pressure drop
3 articles · search the full text for this term
-
Influence of Epoxy-Based Thermally Conductive Polymer Composites on the Thermo-Hydraulic Performance of Finned Helical Coil Heat Exchangers Across Flow Regimes
Abstract: The use of polymer composites in heat exchanger applications has gained increasing attention due to their advantages in weight reduction, corrosion resistance, and design flexibility. However, their relatively low thermal conductivity compared to conventional metallic materials remains a key limitation for efficient heat transfer. In this study, the thermo-hydraulic performance of a finned helical coil heat exchanger is investigated with particular focus on epoxy-based polymer composites reinforced with thermally conductive …
Published in Journal of Polymer & Composites · Vol. 14, Issue 2, 2026 · pp. 586–602 Read article
-
A review on the Enhancing Heat Exchanger Efficiency with CuO/Water Nanofluid in a Shell and Helical Coil System
Abstract: Over the years, there has been a lot of focus on improving heat transmission by utilizing various approaches in an effort to make heat exchangers smaller and less expensive. The following methods have been found to be the most successful in increasing heat transfer rate in heat exchangers: Nano-Fluids, first (3) Rubbing heat exchanger surfaces rough. (2) Inserting fluid tabulators. However, a combination of all three approaches or any two …
Published in Trends in Mechanical Engineering & Technology Read article
-
Numerical Study and Comparison of Passive Mixing in Helical Micromixers
Abstract: A passive mixing inside three micromixers has been studied with water as the mixing fluid. Since the mixing at the micro-level is governed by species diffusion hence it is a time-consuming process that requires an extended length of micromixer for the required amount of mixing. The present study tackles this problem by introducing two helical micromixers, a Three-dimensional helical micromixer (TDHM), and TDHM having four inlets (TDHM-FO). These micromixers need …
Published in Journal of Polymer & Composites Read article