Search
345 articles for “micro-simulation”
-
Interference Effect between Prismatic Buildings Subjected to Microburst Wind
Abstract: Severe thunderstorms are important weather phenomena which impact on various facets of national activity like civil and defense operation, particularly aviation, space vehicle launching and agriculture in addition to its damage potential to life and properties. One of the most important events in the thunderstorms is the “Downburst”. Downbursts occur when a column of descending air reaches the ground and bursts out violently. This downward motion abruptly changes direction and …
Published in Journal of Industrial Safety Engineering · Vol. 1, Issue 1, 2014 · pp. 23–31 Read article
-
AUTOMATED FAULT IDENTIFICATION AND TRACKING IN POWER TRANSMISSION NETWORKS USING GPS
Abstract: Power transmission lines are vulnerable to faults caused by environmental factors, aging infrastructure, and external disturbances such as falling trees or animal contact. Prompt and accurate detection and location of these faults are essential to ensure uninterrupted power delivery, reduce equipment damage, and minimize downtime. This project presents an automatic fault detection and location system using GPS technology integrated with a microcontroller-based sensing module. The proposed system continuously monitors voltage …
Published in Journal of Power Electronics and Power Systems · Vol. 15, Issue 3, 2025 · pp. 37–43 Read article
-
Chitosan polymer and composites Hydrogels: An Emerging Approach for Microplastic Elimination from Water
Abstract: Hydrogel is a polymer network which can retain huge volumes of water but still retains its shape because of its special chemical formula. Recently, hydrogels have become an object of great interest for environmental remediation due to the possibility of controlling their physicochemical properties in the case of removal of microplastics. The current work reviews and analyzes the efficiency of application of conventional coagulation systems based on chitosan and new …
Published in Journal of Polymer & Composites · Vol. 14, Issue 4, 2026 Read article
-
Design and Analysis of Multi Band Patch with Enhanced Bandwidth
Abstract: In this article, a novel lower edge defected multi-band patch with modified ground structure (or Defected Ground Structure-DGS) with enhanced bandwidth has been presented. The bandwidth can be enhanced by defecting the partial ground and by arc truncation of lower edges of the patch. The antenna was converted into multi-band by defecting the lower corners. The antenna is resonating at multiple bands i.e. 3.7 GHz, 7.87 (~7.9) GHz, 12.19 (~12.2) …
Published in Journal of Microwave Engineering and Technologies · Vol. 7, Issue 3, 2020 · pp. 1–8 Read article
-
Design and Simulation of Improvement of Voltage Profile by Efficient Placement of Distributed Generation in Micro Grid
Abstract: The headway of Decentralized Generators or Distributed Generation (DG) acquaints new changes with the since a long time ago settled power framework. Dissemination Generation plays a prime capacity in conveyance framework by updating the frameworks unwavering quality, abridgement in power misfortunes and elevating the voltage profile. This paper proposes a scientific way to deal with catch the ideal size and ideal portion of DG substances in reconfigured appropriation system to …
Published in Trends in Electrical Engineering · Vol. 10, Issue 2, 2020 · pp. 1–8 Read article
-
Gain Enhanced 2.4 GHz Slotted Rectangular Microstrip Patch Antenna with FR-4 Epoxy Substrate
Abstract: Applications that use the Internet of Things (IoT) must be combined with wireless networking technologies. This makes it easy to get to the application data. The wireless communication system is a key part of the infrastructure for the Internet of Things. It acts as a bridge for two-way connections to gather data and send control messages. In this work, HFSS software is used to create a rectangular microstrip patch antenna …
Published in Journal of Microwave Engineering and Technologies · Vol. 10, Issue 1, 2023 · pp. 20–26 Read article
-
Design of a Multiband Antenna with Rectangular and Circular Slots for 5G Mobile Technology
Abstract: AbstractThis paper presents a microstrip patch antenna for 5G mobile communication. Requests for mobile communication arise because of rapid growth in mobile users. So, users need more features like high data rate, good communication and reduced traffic on their mobile phones. These requirements can be met using 5G technology. 5G technology offers very high bandwidth, reduced latency, broadband spectrum, improved QoS and a better capacity. 5G operates from 24 GHz …
Published in Journal of Microwave Engineering and Technologies · Vol. 7, Issue 2, 2020 · pp. 30–34 Read article
-
Design and Implementation of Microstrip Line Fed Rectangular Patch Antenna
Abstract: AbstractThis paper presents a high-performance microstrip line fed rectangular patch antenna with resonance frequency of 2.75GHz. The antenna has been simulated using IE3D software as well as HFSS. The return loss of the patch antenna found to be 24dB through IE3D simulation tool. From the results obtained, it is clear that harmonics exists at 3.75GHz which successfully minimized by removing a part of microstrip conductor with dimensions in accordance to …
Published in Journal of Microwave Engineering and Technologies · Vol. 7, Issue 1, 2020 · pp. 1–4 Read article
-
A Dipole Circular Patch Antenna for Operation in the X-Band
Abstract: This microwave engineering research paper proposes, designs, calculates, and simulates a novel dipole circular patch antenna for theoretical wideband operations in the X-band (the 8 GHz to 12 GHz frequency range). This proposed microstrip patch antenna was realized using FR-4 as a dielectric (a thickness of 1.5 mm) with copper being used in both the ground plate and the two transmitting circular elements (the so-called patches with a thickness of …
Published in Journal of Microwave Engineering and Technologies · Vol. 8, Issue 2, 2021 · pp. 1–8 Read article
-
E-Shaped Microstrip Patch Antenna for High Speed Wireless Local Area Network (WLAN) Applications
Abstract: A microstrip antenna consisting of E-shape radiating patch having low profile, probe-fed is designed and proposed for wireless local area networks (WLAN) applications. All countries use different WLAN, as the antennas available are not able to cover all the standards. This study aims to design a smallest antenna with better polarization covering all high speed WLAN standards ranging from 4.47 to 5.82 GHz. The patch antenna designed on low cost …
Published in Journal of Telecommunication, Switching Systems and Networks · Vol. 4, Issue 1, 2017 · pp. 1–5 Read article
-
Design and Analysis of A Terahertz Microstrip Antenna
Abstract: Terahertz radiation is in the electromagnetic spectrum. Terahertz radiation is used for a variety of purposes since it is non-ionizing and may move in a straight line. It has some similarities with microwaves, in that terahertz radiation can penetrate non-conducting materials, but it shows less depth of penetration than microwaves. Compared to millimeter waves the capacity of Terahertz waves is large enough and possesses high data transmission rates. Terahertz radiation …
Published in Journal of Microwave Engineering and Technologies · Vol. 10, Issue 1, 2023 · pp. 1–7 Read article
-
Design Optimization of a Micro Wind Turbine
Abstract: Nation’s economic health depends on Industrialization. For the growth of Industrial sector i.e. in turn that of society, adequate uninterrupted electric power is essential. Conventional fuel sources are limited and hence the whole world is searching for proper renewable energy sources. Out of many renewable energy sources (Solar, wind, waves etc.) wind energy is offering substantial contribution today. Although, according to Betz’s limit, only 59% energy conversion (i.e. efficiency) can …
Published in Journal of Control & Instrumentation · Vol. 5, Issue 3, 2014 · pp. 1–7 Read article
-
Report on the Novel Electrical Characteristics of Microelectronic High Electron Mobility Transistors to Establish a Low-Cost Microelectronics Laboratory in the National Institute of Technology Arunachal Pradesh
Abstract: AbstractIn this work, total 22584 individual simulation-outputs are reported according to the performed simulation-studies on the microelectronic AlGaN/GaN high electron mobility transistors (HEMTs). This series of simulation work has been performed using the SILVACO-ATLAS software tool on the basis of already established theories related to the semiconductor-physics of HEMTs. In this work, the drain characteristics are investigated with respect to the aluminium mole fraction, drain voltage, gate voltage, gate length …
Published in Journal of Semiconductor Devices and Circuits · Vol. 4, Issue 2, 2017 · pp. 6–28 Read article
-
Tri-Band Edge-Cut Rectangular Microstrip Patch Antenna on Composite Substrate for RF Energy Harvesting in IoT Networks
Abstract: The increasing use of Internet of Things devices underscores the pressing need for sustainable energy solutions, since traditional batteries necessitate regular replacement and constrain scalability. Radio frequency energy harvesting is a viable option; nonetheless, antenna design continues to provide a significant problem owing to the requirements for compactness, efficiency, and multi-band functionality. A hybrid composite substrate configuration combining FR4 (εr = 4.3) and RT Duroid (εr = 2.2) is employed …
Published in Journal of Polymer & Composites · Vol. 14, Issue 1, 2026 · pp. 867–883 Read article
-
Triple Band PIFA Antenna Using The DGS Method
Abstract: In this paper, a new design of a triple band Planner Inverted –F Antenna (PIFA) with DGS, for mobile and wireless communication systems is presented. The PIFA antenna consists of ground plate, patch antenna, feeding port and shorting plate connected to the ground plate. The designed antenna has been simulated with the help of the CST (computer Simulation Technology) software microwave studio 2010. The simulated results calculated for the resonant …
Published in Journal of Microwave Engineering and Technologies · Vol. 1, Issue 2, 2014 · pp. 9–16 Read article
-
Digital Modules of the Green Buildings to Study Protection of Air Quality
Abstract: The aims of this study are to simulate air flows inside and around multi-storey green building spaces together with the distribution of concentrations of harmful substances and microorganisms to increase the sustainability of design solutions for green modules. Among the objectives of the study are assessment of bioclimatic comfort, risk analysis of bioclimatic eco-safety in the framework of aeration and pollution modeling, as well as eco-optimization of building design, which …
Published in Journal of Polymer & Composites · Vol. 13, Issue 1, 2025 · pp. 838–846 Read article
-
Design of Triple Band Microstrip Yagi Uda Antenna
Abstract: Abstract A microstrip yagi uda antenna with triple band is proposed in this paper. The design antenna consists of CPW feeding in which the ground plane and the yagi antenna are on the same plane. The resonating frequency of design antenna is 6.29, 7.97 and 9.26 GHz. The antenna had achieved the directivity of 5.232, 5.704 and 6.062 dBi. The impedance of antenna is completely matched at all the three …
Published in Current Trends in Information Technology · Vol. 3, Issue 2, 2013 · pp. 7–10 Read article
-
Dual Band Suspended Microstrip Right-angled Isosceles Triangular Patch Antenna
Abstract: ABSTRACT In this paper a dualband suspended microstrip right-angled isosceles triangular patch antenna is designed for use in microwave imaging system for breast cancer tumour detection. An approximate design equations are developed and validated by CST Microwave Studio’s simulated result. Here dual band operation is achieved by manipulating fundamental mode and higher mode of microstrip antenna. Tuning of this antenna is achieved at frequency 3.35 GHz and 6.70 GHz which …
Published in Journal of Communication Engineering & Systems · Vol. 2, Issue 2, 2012 · pp. 7–13 Read article
-
Analysis of Thermally Actuated Micromirrors
Abstract: Use of microelectromechanical system (MEMS) to craft deformable mirror is in the embryonic stage. However, MEMS micromirrors hold significant advantages in speed, compactness, and economy in comparison to macroscale counterparts. The MEMS micromirrors are fabricated by silicon batch processing or micrometer scale lithographic pattering technique which offer flexibility in low volume manufacturing and inter batch variations. The project is a structural study and involves the modeling of various geometries for …
Published in Journal of Mechatronics and Automation · Vol. 6, Issue 3, 2019 · pp. 17–23 Read article
-
Effect of Aluminium Nitride Layer on the Electrical Performance of Microelectronic HEMTs
Abstract: AbstractIn this simulation work, a series of simulation outputs are reported related to the AlGaN/GaN single-heterojunction high electron mobility transistors (HEMTs). The effect of aluminium nitride nucleation layer on the drain characteristics is significant in single-heterojunction AlGaN/GaN HEMTs. The effects of drain voltage and gate voltage on the drain current are studied in the designed and simulated device structures. This simulation work may be a useful prediction to fabricate the …
Published in Journal of Microelectronics and Solid State Devices · Vol. 4, Issue 3, 2017 · pp. 9–12 Read article