Search
204 articles for “Circuit analysis”
-
Optimum Setting of Distance Protection Scheme for HV Transmission Line
Abstract: Protective relays in a power system are used to detect system abnormalities and to execute appropriate commands to isolate swiftly only the faulty component from healthy system. One of the protective relay is the distance relay. When the fault occurs it is seen that large amount of current flows through the network. The distance relay detect the over current by measuring the impedance of the transmission line and send the …
Published in Journal of Power Electronics and Power Systems · Vol. 3, Issue 2, 2013 · pp. 23–36 Read article
-
Implementation of Different Low Power Techniques on CMOS Inverter and NAND Circuits
Abstract: The growth in technology has increased the usage of additional components on a single chip. This increased number of components on a single chip increases the significant amount of power dissipation and this causes the major challenge for the today’s circuit designers. There are several techniques in VLSI field which help to reduce power dissipations. This paper has analytical analysis of different low power techniques on CMOS inverter and NAND …
Published in Journal of VLSI Design Tools and Technology · Vol. 9, Issue 1, 2019 · pp. 38–43 Read article
-
Comparative Assessment of Polymers and Composites for Solar Panels: Fundamentals, Performance Metrics, Manufacturing, and Sustainability
Abstract: This paper presents a comprehensive review of the main types of Photo Voltaic polymers and composites such as crystalline silicon (both mono- and poly-Si), thin-film tech (CdTe, CIGS, a-Si), perovskites, and organic/dye-sensitized cells and analyses the parameters such as efficiency, fill factor, open-circuit voltage, temperature response, and degradation. The analysis focusses on polymers and composites and manufacturing techniques like vapor deposition, roll-to-roll printing, and both solution and vapor techniques for …
Published in Journal of Polymer & Composites · Vol. 14, Issue 3, 2026 · pp. 120–130 Read article
-
Behaviour of Three Legged 400 kV Double Circuit Steel Transmission Line Tower by Using Different Diaphragm Comparative Study
Abstract: Power is a vital solution for the growth of any country’s economy. India has the third largest producer of power in the world. As per the Census and Economic Information report, India has 1,06,991 GWh power capacity up to Mar. 2019. So, optimizations of transmission line towers are vital to reduce the cost the power sector and it’s depending on various factors, i.e. materials, size and shape of the section, …
Published in Journal of Structural Engineering and Management · Vol. 6, Issue 3, 2019 · pp. 20–31 Read article
-
Cell Balancing in Lithium-ion Batteries – A Comparative Evaluation
Abstract: Balancing the cells within a battery system is essential for safeguarding against overvoltage, overcharge, and over-discharge, which can lead to system failures and safety hazards. Two commonly employed methods for cell balancing are passive and active balancing. In passive balancing, excess charge is dissipated through resistors, while active balancing involves the controlled flow of charge within the circuit. This paper focuses on the comparison and analysis of passive and two …
Published in Journal of Power Electronics and Power Systems · Vol. 14, Issue 1, 2024 · pp. 37–45 Read article
-
A Time Domain Analysis on Chip High Speed VLSI Optical Interconnection Network
Abstract: Intrachip optical interconnects (OIs) have the potential to outperform electrical wires and to ultimately, solve the communication problem, and to obtain high-performance integrated circuits. In this study, the International Technology Roadmap for Semiconductors (ITRS) is used as a reference to fulfill the requirements of silicon-based ICs must satisfy to successfully perform copper electrical interconnects (IEs). Keywords: Integrated optoelectronic circuits, optoelectronics, optical interconnects (ICs), silicon photonicsCite this ArticleAbhishek Sharma, Sudhir Kumar …
Published in Journal of VLSI Design Tools and Technology · Vol. 8, Issue 3, 2018 · pp. 36–44 Read article
-
Study of Efficient HVDC Boost Converters: Design Challenges and Solutions
Abstract: The boost converter is a fundamental circuit topology in power electronics, widely used for voltage step-up applications. This article explores the design principles, operational characteristics, and performance analysis of boost converters. It delves into key components such as the power switch, inductor, capacitor, and control circuitry, elucidating their roles in achieving efficient voltage conversion. The use of a high voltage direct current (HVDC) boost converter for bug zapper purposes is …
Published in Journal of Control & Instrumentation · Vol. 15, Issue 3, 2024 · pp. 42–48 Read article
-
A Hybrid Cascaded Multilevel Inverter using Space Vector Pulse Width Modulation
Abstract: This paper proposes a topology of hybrid cascaded multilevel inverter consisting of two inverters namely main inverter and auxillary inverter. Main inverter consists of three-leg inverter with single DC source and auxillary inverter consists of three H-bridge two-leg inverter with separate DC sources for each H-bridge. Switches used in our proposed method are IGBT (insulated-gate bipolar transistor). The proposed model consists of 18 switches. The switches are controlled by space …
Published in Journal of Power Electronics and Power Systems · Vol. 5, Issue 1, 2015 · pp. 14–19 Read article
-
Non-Invasive Diabetes Test by Breath Analysis using Semiconductor Gadget
Abstract: AbstractNon-invasive detection of diabetes via acetone sensing using nanostructure semiconductor metal oxides (SMO) is an alternative fast and direct method to invasive blood analysis. It is a reliable and accurate technology. Of late, graphene and graphene oxides are promising nanomaterials for acetone sensing.Keywords: Non-invasive diabetes; Breath analysis, Acetone sensing; Nano materials.Cite this ArticleSurajit Kumar Hazra, Sukumar Basu. Non-Invasive Diabetes Test by Breath Analysis using Semiconductor Gadget. Journal of Semiconductor Devices …
Published in Journal of Semiconductor Devices and Circuits · Vol. 7, Issue 2, 2020 · pp. 20–22 Read article
-
On The Energization and Steady-State Performance of 6-Pulse Diode Bridge Rectifiers Supplying Constant Voltage Loads
Abstract: The paper addresses the analysis of 3-phase 6-pule diode bridge rectifier circuits supplying a special load category representable by constant voltage sources. The applied Mathematica-based solution technique can handle symmetrical and unsymmetrical 3-phase voltages. The presented results include the phase currents on the AC side as well as the magnitude and wave shape of the output current on the DC side. Several case studies demonstrating the impact of the source’s …
Published in Trends in Electrical Engineering · Vol. 11, Issue 1, 2021 · pp. 14–23 Read article
-
Performance Analysis of Fully Flexible Organic Humidity Sensor with Top-Contact and Bottom-Contact OTFTs
Abstract: Abstract: Organic field-effect transistor (OFET) based humidity sensors are extensively used nowadays due to their low cost, mechanically flexible and compatibility with lower temperature fabrication techniques that support the plastic substrate based device and circuit applications. This paper investigates the humidity dependence of performance of organic humidity sensor with Top-Contact and Bottom-Contact OTFTs. Subsequently, impact of channel length on sensor performance is analyzed. The humidity sensitivity of organic sensor drain …
Published in Journal of Semiconductor Devices and Circuits · Vol. 6, Issue 1, 2019 · pp. 26–34 Read article
-
Simulation And Analysis of Radio Frequency Energy Harvesting System Operating at 2.45 GHz Frequency
Abstract: — This paper proposed study of an RF energy harvesting system at 2.45 GHz using a rectifier and an antenna so called rectenna. Inset-fed micro-strip rectangular patch antenna array is fabricated. The rectifier circuit, employing Schottky diodes (HSMS-2850), converts AC power from the antenna to DC for RF detection. Analysis of the antenna's design and parameters such as directivity, return loss, gain, and VSWR is done using high-frequency simulator software …
Published in Journal of Microwave Engineering and Technologies · Vol. 11, Issue 1, 2024 · pp. 7–15 Read article
-
Comparative Analysis of Class-AB Voltage Follower using DTMOS Transistor
Abstract: This paper describes a topology of voltage follower Class-AB Voltage Follower like Translinear voltage follower using MOS and DTMOS Transistor. The circuits are simulated in 90 nm technology. The results are used to compare the performance of the above voltage followers. All analysis was supported by the simulation results. The analysis are made in terms of gain, bandwidth and transient response using ELDO spice, IC station and Design architect of …
Published in Journal of VLSI Design Tools and Technology · Vol. 5, Issue 2, 2015 · pp. 64–70 Read article
-
Analysis of DIBL Effect in MOSFET Working
Abstract: AbstractOne of the most widely used electronic devices, particularly in digital integrated circuits, is the metal insulator semiconductor (MIS) transistor. Most of the existing transistors used in fabrication of integrated chips are with junctions. The device scaling is growing the channel length between junctions in devices are scaling gone down to 10 nm. Drain Induced Barrier Lowering (DIBL) effect is prominent as the feature size of MOS device keep diminishing. …
Published in Journal of Microelectronics and Solid State Devices · Vol. 5, Issue 3, 2018 · pp. 33–40 Read article
-
Performance Analysis of CMOS and FinFET Based SRAM
Abstract: As CMOS devices are scaled to nanometer regime, the consequences such as short channel effects and variations in the process parameters are increased which affects the reliability and performance of the circuit. In order to over these issues, FinFET can be used as a suitable replacement for CMOS as it is a promising and better technology without sacrificing the reliability and performance of the applications and the circuit design. In …
Published in Journal of VLSI Design Tools and Technology · Vol. 8, Issue 3, 2018 · pp. 23–27 Read article
-
Experimental and Simulated Analysis of Hybrid Auxiliary Energy Storage System for Electric Vehicles
Abstract: Electric mobility contributing to greater extent to balance the energy and power demands, energy storage unitsas well as environment safety for current automobile sector. Electric vehicle has major efficient features of zerocombustion, longer charging and discharging cycle which plays a vital role to replace the ongoing increase in price ofpetroleum fuels and its harmful effect son environment with their degrading store. Many non-conventional energysources like solar, tidal, wind etc. Can …
Published in Journal of Experimental & Applied Mechanics · Vol. 14, Issue 1, 2023 · pp. 23–40 Read article
-
Which is the Best 10T Static CMOS Full Adder for Ultralow-Power Applications?
Abstract: This paper presents the analysis of various 10-transistor CMOS 1-bit full adder circuits in terms of their output levels and finds out the suitable adder cell at 200 mV in subthreshold region at 16-nm technology node for ultra-low power applications. This paper also provides worst case output levels (sum and carry) of all the analyzed adder cells (which are presented in the paper) for various input combinations.Keywords: CMOS, carry, 2:1 …
Published in Journal of VLSI Design Tools and Technology · Vol. 5, Issue 1, 2015 · pp. 45–50 Read article
-
Power Estimation for VLSI Circuits Using Neural Networks
Abstract: Neural network based VLSI power estimation is done which estimates power in VLSI circuits from its input/output and gate information, without simulation and analysis of its detail structure and the interconnections.Artificial neural network is created which helps in estimation of power. Power estimation results from the [2] [3]are used as the training vector for the network .The network is trained using Back-propagation algorithm. Asimple recurrent network is also introduced called …
Published in Journal of VLSI Design Tools and Technology · Vol. 1, Issue 1-2-3, 2011 · pp. 45–56 Read article
-
Strength Assessment of RCC Beams Subjected to Corrosion
Abstract: The damage assessment of civil structural members is one of the most important and recently emerging fields in engineering. Deterioration of a structure may occur due to a host of factors such as poor workmanship, improper maintenance, atmospheric effects, accidents, natural calamities. Certain causes like environmental effects, natural calamities cannot be controlled. Therefore, durability of concrete structures especially those exposed to aggressive environments is of great concern. Many deterioration causes …
Published in Recent Trends in Civil Engineering & Technology · Vol. 2, Issue 1-3, 2012 · pp. 139–152 Read article
-
Leveraging cross-coupled domino logic for low-power, two-port SRAM with resilience to Differential Power Analysis (DPA) attacks
Abstract: Side channel attacks have become a serious threat to embedded and cryptographic systems. These attacks can be deployed by capturing the power consumption traces or electromagnetic radiations from the power and communication channels. SRAM is vulnerable to such attacks. Power consumed by SRAM for various read and write operations can express the information about bits being read from or written into the bit-cells which eventually exposes the instructions and data …
Published in Journal of VLSI Design Tools and Technology · Vol. 11, Issue 1, 2021 · pp. 8–16 Read article