Search
118 articles for “Propagation-based”
-
Controller Performance Assessment (CPA) of Intelligent Control for Non-linear System
Abstract: The objective of this paper is to design and undertake comparative analysis of classical and intelligentcontrollers for nonlinear system. These controllers are compared based on controller performanceassessment in which the different parameters as overshoot, steady-state error, rise time, settling time,response of reference change and output variance are analyzed. To achieve these objectives, the water tankcontrol problem as nonlinear system has been built in Simulink and implementations traditionally classicalcontroller and advance …
Published in Journal of Control & Instrumentation · Vol. 1, Issue 1-2-3, 2011 · pp. 25–33 Read article
-
A Shear Strength Reduction Method for an Open Pit Slope Stability Analysis Based on Finite Element Method
Abstract: Slope stability assessment of open pit mines is critically important, since it forms part of the overall productivity and safety management strategy of the mines. The aim of this work is to investigate the overall stability conditions of three (3) open pits in Gold Fields Limited, Tarkwa Ghana. Field and laboratory investigations were conducted as well as empirical methods. Finite Element Analysis (FEA) in Rocscience was carried out using the …
Published in Journal of Geotechnical Engineering · Vol. 13, Issue 1, 2026 · pp. 1–24 Read article
-
Experimental and Numerical Investigation of Corrosion-Induced Failures in Copper-Tin Alloy (Cu-Sn) and Aluminum-Magnesium Alloy (Al-Mg) Connectors: A Stress–Corrosion Coupling Analysis
Abstract: The utilization of an integrated experimental and finite element modelling (FEM) methodology, this study investigates the degradation and failure mechanisms in polymer composite electrical connectors exposed to aggressive environmental conditions. Epoxy- and polyamide-based composites, reinforced with carbon and glass fibers, were subjected to accelerated salt spray and humidity–temperature cycles to simulate prolonged outdoor exposure. Electrochemical and environmental aging experiments revealed that chloride ions and moisture ingress were responsible for matrix …
Published in Journal of Polymer & Composites · Vol. 14, Issue 2, 2026 · pp. 366–379 Read article
-
Design of High-Speed TIQ Comparator for Flash-Type ADC for (WPMOS/LPMOS) > 1
Abstract: Comparator is the circuit that compares an analog signal with the reference signal and produces the binary output based on comparison. A Comparator is the main block in the ADC design as it directly affects the conversion rate of an ADC. Depending on the type and architecture of the comparator, the comparator can have significant impact on the performance of the target application. The speed and resolution of an ADC …
Published in Journal of VLSI Design Tools and Technology · Vol. 4, Issue 2, 2014 · pp. 47–52 Read article
-
Catalyst-Driven Degradation and Failure Analysis of Intergranular Cracking in 316H Studded Pipes under Refinery Heat Recovery Conditions
Abstract: A failure analysis investigation was carried out on a high-temperature studded pipe used in a convection module for heat recovery in an oil and gas refinery application after leakage was detected during pre-commissioning hydrotesting. The investigated pipe was manufactured from AISI 316H austenitic stainless steel, and carbon steel studs had been joined to its outer surface by high-frequency resistance welding. Two leaks were reported in the pipe under investigation, and …
Published in Journal of Catalyst & Catalysis · Vol. 13, Issue 1, 2026 Read article
-
Li-Fi based Underwater Audio and Data Transmission System
Abstract: Visible Light Communication, or Li-Fi (Light Fidelity), is a wireless optical networking technique used for communication (VLC). Due to its lack of RF communication's drawbacks, such as water absorption and scattering, Li-Fi has the potential to completely transform underwater communication. This project suggests utilizing two Arduinos, a solar panel, a speaker, a display, an amplifier, a laser, a battery, and other components to create a Li-Fi based underwater audio and …
Published in Recent Trends in Fluid Mechanics · Vol. 11, Issue 2, 2024 · pp. 23–29 Read article
-
Estimation of Power System Stabilizer Parameters Using Swarm Intelligence Techniques to Improve Small Signal Stability of Power System
Abstract: Interconnection of the power system utilities and grids presents a formidable challenge in front of design engineers. With the interconnections, power system has emerged as a more complex and nonlinear system. In recent years, small signal stability issues have gained much importance along with the conventional transient stability issues. Transient stability of the power system can be achieved with high gain and fast acting automatic voltage regulators (AVRs). However, AVRs …
Published in Trends in Electrical Engineering · Vol. 6, Issue 2, 2016 · pp. 16–25 Read article
-
Prediction of Human Heart Disease
Abstract: AbstractData mining techniques have been widely used in clinical decision support systems for prediction and diagnosis of various diseases with good accuracy. These techniques have been very effective in designing clinical support systems because of their ability to discover hidden patterns and relationships in medical data. One of the most important applications of such systems is in diagnosis of heart diseases because it is one of the leading causes of …
Published in Journal of Software Engineering Tools & Technology Trends · Vol. 6, Issue 2, 2019 · pp. 27–31 Read article
-
Autonomous 6G Physical Layer Architectures for Space-Air-Ground Integrated Networks
Abstract: The emergence of sixth generation (6G) wireless systems calls for a significant shift away from conventional deterministic communication models. As communication infrastructures evolve into Space- Air-Ground Integrated Networks (SAGIN), traditional physical layer (PHY) techniques struggle to operate effectively under the severe Doppler effects and long propagation delays associated with space environments. This paper examines the role of artificial intelligence embedded directly within the 6G transceiver architecture to enable ultra-reliable and …
Published in Journal of Telecommunication, Switching Systems and Networks · Vol. 13, Issue 2, 2026 · pp. 21–31 Read article
-
Performance Analysis of Schmitt Trigger Circuit for Noise-Free Chips
Abstract: At lower nodes of complementary metal-oxide semiconductor (CMOS) technology, noise within a chip increase due to a drastic increment in interconnects within a given area. To improve the noise immunity of a chip, a Schmitt trigger circuit is used as a buffer instead of a simple CMOS inverter at various intervals along the metal interconnect. The use of a Schmitt trigger circuit not only makes the chip noise immune but …
Published in Journal of VLSI Design Tools and Technology · Vol. 14, Issue 3, 2024 · pp. 11–20 Read article
-
An experimental study on flexural behavior of RC beams of Alccofine based engineered concrete infusing steel fibres
Abstract: The innovations in concrete being engineered to the specific requirements have found a new dimension under sustainability. Alccofine is a sustainable construction material derived from GGBS. The primary objective of the study is to explore the potential of Alccofine particles in varying proportions in combination with 0.5% steel fibers to uplift the flexural strength of the engineered concrete. As concrete is known to be a brittle material once hardened, exhibits …
Published in Journal of Polymer & Composites · Vol. 12, Issue 3, 2024 · pp. 87–97 Read article
-
Debris Flow Kinetics in Planetary Environments: A Systems Perspective
Abstract: Debris flow kinetics in planetary environments represent a critical intersection of geomorphology, fluid mechanics, and planetary science. These gravity-driven flow mixtures of solids, liquids, and gases play a key role in shaping planetary surfaces and recording environmental histories. This study adopts a systems perspective to analyze debris flow behavior across different planetary contexts, emphasizing the interconnected roles of material properties, energy transformations, and environmental forcing. By integrating rheological models with …
Published in International Journal of Universe · Vol. 1, Issue 2, 2025 · pp. 08–17 Read article
-
A Comparative Study of Transfer Learning-Based Deep Learning Models for Breast Cancer Detection
Abstract: Breast cancer is a major concern in the world today, and early and accurate diagnosis is most crucial in the case of breast cancer, as it is among the disorders where the total cost of loss of life is high. Traditional screening processes are subjective and vulnerable to inter-observer reliability issues and diagnostic errors, being primarily based on manual interpretation of medical images. To address these limitations, Deep Learning (DL) …
Published in Research and Reviews : A Journal of Medical Science and Technology · Vol. 15, Issue 1, 2026 · pp. 24–34 Read article
-
Finding Color Blindness Using Ishihara Algorithm
Abstract: This paper is aimed to develop a back propagation artificial neural network (ANN) model that could distinguish crop plants from weeds. Although only the color indices associated with image pixels were used as inputs, it was assumed that the ANN model could develop the ability to use other information, such as shapes, implicit in these data. The 756x504 pixel images were taken in the field and were then cropped to …
Published in Research & Reviews: A Journal of Bioinformatics · Vol. 2, Issue 1, 2015 · pp. 1–14 Read article
-
Bearing Defect Diagnosis: An Approach for Manufacturing Industries Using Wavelet Transform Based Features
Abstract: To maintain reliability in the manufacturing units, industries have concentrated their attention on the condition based maintenance. Fault detection and diagnosis are the two of three condition based maintenance mainstays. Bearing is one of the most important and essential components of the rotating machines. Hence, the researchers have shown their interest in bearing fault detection and diagnosis from the last few years. They mainly use bearing vibration as fault characteristics …
Published in Journal of Microelectronics and Solid State Devices · Vol. 4, Issue 1, 2017 · pp. 15–21 Read article
-
Seismic-Resilient Structural Systems: Geotechnical Engineering
Abstract: Earthquakes represent one of the most destructive natural hazards, capable of causing severe structural damage, loss of life, and substantial economic disruption. Seismic waves propagating through the ground can induce excessive forces and deformations in buildings, often leading to partial or complete collapse. Statistical records indicate that thousands of earthquakes occur globally each year, including several major events that result in significant damage. Past earthquake disasters have repeatedly demonstrated that …
Published in Journal of Geotechnical Engineering · Vol. 13, Issue 1, 2026 · pp. 55–63 Read article
-
Comparison of Bit Error Rate and Interleaver in Coding Scheme
Abstract: The powerful channel coding schemes, namely, those based on turbo codes with different type of interleaver design and iterative scheme of decoding. The Shannon’s predictions to optimal codes would imply random like codes and intuitively implying that the decoding operation on these codes would be prohibitively complex in nature. A brief comparison of Turbo codes with different type interleaver will be given in this section, both in term of actual …
Published in Journal of Mechatronics and Automation · Vol. 7, Issue 1, 2020 · pp. 1–5 Read article
-
Power Quality Monitoring in Wind Solar Hybrid System
Abstract: With the development of new functionalities, solar and wind energy based hybrid systems are upcoming energy source with higher efficiency. Solar and wind energy being naturally available in abundance and non-polluting, is one of the most promising sources. Due to the development of modern power electronic devices, the power quality of wind solar hybrid system gets affected. Hence, due to the increasing usage of sensitive electronic equipments in wind solar …
Published in Journal of Power Electronics and Power Systems · Vol. 8, Issue 1, 2018 · pp. 16–23 Read article