balancing robots (TWSBR) are a popular application of embedded control and robotics because they operate on the inverted pendulum concept, which is naturally unstable. The main objective of such robots is to continuously maintain balance by estimating the tilt angle and applying corrective motor action in real time. In most practical systems, low-cost inertial sensors such as accelerometers and gyroscopes are used for tilt measurement. However, accelerometer readings are …
Published in Journal of VLSI Design Tools and Technology · Vol. 16, Issue 1, 2026 · pp. 17–27 Read article
-
Effect of Bi2O3 Content and Sintering Temperature on the Frequency-Dependent Magnetic Properties of Nanosized Barium Hexaferrite
Abstract: The magnetic properties of commercially available nanosized barium hexaferrite (BaFe12O19) are studied. The particles were characterized using X-ray diffraction (XRD), vibrating sample magnetometer (VSM), and high-frequency magnetic measurements. The frequency-dependent magnetic properties viz. complex permeability and loss tangent were analyzed within the 10 MHz to 1 GHz range. Variations in complex magnetic permeability and loss tangent were discussed under varying sintering parameters such as temperature and sintering aid content. The …
Published in Journal of Polymer & Composites · Vol. 13, Issue 5, 2025 · pp. 107–113 Read article
-
Orthostride: An Internet of Medical Things-Enabled Smart Rehabilitation Footwear System for Real-Time Monitor
Abstract: The orthopedic rehabilitation goal of controlled weight bearing, a stable gait progression, and early recognition of hazardous situations for safe mobility is traditionally met through time, scheduled in-clinic observation and clinician induction, and patient report. In this work, Orthostride, a smart rehabilitation footwear prototype intended to augment postoperative and injury-related lower extremity restoration through continuous sensing, embedded decision logic, local feedback, and remote telemetry, is proposed. This system incorporates force …
Published in International Journal of Electronics Automation · Vol. 4, Issue 2, 2026 Read article
-
Preparation of Transparent and Thermal Resistant Zirconia Reinforced Epoxy Based Polymer Matrix Composite Coatings
Abstract: This study investigates the thermal stability, structural characteristics, optical transparency, and surface wettability of epoxy-based composite coatings reinforced with 2 wt.% zirconia (ZrO₂) nanoparticles. The composite coatings were synthesized using a dip-coating technique on carbon fiber substrates and subsequently subjected to thermal treatments at 300 °C, 400 °C, and 500 °C. Structural analysis using X-ray diffraction (XRD) confirmed the amorphous nature of the epoxy matrix with no significant crystallization or …
Published in Journal of Polymer & Composites · Vol. 13, Issue 3, 2025 · pp. 171–177 Read article
-
Study of Rehydration and Dehydration behavior of Scolecite by insitu Raman spectroscopy
Abstract: The study of structural changes of stretching and bending modes around 3000-4000cm-1 and 700-1800cm-1 in the temperature range of 299 to 503 K during the dehydration of naturally occurring scolecite was investigated using in-situ Raman spectroscopy. A Raman spectrum from 3000-4000cm-1 was measured for a fibrous zeolite called scolecite to regulate the behavior of water molecules in the passages. The extending vibrations of H2O molecules of scolecite are located between …
Published in Journal of Polymer & Composites · Vol. 12, Issue 6, 2024 · pp. 152–159 Read article
-
Synthesis of Thermal Resistant and Transparent Al2O3 Reinforced Epoxy-Based Composite Coatings
Abstract: This study explores the influence of thermal treatment on the structural, optical, and surface wettability characteristics of epoxy-based composite coatings reinforced with 3 wt.% aluminum oxide (Al₂O₃) nanoparticles. The coatings were synthesized via a dip-coating method on carbon fiber substrates and subjected to controlled thermal treatments at 300 °C, 400 °C, and 500 °C to assess their thermal resilience. X-ray diffraction (XRD) analysis confirmed the structural integrity of the composite …
Published in Journal of Polymer & Composites · Vol. 13, Issue 3, 2025 · pp. 178–183 Read article
-
Revolutionizing Geopolymer Composites: Unveiling Intelligent Wall Facades and Precision PZT Sensors for Vibration Analysis
Abstract: Evaluating the mechanical performance and environmental benefits of geopolymer composites is imperative for sustainable alternatives in construction. This study presents an innovative circular PZT-based sensor that effectively captures transient vibrations within concrete structures, demonstrating its validity in comparison to standard surface-mounted accelerometers. The research also elucidates the influence of sensor orientation on capturing various vibrational modes of concrete. Furthermore, the embedded PZT sensors provide valuable insights into the evolving mechanical …
Published in Journal of Polymer & Composites · Vol. 11, Issue 13, 2023 · pp. 59–73 Read article
-
Multifunctional and Photocatalytic Properties of DyFeO₃/Dy₃Fe₅O₁₂ Biphasic Nanoparticles
Abstract: Rare-earth orthoferrites constitute a class of compounds that exhibit remarkable magnetic, optical, and electronic properties across a wide temperature range. In the present study, a dysprosium-based orthoferrite containing dual phases of DyFeO₃ perovskite and Dy₃Fe₅O₁₂ garnet was successfully synthesized via the co-precipitation technique. X-ray diffraction (XRD) analysis was employed to investigate the structural configuration of the synthesized material. The diffraction pattern confirmed the formation of a biphasic composite comprising orthorhombic …
Published in International Journal of Crystalline Materials · Vol. 2, Issue 2, 2025 · pp. 41–54 Read article
-
Representation-Theoretic Symmetry Reduction and Fuzzy-Grey Optimization of Modular Vibration Systems
Abstract: This paper presents a representation-theoretic framework for symmetry-aware vibration control in modular structural systems. Exploiting cyclic symmetry, the mass, damping, and stiffness operators are block-diagonalised into irreducible representations, reducing the full structural dynamics to a collection of lower-dimensional modal subsystems. This decomposition provides both computational efficiency and a rigorous mathematical description of symmetry-preserving dynamic behaviour. To account for imperfections arising in practical implementations, near-symmetry defects in stiffness and damping are …
Published in Emerging Trends in Symmetry · Vol. 2, Issue 1, 2026 · pp. 22–30 Read article
-
Influence of Gd Doping in Structural, Morphological and Optical Properties of Zno Nanostructures Synthesised Via Sol-Gel Processes
Abstract: In this study, nanocrystalline Zn1-xGdx (x=0.0 and 0.03) samples were synthesised via the Sol-gel combustion process. An array of analytical techniques was employed to examine the prepared samples to determine their different physical features. For both pristine and Gd-doped samples, the crystal symmetry is hexagonal with the P63mc space group which is verified via the Rietveld refinement analysis of X-ray diffraction (XRD) data. The atoms' bond length Zn-O and bond …
Published in Journal of Polymer & Composites · Vol. 12, Issue 4, 2024 · pp. 219–225 Read article
-
Electrical Measurements on La-modified Four-Layered Aurivillius Ceramics
Abstract: Bismuth layered structure ferroelectric (BLSF) of Aurivillius family is found to be attractive owing to its scientific and technological point of view. These materials have potential ferroelectric applications owing to the fact of its high Curie temperature, high temperature piezo-devise and ferroelectric random access memory (FRAM), applications. In addition, Bi-modified compounds have shown improved ferroelectric properties. However, the plausible reason for improving ferroelectric properties in Bi-modified is still unclear. The …
Published in Journal of Polymer & Composites · Vol. 13, Issue 1, 2025 · pp. 157–170 Read article
-
Design and Analysis of Thermoelectric Dc boost converter
Abstract: In today’s consumer-oriented market, researchers are increasingly focusing on harvesting energy from ambient and renewable sources to enable sustainable power generation and reduce dependency on conventional energy resources such as batteries and fossil-fuel-based electricity. The rapid growth of portable electronics, wireless sensor networks, and Internet of Things (IoT) devices has created a significant demand for low-power, long-life, and maintenance-free energy solutions. In many practical situations, frequent battery replacement is difficult, …
Published in International Journal of Electro-Mechanics and Material Behaviour · Vol. 4, Issue 1, 2026 · pp. 1–10 Read article
-
Design and Development of a Triboelectric Sensor for a Generic Counting Application
Abstract: In today’s consumer-oriented market, researchers are increasingly focusing on harvesting energy from ambient and renewable sources to enable sustainable power generation and reduce dependency on conventional energy resources such as batteries and fossil-fuel-based electricity. The rapid growth of portable electronics, wireless sensor networks, and Internet of Things (IoT) devices has created a significant demand for low-power, long-life, and maintenance-free energy solutions. In many practical situations, frequent battery replacement is difficult, …
Published in Journal of Experimental & Applied Mechanics · Vol. 17, Issue 1, 2026 · pp. 38–48 Read article