Search
620 articles for “Subtractive Synthesis”
Nothing matched all of your words, so these match any of them.
-
Synthesis of low cost artificial sand from fly ash and its application as a filter material
Abstract: The usage of natural river sand is increasing vastly. Geopolymers are materials with three-dimensional alumina silicate structures that have a high mechanical strength and can be used as an alternative to Portland cement. The probability of using Natural river sand can also be replaced with geopolymer synthetic sand. There are many properties which may lead the scarcity of natural river sand they are Because of landslides, tsunamis and erosion. The …
Published in Journal of Geotechnical Engineering · Vol. 9, Issue 3, 2022 · pp. 37–46 Read article
-
Synthesis and Characterization of Ta Doped Nanostructured PZT
Abstract: Lead Zirconate Titanate (PZT) powder of composition Pb(Zr0.65Ti0.35)O3 was modified by incorporation of Tantalum (Ta5+) in a wide composition range (5–25 at%) by chemical co-precipitation method using PbO, Zr2O3, TiO2 and Ta2O5. X-ray diffraction patterns of the samples showed the formation of a single phase and confirmed the formation of a rhombohedral phase of all the samples after sintering. SEM analysis showed well-developed, uniformly packed grains. Both the linear particle …
Published in Journal of Materials & Metallurgical Engineering · Vol. 3, Issue 2, 2013 · pp. 41–48 Read article
-
Al-MMC Foam: Synthesis and Characterisation
Abstract: Aluminium alloy composite foams are produced in the laboratory using TiH2-CaCO3 dual foaming agents. The density of the developed material varied along various cross sections. There exists a more pronounced variation in density along the direction of foaming. Compressive and tensile tests are performed on Aluminium Metal Matrix composite (Al-MMC) specimens of different relative density. The compressive stress-strain response of the material establishes their engineering utility in terms of their …
Published in Journal of Materials & Metallurgical Engineering · Vol. 1, Issue 1-3, 2011 · pp. 18–27 Read article
-
Synthesis and Characterization of Green Synthesized Iron Nano Particle (GInP) Using Eucalyptus globulus for Lead Removal
Abstract: The application of green synthesized iron nanoparticle for the removal of lead is researched in this study. The FT-IR and XRD results reveal that a nanoparticle with 80 nm size could be synthesized using Eucalyptus globulus leaf extract. The specific surface area of the nanoparticle was found to be 59 m2/g. The lead removal capability of the green synthesized iron nanoparticle (GInP) was investigated for lead concentration ranging from 50–250 …
Published in Journal of Materials & Metallurgical Engineering · Vol. 10, Issue 3, 2020 · pp. 20–25 Read article
-
Recent Progress in Synthesis of Metal Nanostructures in Plasmonic: A Review
Abstract: Plasma physics is a very mature field, studied extensively for well over a century the cross-disciplinary field of plasmonics (electromagnetics of metallic nanostructures), on the other hand, has only recently gained popularity due to its potential for extraordinary light control via novel classes of materials and the resulting applications. As a result of this rapid development, the deep connections with the mother discipline, plasma physics, have sometimes been overlooked. The …
Published in Journal of Nuclear Engineering & Technology · Vol. 11, Issue 3, 2021 · pp. 1–4 Read article
-
Synthesis and Characterization of Banana Fiber Composite
Abstract: AbstractBanana fiber is used for making handbags, floor mats, ropes, clothes, etc., since many years. The authors considered banana fiber to make composite with thermoset material. The purpose of this work was to establish and optimize a process for production of banana fiber-reinforced composite material with thermoset. Fiber surface modification and treatment were studied along with processing condition for polyester fiber composite. Natural fiber-reinforced bio-degradable composites are good alternative for …
Published in Journal of Polymer & Composites · Vol. 2, Issue 3, 2023 · pp. 1–3 Read article
-
Conductive Organic Polymer Based Inorganic-Organic Hybrid Composite: Synthesis and Characterization
Abstract: Inorganic organic (IO) hybrids where inserted conducting organic polymer (COP) imprints their polymeric nature onto the hybrid material are one of the most promising candidates for solving many technological problems of modern technocratic society. The Inorganic-organic hybrid material of para toluidine (organic) & mercuric chloride (inorganic) was synthesized by using “instant-heating and slow-cooling” technique. Some light orange coloured plate-like crystals were obtained. XRD pattern of the grown crystal were analysed …
Published in Journal of Polymer & Composites · Vol. 8, Issue 1, 2020 · pp. 1–5 Read article
-
An Optimize Formulation to Synthesis of size Controlled Hydrophobic Starch Acetate Nanoparticles using Box-Behnken Design
Abstract: The best way to improve the overall performance of native starch is by chemical modification. In recent years, hydrophobically modified starch has attracted considerable attention for the design and manufacture of novel nanoparticulate drug delivery carriers. The purpose of this research was to synthesize hydrophobic starch nanoparticles (NPs) and to optimize process factors through the use of response surface methodology (RSM). The corn starch acetate (CSA) NPs was synthesized using …
Published in Journal of Polymer & Composites · Vol. 10, Issue 1, 2022 · pp. 32–54 Read article
-
Synthesis and formability of Al/(Fe-Mn) particulate compositeusing stir casting
Abstract: Demand for lightweight and fuel economy by automotive and aircraft industries focuses to explore different materials. Alloys and composites developed with same objective to obtain superior desired mechanical properties compatible for such intended applications. However, alloy consider as solid solutions with metallic properties and cannot mix with primary major element in random proportions. This forced researcher community to develop composites, which are heterogeneous solid solutions or multi-phase materials comprising matrix …
Published in Journal of Polymer & Composites · Vol. 10, Issue 1, 2022 · pp. 80–88 Read article
-
Synthesis of PANI/RGO/NiCrO Nanocomposite Material for Charge Storage Application
Abstract: PANI/RGO/NiCrO nanocomposite is synthesized by chemical oxidative polymerization of aniline and Nickel-Chromium Oxide (NiCrO). The prepared PANI/RGO/NiCrO nanocomposite exhibited high specific capacitance of 800 F/g at the scan rate of 5 mV/s, high power density of 1399.44 Wkg-1 and high energy density of 70 Whkg-1. The as-prepared polymer nanocomposites were characterized by X-ray diffraction (XRD) to study crystallinity, Fourier transform infrared spectroscopy (FTIR) to know the functional groups, Transmission electron …
Published in Journal of Polymer & Composites · Vol. 10, Issue 1, 2022 · pp. 89–99 Read article
-
Synthesis and Characterization of Polymer Blend Electrolyte Based on Bio-degradable Polymers Doped with Ammonium Iodide
Abstract: A polymer blend of Polyvinylalchohol (PVA) and Polyvinylpyrrilodine (PVP) doped with ammonium iodide (NH4I) has been prepared by solution casting method to develop a new solid polymer electrolyte. The influence of NH4I on the structural, electrical characteristics of PVA/PVP blend was investigated utilizing XRD, FTIR and impedance spectroscopy techniques. Structural properties were studied by using the XRD technique and found that the pure polymer blend is in semi crystalline form, …
Published in Journal of Polymer & Composites · Vol. 10, Issue 2, 2022 · pp. 60–71 Read article
-
Synthesis and Characterization of Al-Mg-Si Alloy based Hybrid Composite Reinforced with SiC and Graphite
Abstract: The present work is carried out to investigate the mechanical properties of Al-Mg-Si alloy matrix based hybrid metal matrix composites (MMCs) using stir casting method owing to its popularity and large scale productions. SiC and graphite reinforcements were added each with 1%, 2%, 3% and 4% respectively to fabricate four composites specimens. X-ray diffractometer and scanning electron microscope were used for phase identification and microstructure characterization (SEM). Density, hardness, compressive …
Published in Journal of Polymer & Composites · Vol. 10, Issue 3, 2022 · pp. 9–19 Read article
-
Synthesis and Characterization of Polyvinyl alcohol film incorporated with Tridax procumbens leaf extract
Abstract: Active film materials are prepared by incorporation of natural antimicrobial and antioxidant agents. These materials have attracted growing interest in wound dressing and food packaging process. In this study, active films were developed by incorporation of Tridax procumbens (T. procumbens) leaf extract into Polyvinyl Alcohol (PVA) matrix. T. procumbens leaves have been accounted for their biomedical and nutritional properties. The impact of T. procumbens leaf extract on the physical, mechanical …
Published in Journal of Polymer & Composites · Vol. 11, Issue 2, 2023 · pp. 40–51 Read article
-
Synthesis, Characterization and Deformation Studies of Blast Furnace Slag Particles Reinforced Aa2024 Composite
Abstract: The main objective is to explore the use of blast furnace slag as a reinforcing material. This work provides results of aluminum metal matrix composites reinforced with granulated slag (GS). The Composite is prepared by taking AA 2024 and GS with stir casting process. Optical microscope and scanning electron microscopy were employed to track the reactions between the aluminum matrix and the granulated slag during the sintering treatment. The hardness …
Published in Journal of Thin Films, Coating Science Technology & Application · Vol. 3, Issue 3, 2016 · pp. 31–43 Read article
-
Synthesis and Characterizations of GeS0.5Se0.5 (I2) Single Crystals
Abstract: Material processing of layered structure remains a widely investigated subject in recent time due to their anisotropic properties. The large volume of work carried out in this field is of importance not only in basic science but also in industrial as well as energy applications. In this paper authors report growth of GeS0.5Se0.5 (I2) single crystals using Chemical Vapour Transport (CVT) technique with iodine as a transporting agent. Photograph of …
Published in Research & Reviews: A Journal of Embedded System & Applications · Vol. 7, Issue 1, 2019 · pp. 10–16 Read article
-
Wear Behavior of Al-Alloy (Al-5 Mg) in-situ Reinforced TiB2 Particulate
Abstract: A research has been carried out for replacing Al monolithic alloys by aluminium (Al) based metal matrix composites (MMCs) in many engineering applications where high wear resistance and stiffness are required. In this paper, the investigated dry sliding wear behavior of TiB2 particulate reinforced composite of Al-Alloy (Al-5 Mg) is discussed. The in-situ Al-Alloy (Al-5 Mg) 10wt% TiB2 composite material were prepared by molten flux reaction synthesis using electric melting …
Published in Journal of Materials & Metallurgical Engineering · Vol. 4, Issue 3, 2014 · pp. 32–37 Read article
-
Electrochemical Exfoliation of Graphene Oxide (GO) and Thermally Reduced Graphene Oxide (TrGO) Using Ecofriendly Reducing Agent as Cow Urine
Abstract: The Graphene oxide (GO), the reduced form of GO i.e. (rGO) with thermally reduced graphene oxide (TrGO), have concerned significant interest in various fields with their exceptional properties. We investigate the electrochemical exfoliation processes of GO and rGO to understand their structural and electrochemical behavior of GO and TrGO through various characterization techniques. The electrochemical exfoliation method offers a versatile and scalable approach for the mass fabrication of the materials …
Published in Journal of Polymer & Composites · Vol. 12, Issue 1, 2024 · pp. 89–100 Read article
-
Implications from Iridium—Compose in Versatility
Abstract: Iridium (Ir) is a platinum group of metals suggested to be used in electronic component manufacturing to substitute gold for catalysts, alloy elements and increasing problems. Ir is a high melting metal to avoid corrosion, so rendering is called green as stipulated. Iridium artificial photosynthesis and electron generation capabilities have suggestive problems in supplementing the respective food value after chlorophyll composition and enhancing electricity from supplemented electricity through wind tunnels. …
Published in Journal of Catalyst & Catalysis · Vol. 7, Issue 3, 2020 · pp. 1–7 Read article
-
Catalytic Activity Advancements in Organometallic Chemistry
Abstract: Organometallic chemistry is essential to catalysis and synthesis, helping to shape a wide range of chemical reactions. The study of the interactions between organic compounds and metal elements is known as organometallic chemistry. Modern synthetic chemistry and catalysis have been greatly influenced by the field of organometallic chemistry. It entails the investigation of substances that have metal-carbon bonds because they can have special catalytic and reactive qualities. Applications for these …
Published in Journal of Catalyst & Catalysis · Vol. 10, Issue 2, 2023 · pp. 10–25 Read article
-
Enhanced Thermal Conductivity of Polyaniline Nanofluids Synthesized using CuCl2 as Catalyst
Abstract: AbstractThe development of nanofluids for enhancing the heat transfer properties over the conventional fluids is mainly hindered by a vital issue of dispersion stability and hence is being explored in the present work. In the present study, Copper Polyaniline nanoparticle was synthesized by the oxidative polymerization method using CuCl2 as a catalyst. The characterization of Copper Polyaniline was performed. The sizes of nanoparticles were found to be within 7.24 nm …
Published in Journal of Polymer & Composites · Vol. 11, Issue 1, 2023 · pp. 20–40 Read article