Search
334 articles for “Power output”
-
Direction of Arrival Estimation in Mobile Communication Systems using MUSIC Algorithm
Abstract: AbstractAdaptive antenna arrays use multiple antenna elements to form directional patterns in order to improve the performance of wireless communication systems. The antenna arrays also have the ability to estimate the Direction-of-Arrival (DoA) of the signals received from the desired transmitters as well as the directions of interference signals. The results of DoA estimation are then used to adjust the weights of the adaptive Multi-Input Multi-Output (MIMO) antenna so that …
Published in Journal of Communication Engineering & Systems · Vol. 3, Issue 2, 2013 · pp. 20–27 Read article
-
Self-Tuning Wireless Power Transfer System Using Reinforcement Learning for Dynamic Electric Vehicle Charging
Abstract: The rapid growth of electric vehicles (EVs) has intensified the demand for efficient, reliable, and user-friendly wireless power transfer (WPT) systems capable of supporting dynamic charging under varying operating conditions. This paper presents a self-tuning wireless power transfer system employing deep reinforcement learning (DRL) to optimize power transfer efficiency in real time. Unlike conventional WPT controllers that rely on fixed compensation parameters or predefined control rules, the proposed framework continuously …
Published in International Journal of Advanced Control and System Engineering · Vol. 4, Issue 2, 2026 Read article
-
High-speed Data Converter Architectures: Latched Comparator Design & Performance Comparison
Abstract: This paper focuses on the design and optimization of latch comparators for high-speed data converter applications. The performance of different comparator architectures is compared in terms of speed, power consumption, and noise performance. The proposed latch comparator architecture uses a preamplifier to boost gain and sensitivity, and a latch to store the output signal. The latch comparator design is optimized for low power consumption and high speed, and is implemented …
Published in Journal of VLSI Design Tools and Technology · Vol. 14, Issue 1, 2024 · pp. 23–32 Read article
-
Revolutionizing EV Battery Charging: Enhancing Power Factor with Modified Bridgeless Landsman Converter
Abstract: The work focuses on the design and implementation of an innovative battery charger for electric vehicles (EVs) with a significant improvement in the power factor at the front end. The existing EV chargers often suffer from poor power factor, leading to increased losses and reduced efficiency. An altered Landsman power factor correction (PFC) converter is used in place of the traditional diode bridge rectifier (DBR) in order to solve this …
Published in Journal of Power Electronics and Power Systems · Vol. 14, Issue 2, 2024 · pp. 12–20 Read article
-
Swing Restored Low Power and Area Efficient 8-bit Arithmetic Logic Unit Using Modified Gate Diffusion Input Technique
Abstract: AbstractThe arithmetic logic unit (ALU) is one of the most fundamental operational units in any processor. The ALU is the heart of any system or any processor and the core component of the central processing unit because mainly all the fundamental operations are performed by the help of ALU only. So, it can be defined as the combinational unit that is used to perform its logical and arithmetic units. The …
Published in Journal of Microcontroller Engineering and Applications · Vol. 5, Issue 2, 2018 · pp. 19–29 Read article
-
Automatic Power Switching Mains for Various Sources
Abstract: This project's major objective is to autonomously choose from four possible power sources—mains, generator, inverter, and solar—to guarantee a load's continuous power delivery. This is crucial due to the rising demand for electricity and the frequent power disruptions affecting industries, hospitals, and households. Establishing an alternative power source is imperative to address this issue. In this project, four switches are utilized to simulate the failure of individual power sources. Pressing …
Published in International Journal of Electrical Machine Analysis and Design · Vol. 1, Issue 2, 2023 · pp. 24–30 Read article
-
Study of Multiple-Input Multiple-Output DC-DC Converter for DC Microgrid Applications
Abstract: DC microgrids have been developed because of the integration of renewable energy sources and the rising demand for sustainable energy solutions. DC microgrids offer numerous advantages such as increased efficiency, reduced transmission losses, and enhanced reliability. However, the varying output characteristics of renewable sources and the dynamic nature of loads within a microgrid necessitate efficient power management systems. In order to overcome these difficulties, MIMO (Multiple-Input Multiple-Output) DC-DC converters have …
Published in Trends in Electrical Engineering · Vol. 13, Issue 3, 2023 · pp. 16–23 Read article
-
Study Effect of Position of Fixed Magnet on Performance of VEH Device Working on Electromagnetic Principal
Abstract: Vibration energy harvesting (VEH) is one of key source of power for remote locations. VEH device gives maximum output at its natural frequency matching with excitation frequency. So, it is suitable for standalone frequency, gives rise to increase band widening efforts. To achieve resonance, stiffness or moving mass is to be changed. Changing of mass during operation is difficult to achieve. Repulsive and attractive force between magnets can be varied …
Published in Journal of Telecommunication, Switching Systems and Networks · Vol. 4, Issue 1, 2017 · pp. 6–11 Read article
-
Boost Converter with Optimized Pi Controller Design for Grid Tied PV Based Electric Vehicle
Abstract: The growing demand of clean energy along with the depletion of fossil fuel usage have paved the way for electric vehicles (EV) to emerge as a significant alternative in automobile sector. Reduction of air pollution and reliance of fossil fuels thereby improving energy security are termed as the primary goals of EV. The adopting of EV facilitates emission free transportation and addresses the environmental crisis caused due to climatic changes …
Published in International Journal of Electrical Power and Machine Systems · Vol. 3, Issue 1, 2025 · pp. 1–16 Read article
-
Strengthening Low Voltage Ride-Through in Wind Energy Systems: A Comparative Study of DVR and STATCOM
Abstract: This study looks at the various methods used to improve the low-voltage ride-through (LVRT) capabilities of wind turbine systems (WT) that are based on double-fed induction generators (DFIG). The Type-III WT machine, which is mostly based on DFIG, is instantly connected to the grid without the digital power interface, making the terminal voltage or reactive electricity output unmanageable. This is because the world utilizes between 20% and 25% of renewable …
Published in Journal of Power Electronics and Power Systems · Vol. 14, Issue 3, 2024 · pp. 47–62 Read article
-
Performance Analysis of Bridgeless Converter Based SMPS used for Welding Application
Abstract: Abstract: This paper deals with performance analysis bridgeless converter based switched mode power supply (SMPS) of improved power quality. Power Factor Correction (PFC) based bridge less SMPS having so many applications in the area of welding power supply with IPC. This topology based on the constant voltage output and output current varied according to load changes. In the proposed topology, it is replaced the front end diode bridge rectifier with …
Published in Journal of Electronic Design Technology · Vol. 10, Issue 1, 2019 · pp. 27–33 Read article
-
System Level Modeling of ISMB Quadrature Transceiver
Abstract: In this paper, a new ISMB quadrature transceiver system-level design architecture is presented along with its referenced mathematical models and these were verified using state-of-the-art system modeling tools. Unlike a K-TEK’s receiver, it does not suffer from the timing and template matching problems, and it circumvents processing at high frequencies, thereby reducing the on-chip circuit complexity and power consumption. Hilbert transform has been used at the output of the demodulator …
Published in Journal of VLSI Design Tools and Technology · Vol. 2, Issue 1-2-3, 2012 · pp. 108–117 Read article
-
Nuclear power—benefit or threat? Nuclear Engineering and Technology Examination
Abstract: As the globe struggles with climate change and energy security, nuclear power is back in the news. This low-carbon, high-output alternative to fossil fuels can stabilise electrical networks, say supporters. Critics say catastrophic accidents, radioactive waste, high costs, and technology spread are risks. When the earth is warming quickly and energy demand is expanding worldwide, finding reliable, low-carbon energy sources is more critical than ever. Nuclear power is a potential …
Published in Journal of Nuclear Engineering & Technology · Vol. 15, Issue 3, 2025 · pp. 24–36 Read article
-
TZSBLC With Optimized PI Controller Design for Grid Tied PV Based Electric Vehicle
Abstract: Around the world, about 18% pre-mature births and 3.7 million losses of lives occur due to air pollution and 29% of it is contributed by the Internal Combustion Engine (ICE) based vehicles, which consumes fossil fuels for its functioning. Moreover, the increased demand for fossil fuels, as well as the growth in concerns regarding the environmentally friendly and zero-emission transportation, lead to the introduction of electric Vehicles (EVs). The increased …
Published in International Journal of Electrical Machine Analysis and Design · Vol. 3, Issue 1, 2025 · pp. 18–35 Read article
-
Optimization of turning process parameters for Titanium grade 5 using Taguchi method
Abstract: In the contemporary world, the standard of the surface end is most significant demand for several turned work piece due to that maker's square measure seeking to stay competitive in the market. Taguchi parameter style is a powerful tool and efficient methodology for optimizing quality and performance output of the producing method. This paper investigates the parameters poignant the surface roughness manufacture in turning method for material Titanium Grade 5. …
Published in Journal of Experimental & Applied Mechanics · Vol. 10, Issue 2, 2019 · pp. 17–22 Read article
-
Different Types of PWM Techniques for Single Phase Inverter: A Review
Abstract: In this paper, different types of PWM techniques and their methodology of single-phase inverter have been introduced. The PWM technique used in single phase inverter is more advantageous than conventional inverter. This paper includes the review of modern power devices such as MOSFETs, IGBTs, etc. The conventional inverter output voltage changes according to the change in load but in single phase PWM inverter gives the steady output of voltage 230 …
Published in Journal of Power Electronics and Power Systems · Vol. 12, Issue 3, 2022 · pp. 19–25 Read article
-
Advancing Grid Integration: Maximum Power Point Tracking-Based Model Predictive Current Control Technique for Photovoltaic Systems
Abstract: Tracking a PV system's maximum power point is necessary as demand for grid-connected solar systems rises, regardless of utility demand. Since the PV system's output is D.C., a converter serving as a middleman between the PV system and the D.C. link capacitor is necessary to track the maximum power at all loads. Since the firing angle of the IGBT in the boost converter is between 0 and 1 at maximum …
Published in International Journal of Electrical Machine Analysis and Design · Vol. 1, Issue 2, 2023 · pp. 31–35 Read article
-
A Review on Energy Efficiency Challenges and Techniques for EE in 5G Network
Abstract: AbstractThis paper includes the survey of Energy Efficiency challenges and need in 5G network and D2D technique to improve energy efficiency without comprising the user experience. Improving the energy efficiency is important part while designing a network. The cellular systems must be energy efficient, especially in mobile communication which has made the battery constraint a major issue. This has motivated optimization of energy for the use of mobile devices. Mobile …
Published in Journal of Microwave Engineering and Technologies · Vol. 7, Issue 2, 2020 · pp. 21–29 Read article
-
Load Sharing control Between Wind Energy & Diesel Generator
Abstract: AbstractThe disturbed expansion in energy request has represented a significant issue for the power frameworks security and dependability, and henceforth has happened to central issue. The weaknesses of ordinary wellspring of energy have cleared way for environmentally friendly power sources. The impact of the breeze turbine in the lattice framework concerning the power quality estimations are-the dynamic power, receptive power, variety of voltage, glint, sounds, and electrical conduct of exchanging …
Published in Recent Trends in Fluid Mechanics · Vol. 8, Issue 2, 2021 · pp. 37–47 Read article
-
To analyze performance of Wind/Battery Hybrid Power System using Different MPPT Techniques
Abstract: Where traditional power generation is not feasible, renewable energy sources have become a popular alternative electrical energy source. The output of photovoltaic and wind electricity has expanded dramatically in recent years. We suggested a hybrid energy system in this study that uses both solar panels and wind turbine parameters to generate electrical power and supply it to a power grid station. Maximum power point tracking is achieved using two control …
Published in Current Trends in Signal Processing · Vol. 11, Issue 3, 2021 · pp. 15–27 Read article