Search
1122 articles for “Concentricity”
-
Thermodynamic, Kinetic and Mechanistic Investigations of Ruthenium(III) Catalyzed Methylparaben Oxidation by Diperiodatocuprate(III) in Aqueous Alkaline Medium
Abstract: The kinetics of ruthenium(III) catalyzed degradative oxidation of methylparaben by the copper complex, diperiodatocuprate(III) in alkaline medium is studied at 25ºC and at a ionic strength of 8.0 × 10−2 mol dm−3. In the presence of catalyst ruthenium(III), the reaction between methylparaben and diperiodatocuprate(III) in aqueous alkaline medium exhibits 1:1 stoichiometry. The oxidation products were identified by UV-visible, GC-MS and IR spectroscopy. The reaction exhibited unit order in case of …
Published in Journal of Catalyst & Catalysis · Vol. 2, Issue 1, 2015 · pp. 4–17 Read article
-
Adsorption of Congo Red Dye in Aqueous Solution using Moringa oleifera Seed Powder
Abstract: The feasibility of using Moringa oleifera seed for the Congo red adsorption from aqueous solution has been investigated as a low cost and an eco-friendly adsorbent. Adsorption studies were conducted on a batch process, to study the effects of contact time, initial dye concentration and adsorbent dosage. Maximum colour removal was observed at higher adsorbent dosage. The present dye removal decreased from 95% to 81% as the dye concentration has …
Published in Journal of Catalyst & Catalysis · Vol. 8, Issue 1, 2021 · pp. 8–18 Read article
-
Fermentation of Potato Peels Using Saccharomyces cerevisiae as a Fermenting Yeast
Abstract: This research was basically on the investigation into the possibility of fermenting a potato peel using Saccharomyces cerevisiae as a fermenting yeast which gave a very favourable result and found reliable and adoptable. Selected number of peels were washed very well with stream water (running water) to remove any form of dirt such as sand and other particles, and then the stone particles since the potato is a root crop. …
Published in Journal of Catalyst & Catalysis · Vol. 9, Issue 1, 2022 · pp. 1–5 Read article
-
Generating Fuel Energy by Catalytic Pyrolyzing of Microalgae
Abstract: In biomass pyrolysis process, a catalyst is used to modify the pyrolysis gases' chemical composition and increase the bio-oil fraction. This process uses the byproducts of thermal conversion processes. It is anticipated that the introduction of pyrolysis catalysts in the case of microalgae will lower the bio-oxygen oil's content and increase the number of added-value compounds in this liquid fraction. Catalysts can also help decrease the nitrogen in bio-oil. As …
Published in Journal of Catalyst & Catalysis · Vol. 9, Issue 2, 2022 · pp. 31–35 Read article
-
Impact of water-cement ratio and cement content on pore area percentage and chloride diffusion – A molecular dynamics study
Abstract: The exposure of a reinforced structure to water-based settings leads to the occurrence of chloride-induced corrosion, resulting in a reduction in both the durability and performance of the structure. The entry of chloride ions into concrete and the pore area percentage is influenced by several elements, including the degree of humidity, the presence of fractures, environmental conditions, water-to-cement ratio (w/c ratio), and cement content. This research focuses on the utilization …
Published in Journal of Construction Engineering, Technology & Management · Vol. 13, Issue 3, 2023 · pp. 37–45 Read article
-
Gas and Temperature Detection System using Microcontroller
Abstract: In current system safety plays an important role, so best safety systems to be implemented in everyday routines. Gas leakage is a major concern with residential, commercial premises, and gas powered transportation vehicles. One of the preventive measures to avoid the danger associated with gas leakage is to install a gas leakage detector at vulnerable locations. The objective of this work is to present the design of a cost effective …
Published in Journal of Control & Instrumentation · Vol. 4, Issue 2, 2013 · pp. 1–7 Read article
-
Frozen Waves: Double T-Shape Patch Antenna Sensor for Precise Ice and Snow Measurement
Abstract: To design a Micro strip patch antenna with double T shaped slots at operating frequency 2.4GHz was developed for ice detection and measurement application. Detection was performed by monitoring the resonance frequency and amplitude of the transmission coefficient between the antenna sensor and a broadband receiver. The patch antenna sensor is also capable of distinguishing between ice and water, respectively when compared to the bare sensor. The antenna was also …
Published in Journal of Control & Instrumentation · Vol. 14, Issue 3, 2023 · pp. 15–20 Read article
-
Experimental Investigation of Effect of Temperature and Molarity on Compressive Strength of Geopolymer Concrete
Abstract: Geopolymer concrete is a relatively new development in the field of concrete, in which regular Portlandcement is completely replaced with pozzolanic material such as fly ash, which is then activated by astrongly alkaline solution to function as a binder in the mix. As a result, we must manufactureenvironmentally friendly concrete to address issues such as global warming and CO2 emissions intothe atmosphere generated by standard Portland cement production. An experimental …
Published in Journal of Experimental & Applied Mechanics · Vol. 12, Issue 3, 2021 · pp. 34–39 Read article
-
Appliance Scheduling Optimization For Demand Response Using Schedulling Algorithm
Abstract: The exploration concentrates on the test of the power utilization the board in keen networks. It centers around various effects of interest reaction running in the savvy matrix connecting with buyers to take part. The principle obligation of the interest reaction framework is planning the activity of machines of customers to accomplish an organization wide advanced execution. Each taking an interest power purchaser, who claims a bunch of home machines, …
Published in Journal of Electronic Design Technology · Vol. 12, Issue 2, 2021 · pp. 10–16 Read article
-
Modeling Reaction Rate of Dispersion Coefficient and Oxygen Deficit on Nitrobacteria Transport in Onu-Imo River
Abstract: The migration rate of nitrobacteria in the Onu-Imo River was monitored based on some variables that determine the predictive model for such pollution transport. These parameters were factors applied in developing the derived model for the study. The variables were integrated into the system to monitor their various rates of impact on the transport process in the study environment. This was monitored by applying a one-dimensional flow transport system at …
Published in Journal of Energy, Environment & Carbon Credits · Vol. 11, Issue 1, 2021 · pp. 28–41 Read article
-
Aerosol to Suggest Climate Delineation
Abstract: Marine aerosol of submicron sized biogenic originated organic fraction is subtending persistently constitutively compared to drastic variation based on volcanic eruptions. Sulphur is studied to form acid aerosol where the basic constituent in the stratosphere is reduced comparatively. High concentrations of organic fraction have been found from aerosol in marine boundary layer (MBL). Marine aerosol chemical composition has been influenced by the yearly biological cycle of the ocean, and so …
Published in Journal of Energy, Environment & Carbon Credits · Vol. 11, Issue 2, 2021 · pp. 51–58 Read article
-
Characterization and Optimization of Neem Leaves and Moringa Seed Husk-based Composite Activated Carbon for Efficient Adsorption of Methylene Blue Dye
Abstract: The research in question was meticulously conducted within the premises of the Nigerian Liquefied Gas (NLG) Engineering laboratory, situated at the esteemed University of Maiduguri, Nigeria. This study focuses on the development and characterization of a composite material derived from neem leaves (NL) and Moringa seed husk (MSH) to adsorb methylene blue (MB) dye effluent. The synthesis process involved pyrolyzing MSH and NL at 400°C to produce MSH and NL …
Published in Journal of Energy, Environment & Carbon Credits · Vol. 13, Issue 3, 2023 · pp. 12–22 Read article
-
Use of Geohydrological Controls to Tackle Geogenic Arsenic Contamination of Hard Rock Aquifer: A Case Study from Central India
Abstract: AbstractArsenic poisoning of potable groundwater is considered one of the most severe health hazard in recent years. Reporting of high geogenic arsenic contamination in groundwater is increasing day by day within the country. The hydrothermal phase following the batholithic intrusion is responsible for sulfide mineralization and related enrichment of Arsenic (As) concentration in the granite-meta rhyolite rocks along the Kotri lineament of central India. Isolated clusters of high As groundwater …
Published in Journal of Geotechnical Engineering · Vol. 3, Issue 2, 2016 · pp. 23–29 Read article
-
Assessment of Air Quality Index using High Volume Sampler for Nasik City
Abstract: Seismic Information on air quality in urban areas represents an important objective to raise awareness and participation of citizens towards those measures aimed at containing and reducing vehicular traffic. For several years at the international level, evaluation procedures have been adopted by indices. One of the first synthetic indices, adopted by the United States Environmental Protection Agency (US-EPA), have established an exchange of information from networks and individual stations measuring …
Published in Journal of Industrial Safety Engineering · Vol. 8, Issue 3, 2021 · pp. 9–16 Read article
-
Centrifugal Casting of Nano Crystalline TiB2 Reinforcement Particulate Reinforcement in Al-Alloy Matrix
Abstract: A method of producing Nano size TiB2 particles within an aluminium matrix is the in situ reaction synthesis method, using KBF4 and K2TiF6 potassium based bearing fluxes. The advantages of this in situ reactive process are a small particle size and good particle/matrix interfacial bonding. However, this method is limited to producing low particulate volume percentage material (˂6 vol%). To overcome this limitation, centrifugal casting has been investigated. A series …
Published in Journal of Materials & Metallurgical Engineering · Vol. 3, Issue 3, 2013 · pp. 7–13 Read article
-
Synthesis and Characterization of Green Synthesized Iron Nano Particle (GInP) Using Eucalyptus globulus for Lead Removal
Abstract: The application of green synthesized iron nanoparticle for the removal of lead is researched in this study. The FT-IR and XRD results reveal that a nanoparticle with 80 nm size could be synthesized using Eucalyptus globulus leaf extract. The specific surface area of the nanoparticle was found to be 59 m2/g. The lead removal capability of the green synthesized iron nanoparticle (GInP) was investigated for lead concentration ranging from 50–250 …
Published in Journal of Materials & Metallurgical Engineering · Vol. 10, Issue 3, 2020 · pp. 20–25 Read article
-
Determination of Heavy Metals in Soil Samples in the Vicinity of Liquid Natural Gas Project, Shabwah Governorate, Yemen
Abstract: The present work aimed to determine the contaminants in soils resulting from or deposited due to emissions that come from natural gas in the area of Balhaf which is an LNG project in Republic of Yemen. Total of 8 surface soil samples were collected at depth of approximately (0–10 cm) from two sites which has different distances from the natural gas liquefaction project, took 4 samples from first site. The …
Published in Journal of Materials & Metallurgical Engineering · Vol. 12, Issue 1, 2022 · pp. 67–76 Read article
-
Surface Modified Abaca Fibers: Physico-Mechanical, Morphological and Degradation Properties Evaluation
Abstract: Lignocellulosic fibers are used as cost-cutting fillers in plastics factories. Amid several factors, the ultimate performance of composite ingredients depends on the bond between the matrix resin and the filler, and hence on the quality of the interface. To acquire optimal performance of the end product, adequate interaction between the matrix and the lignocellulosic ingredient is preferred. This is often acquired through surface modification of the matrix or filler. Abaca …
Published in Journal of Materials & Metallurgical Engineering · Vol. 12, Issue 2, 2022 · pp. 34–46 Read article
-
Gallium Nitride based HEMTs in Nano-Scale Regime
Abstract: AbstractIn this work, a maximum drain current of 557 mA is achieved by the simulated structures of double-heterojunction HEMTs using the SILVACO-ATLAS software tool. The drain current is found to be higher at shorter gate length. The drain current is observed as higher at larger aluminium mole fraction. The drain current is also higher at larger thickness of AlGaN barrier layer. Again, the drain current is higher at larger doping …
Published in Journal of Microelectronics and Solid State Devices · Vol. 5, Issue 3, 2018 · pp. 11–21 Read article
-
Assessment of Natural Radiation Exposure from Sand and Sediment Samples Obtained from Kuakata Beach Area in Bangladesh
Abstract: In Bangladesh, Kuakata Beach situated in Patuakhali district contains some in sand and sediment. In this paper the activity concentration and absorb dose of sand and sediment collected sand and sediment collected from Kuakuta Beach were measured. The activity concentrations of radionuclides and their respective annual effective dose rates, produced by 226Ra, 232Th, 40 K were measured using a High Purity Germanium (HPGe) detector of relative efficiency 40%. The measured …
Published in Journal of Nuclear Engineering & Technology · Vol. 8, Issue 3, 2018 · pp. 18–26 Read article