Search
30 articles for “Micro strip antenna”
-
Review Paper of Designing of CPW Fed Micro-strip Patch Antenna for UWB and Bluetooth Application
Abstract: A compact size coplanar waveguide (CPW)-fed micro strip antenna is proposed for radiation of the frequency spectrums 2.36 to 2.49 GHz (Bluetooth) and 3.1 to 10.6 GHz (UWB-Ultra wideband) covers. Both are unlicensed bands but in UWB band there are two licensed bands i.e. WLAN and Wi-MAX present in the frequency range of 5.12 to 5.825 GHz and 3.4 to 3.7 GHz respectively. In this design we have single CPW-fed …
Published in Journal of Microwave Engineering and Technologies · Vol. 3, Issue 1, 2016 · pp. 35–40 Read article
-
A Compact Design of Dual Band Micro Strip Antenna for WLAN/WiMax Applications
Abstract: In this paper compact dual wide band micro strip antenna has been designed with line feed technique. The return loss bandwidth achieved is 12.34% (1.398–1.582) GHz and 21.56% (2.395–2.974) GHz with a maximum return loss –44.89 dB at resonant frequency 2.656 GHz by using Zeland IE3D software. The fabricated line feed patch antenna is tested and measured by using spectrum analyzer.
Published in Journal of Microwave Engineering and Technologies · Vol. 1, Issue 3, 2014 · pp. 1–6 Read article
-
Design and Simulation of E-Shape Micro-strip Patch Antenna at 2.45GHz
Abstract: AbstractThis paper presents comparison of rectangular micro strip patch antenna and E-Shaped micro strip patch antenna operating at 2.45GHz. Two parallel slots are made into the basic rectangular patch design of micro strip antenna which resulted into desired E-shaped patch. The basic design consist of inset feed type and we have used dielectric substrate Fr4 epoxy whereas E-shaped patch consist of coaxial probe and RT Duroid as substrate. Both the …
Published in Journal of Microwave Engineering and Technologies · Vol. 7, Issue 1, 2020 · pp. 17–24 Read article
-
A Review On A Compact Dual Polarized Antenna Array
Abstract: A compact dual-polarized antenna array for low-cost millimeter-wave (mm Wave) applications is proposed in this article. Utilizing a patch antenna with two orthogonal feeds positioned horizontally and vertically, a dual linear polarization antenna can be created. Two ports—a vertical port and a horizontal port—make up the suggested design. The antenna produces horizontal polarization by stimulating the horizontal port. The antenna produces vertical polarization by stimulating vertical port. With the higher …
Published in Journal of Microwave Engineering and Technologies · Vol. 9, Issue 2, 2022 · pp. 46–50 Read article
-
Rectangular Micro Strip Patch Antenna Interconnected with Symmetrical Cut Hexagonal Shaped between Horizontal Lines Meta Material Structure Enhancement Bandwidth at 1.80 GHz
Abstract: This paper proposes a new generation of antenna that applies Metamaterial (MTM) properties at ground plane. The paper analyzes the performance of Microstrip Patch Antenna with and without using the MTM structure. Rectangular Microstrip Patch Antenna (RMPA) interconnected with symmetrical cut hexagonal shaped between horizontal lines MTM structure is proposed for enhancement of bandwidth and reduction of return loss at operating frequency of 1.80 GHz. The proposed antenna is designed …
Published in Journal of Microwave Engineering and Technologies · Vol. 1, Issue 3, 2014 · pp. 15–20 Read article
-
High Gain Antenna Array (2x1 and 4x1) Design for WLAN Application
Abstract: Micro-strip antennas became very popular in 1970s primarily for space borne applications. Today they are used for government and commercial applications. These antennas consist of a metallic patch on a grounded substrate. The metallic patch can take many different configurations. However, the rectangular and circular patches are most popular because of ease of analysis and fabrication, and their attractive radiation characteristics, especially low cross-polarization radiation. In high performance aircraft, spacecraft, …
Published in Journal of VLSI Design Tools and Technology · Vol. 8, Issue 2, 2018 · pp. 1–8 Read article
-
Investigation of Square Monopole Antenna with Slotted Patch
Abstract: A novel antenna with slotted patch for L-Band applications is presented in this paper. The proposed antenna consists of a square patch with rectangular slot. By slotting of the patch the antenna shows enhancement of gain in allocated band. A rectangular slot in the patch and partial ground plane is used in this antenna to enhance return loss and bandwidth. The simulated results have shown that the designed antenna receives …
Published in Journal of Microwave Engineering and Technologies · Vol. 1, Issue 3, 2014 · pp. 21–25 Read article
-
Design and Fabrication of Patch Antenna using DGS for WLAN and WIMAX Applications
Abstract: AbstractIn this paper a small size micro strip patch antenna with dual frequency characteristics is presented. The proposed antenna is designed on an FR-4 epoxy dielectric substrate with the thickness of 1.6 mm and dielectric constant er =4.3. The proposed antenna has used defected ground structure (DGS) stop theory to create dual frequency band characteristics 2.13GHz – 3.25 GHZ for WIMAX and 5.725GHz – 6.3084 Hz for WLAN, respectively. The …
Published in Journal of Microwave Engineering and Technologies · Vol. 7, Issue 1, 2020 · pp. 5–16 Read article
-
U-Shaped Antenna Design for 5G High Frequency Band
Abstract: Designing small antennas for 5G millimeter wave bands is an emerging research subject in the wireless communication age. This research paper describes the design, simulation, and measurement of a micro-strip patch antenna operating at high frequency, 38 GHz. The substrate material used is FR4 proxy due to its easy availability and cost with the dielectric constant 3.8 to 4.6. The analysis and simulation are done on Ansys HFSS Software. The …
Published in Journal of Microwave Engineering and Technologies · Vol. 10, Issue 3, 2023 · pp. 31–40 Read article
-
A Novel High Gain Cavity Backed Micro Strip-Fed Circular Triangular Corner Fractal Antenna for UWB Applications
Abstract: In the current article, a novel micro strip-fed circular triangular corner fractal unidirectional antenna with high gain is proposed for ultra wideband (UWB) applications. This antenna consists of circular patch with triangular slot with three iterations. A prototype of antenna has been designed on FR4 substrate having dielectric constant 4.4 and thickness 1.6 mm. This reference antenna is then placed in a cavity made up of FR4 having thickness same …
Published in Journal of Electronic Design Technology · Vol. 6, Issue 1, 2015 · pp. 19–24 Read article
-
Frozen Waves: Double T-Shape Patch Antenna Sensor for Precise Ice and Snow Measurement
Abstract: To design a Micro strip patch antenna with double T shaped slots at operating frequency 2.4GHz was developed for ice detection and measurement application. Detection was performed by monitoring the resonance frequency and amplitude of the transmission coefficient between the antenna sensor and a broadband receiver. The patch antenna sensor is also capable of distinguishing between ice and water, respectively when compared to the bare sensor. The antenna was also …
Published in Journal of Control & Instrumentation · Vol. 14, Issue 3, 2023 · pp. 15–20 Read article
-
Small Size High Gain Antenna and High Efficiency Rectifier for RF Energy Harvesting in 2.45 GHz ISM Band
Abstract: A streamlined microwave energy harvesting system to harvest energy in 2.45 GHz presented in this paper. An electromagnetically coupled square micro-strip antenna is designed and fabricated for formation in proposed system. Antenna gain of 6.7 db and bandwidth from 2.42to 2.47 GHz is achieved. The maximum gain of proposed antenna is 24 db at frequency 2.1 GHz. Rectifier circuit consists of a resonant circuit and a boosting circuit for enhancing …
Published in Journal of Microwave Engineering and Technologies · Vol. 3, Issue 1, 2016 · pp. 41–46 Read article
-
Rectenna for Low Power Wireless Applications
Abstract: This paper presents a rectenna that is designed and simulated to power the wireless sensor systems at 3.12 GHz. The antenna substrate is designed with glass epoxy. The rectenna circuit has been simulated on the glass epoxy and RF-to-DC conversation is investigated for power level -5dBm. The presented antenna has the impedance bandwidth of 58.34%, i.e. from 2.61GHz to 4.76 GHz with a gain of 2.67dBi.Keywords: Rectenna, RF-to-DC, micro strip …
Published in Trends in Electrical Engineering · Vol. 8, Issue 1, 2018 · pp. 19–23 Read article
-
Performance and Improvement of Antenna Designs in Modern Wireless Communication System
Abstract: AbstractIn this paper, the cell innovation and the remote correspondence innovation is creating and enhancing quickly. The reception apparatus goes about as the scaffold between the client terminal and the base station controller. Being a key segment of the remote correspondence framework, the reception apparatus' fundamental capacity is to communicate and to get electromagnetic waves. It will, to an expansive degree, influence the quality and the speed of the correspondence. …
Published in Journal of Microwave Engineering and Technologies · Vol. 4, Issue 3, 2017 · pp. 5–10 Read article
-
Bandwidth and Return Loss Enhancement in Patch Antenna by Meta Material using at 2.62 GHz
Abstract: In this work, a rectangular micro strip patch antenna (RMPA) loaded with “Symmetric square Shapes Four Segments with circular rings structure” metamaterial structure is designed at a height 3.2 mm from ground plane by using CST-MWS software. The resonance frequency of the designed antenna is 2.62 GHz. The 10 dB impedance bandwidth of proposed antenna is increased up to 78.3 MHz. The return loss of the proposed antenna reduced to …
Published in Journal of Microwave Engineering and Technologies · Vol. 1, Issue 3, 2014 · pp. 33–37 Read article
-
A New Dual Side Cut Corner Circularly Polarized Rectenna 2.45 GHz with DGS
Abstract: This paper introduces a new dual side cut corner circular polarized (CP) high efficiency rectifying antenna (Rectenna) array. The Rectenna consists of a truncated square patch antenna and a rectifying circuit. The Rectenna use a micro-strip patch antenna as a frequency 2.45 GHz and gain of 31.29 dB. The Rectenna circuit has a low pass filter (LPF) the maximum RF to DC conversion efficiency of the Rectenna is 68%.
Published in Journal of Telecommunication, Switching Systems and Networks · Vol. 2, Issue 3, 2015 · pp. 19–23 Read article
-
An Overview of the Design and Optimization of Antennas Employing Machine Learning Algorithms and Methodologies
Abstract: This paper offers a comprehensive exploration of the integration of machine learning (ML) techniques in antenna design and optimization, reflecting the burgeoning interest and potential impact of ML in emerging technologies. The first segment conducts a detailed literature survey, elucidating conventional computational electromagnetic and numerical methods preceding an in-depth discussion on the core facets of ML, encompassing diverse learning categories and frameworks. Additionally, it provides a mathematical exposition on regression …
Published in Journal of Telecommunication, Switching Systems and Networks · Vol. 10, Issue 3, 2023 · pp. 1–12 Read article
-
Simulation And Analysis of Radio Frequency Energy Harvesting System Operating at 2.45 GHz Frequency
Abstract: — This paper proposed study of an RF energy harvesting system at 2.45 GHz using a rectifier and an antenna so called rectenna. Inset-fed micro-strip rectangular patch antenna array is fabricated. The rectifier circuit, employing Schottky diodes (HSMS-2850), converts AC power from the antenna to DC for RF detection. Analysis of the antenna's design and parameters such as directivity, return loss, gain, and VSWR is done using high-frequency simulator software …
Published in Journal of Microwave Engineering and Technologies · Vol. 11, Issue 1, 2024 · pp. 7–15 Read article
-
A Novel Approach for Design and Optimization of Slot Antenna for WLAN Applications
Abstract: The simulation, and analysis of a micro-strip fed slot antenna array intended for operation in the 2.4 GHz ISM (Industrial, Scientific, and Medical) band, which is widely used for wireless technologies such as Wi-Fi and Bluetooth. A slot antenna is a type of antenna where a slot (cut or gap) is made on a metal surface, and it radiates electromagnetic waves. Utilizing ANSOFT HFSS software, the antenna's performance is optimized, …
Published in Journal of Microwave Engineering and Technologies · Vol. 12, Issue 1, 2025 · pp. 1–12 Read article
-
A CPW Fed Inverted E-Shape Microstrip Patch Antenna for Multi Band Applications
Abstract: In this paper a CPW fed multi band monopole antenna with inverted E-shape micro strip patch is presented for radar/satellite applications. Ansys soft HFSS simulator is used to simulate the antenna in this paper. The proposed antenna consists of inverted E shape patch including finite ground CPW feeding. The antenna is fabricated on 1.5 mm FR4 substrate which has dielectric constant of 4.4 and loss tangent of 0.02. The operating …
Published in Journal of Microwave Engineering and Technologies · Vol. 2, Issue 3, 2015 · pp. 26–35 Read article