Search
1986 articles for “failure-prediction AUROC of 0.967” (ranking capped at the first 2,000 matches — narrow the search to see the rest)
Nothing matched all of your words, so these match any of them.
-
Investigation of the Effects of Solpawa SBR-X TM Doses on Total Petroleum Hydrocarbon in Loam Soil at Different Depths
Abstract: Laboratory trials of environmental remediation products bring the hope of inventing such products to reality for many of today’s intractable environmental pollution conditions, paving the way for the field trials and subsequent large-scale field application. This laboratory study was conducted as the first phase of a 2-tiered adaptive trials of Solpawa® Bioremediation System (Solpawa-SBX) funded by the Nigerian Content Development and Monitoring Board (NCDMB). The study investigated the effectiveness of …
Published in Journal of Petroleum Engineering & Technology · Vol. 13, Issue 1, 2023 · pp. 64–72 Read article
-
Industrial wagon tippler to scheme and scope materials handling
Abstract: This article is study about tippler to discharge bulky materials of various plants on conveyor transit system. Tippler is used for emptying loaded wagons by tipping it. Clamp devices have been inclusive to tippler so as to retain wagon from top as well as from side. Wagon tipplers have equipped with track stops, wheel grippers and different type of limit switches. Geometry of fabrication has categorized wagon tipplers by either …
Published in Journal of Production Research & Management · Vol. 12, Issue 1, 2022 · pp. 1–7 Read article
-
A Review of Semiconductor Solar PV Cell and Development of Solar Radiation Estimation Models
Abstract: Today’s life could not be imagined without energy (Power). It has become an integral part of day to day life. Traditionally, dependency was there on conventional sources of energy like coal, hydroelectric etc. But they are limited resources; also, they offer residue or pollution to the environment which is not desirable. These are the main reasons that the researchers inclined themselves towards the maximum exploration and make optimal use of …
Published in Journal of Semiconductor Devices and Circuits · Vol. 5, Issue 1, 2018 · pp. 20–26 Read article
-
A Review on Reliability Modeling, Performance and Cost-benefit Analysis of Optical Fiber Network in DCRUST
Abstract: AbstractThis paper includes the survey of optical fiber network layer in the Deenbandhu Chhotu Ram University of Science and Technology (DCRUST) and its reliability modeling aspects to evaluate reliability of that optical fiber network. To find out reliability is important part of a system is important to know its period of working, failure rates and cost benefit analysis. Optical fiber which are buried are significantly more vulnerable to human related …
Published in Journal of Semiconductor Devices and Circuits · Vol. 7, Issue 1, 2020 · pp. 8–13 Read article
-
Design And Validation of High Efficiency Of 10T Sram with High Recoverability Of Multi Node Soft Error
Abstract: Sensitive nodes' critical charge is decreasing, which increases the soft-error vulnerability of SRAM cells used in aerospace applications. A single event upset (SEU) occurs when a radiation particle hits a sensitive node in a typical 6T SRAM cell, flipping the data that has been stored in the cell. Consequently, a Soft-Error-Aware Read-Stability-Enhanced Low Power 10T (SARP10T) SRAM cell is suggested in this project to reduce SEUs. The quadro cell exhibits …
Published in Journal of Semiconductor Devices and Circuits · Vol. 10, Issue 2, 2024 · pp. 7–14 Read article
-
Effect of Viscoelastic Dampers on Progressive Collapse Resistance of RC Building
Abstract: Natural as well as man-made hazards may cause the failure of the primary load bearing members of buildings. The spread of an initial local failure from element to element, eventually result into the collapse of an entire structure or a large part of it, which is known as Progressive Collapse. Progressive collapse initiates when one or more primary load bearing elements get fails causing failure of the entire structure. It …
Published in Journal of Structural Engineering and Management · Vol. 4, Issue 1, 2017 · pp. 27–34 Read article
-
Compressive Strength of SCC Increased by Use of HD-Glass Fiber and Glass Fiber
Abstract: Self-Compacting Concrete (SCC) is a concrete that has been specifically designed for use in situations where access from below is impossible. It is able to flow when the weight of its own body is applied. When encountering extensive reinforcement and intricate structural designs, it may be utilised. Segregation and bleeding issues are ignored, and compaction does not require vibration. Concrete has a strong compression strength and a weak tension strength. …
Published in Journal of Structural Engineering and Management · Vol. 9, Issue 3, 2022 · pp. 34–41 Read article
-
Effects of Carbon Fiber on Strength of Concrete
Abstract: Experimental investigations were carried out to evaluate the effect of carbon fibers on strength of concrete. The concrete mix of M-25 grade was considered and produced by replacing carbon fibers with cement. Modified concrete is produced by adding carbon fibers with various percentages as 0 to 0.6% at an interval of 0.2% with 10 and 20 mm in length. The compressive and flexural strengths are considered for investigations. Cube of …
Published in Journal of Thin Films, Coating Science Technology & Application · Vol. 3, Issue 3, 2016 · pp. 1–8 Read article
-
Optimization Study by Response Surface Methodology and Artificial Neural Network on the Culture Parameters of Citric Acid Bioproduction from Sweet Potato Peels
Abstract: In the cause of this research work, two steps enzymatic hydrolysis of sweet potato peel was carried out respectively. The effect of α-amylase dose, reaction time, and reaction temperature and biomass weight on glucose concentration was investigated carefully. The response surface methodology (REM) predicted the highest reducing sugar concentration at liquefaction to be 74 g/L, at the following optimized conditions; temperature of 45°C, α-amylase dose 0.7 %v/v, biomass weight 22.345 …
Published in Journal of Thin Films, Coating Science Technology & Application · Vol. 9, Issue 1, 2022 · pp. 30–38 Read article
-
Studies on Removal of Coomassie Brilliant Blue R250(CBB) dye Usingligninas Adsorbent
Abstract: Coomassie brilliant blue R-250 (CBB), an organic dye present in wastewater effluent, affects environment by reducing the photosynthetic activity in aquatic ecosystems. CBB must be eliminated from effluent as a result. In the present study, lignin was utilized as a low-cost bio adsorbent for the removal of CBB dye employing an adsorption technique in order to minimize pollution caused by CBB dye. By studying the effect of several parameters includes …
Published in Journal of Thin Films, Coating Science Technology & Application · Vol. 9, Issue 3, 2022 · pp. 9–19 Read article
-
A High Performance Reference Circuit with Optimized Input Offset Operational Amplifier using Device Mismatch Model
Abstract: In this paper, author describes a band gap reference (BGR) circuit, having reference voltage 1.20V with maximum temperature coefficient of 63 ppm/0C in temperature range of –40 to 120 0C. The circuit operates in range of supply voltage, 3.0V to 3.6V. An operational amplifier (op-amp), whose input offset voltage is reduced upto 892 µV using Pelgrom’s device mismatch model is used in BGR. The power supply rejection ratio of circuit …
Published in Journal of VLSI Design Tools and Technology · Vol. 3, Issue 1, 2013 · pp. 1–7 Read article
-
Reconfiguring CMOS Driver and Receiver Pair as Pseudo NMOS for Low-swing Signaling On-chip Interconnects
Abstract: The Low power bus architecture [9, 12, 13] consists of Driver, Receiver and Interconnects in between them inside the Chip. The Low power bus architecture [1] models are classified in to Symmetric and Asymmetric [7, 11, 14, 15] based on low voltage scaling technique and very simple design principles were utilized to construct driver, receiver and interconnects. The low power bus driver has the ability to switch from a low …
Published in Journal of VLSI Design Tools and Technology · Vol. 3, Issue 1, 2013 · pp. 20–27 Read article
-
Design and Implementation of Low Power 8-bit Level Crossing ADC
Abstract: Implantable medical devices, electronic gadgets, wireless communication elements and many other such applications require low power electronic circuits. Analog to digital converters are essential part of most of such circuits. This paper presents a design of the level crossing analog to digital converter (LC-ADC) architecture. The proposed circuit and layout has been implemented in semi-conductor laboratory (SCL) 180 nm technology and its performance was evaluated using cadence virtuoso at supply …
Published in Journal of VLSI Design Tools and Technology · Vol. 6, Issue 2, 2016 · pp. 33–43 Read article
-
Design and RTL Implementation for AHB-APB Bridge on SoC
Abstract: The focus of this research is to design and implement an interconnection protocol with 32-bit read/write data which operates on AMBA AHB-APB bridge. With the advent of scaling technology, embedded system focuses more on low-power dissipation and SoCs. Hence processors and routing protocols which focus on low-power design by ARM have gained popularity. In high-speed communication modules, the protocol works efficiently but has limitations with device operating at low speed. …
Published in Journal of VLSI Design Tools and Technology · Vol. 6, Issue 2, 2016 · pp. 44–52 Read article
-
Hydrogenomonas Transport in Lateritic and Silty Formation Influenced by Heterogeneous Velocity Applying Numerical Simulation
Abstract: Hydrogenomonas in lateritic and silty formation influenced by velocity were monitored to predict its rate of migration and its level of variation in concentration. The study examined various conditions observed in the migration level in these two formations. Velocity variation were based on its rate of deposition between the litho structure in study area., The derived solution generated simulation values that express their various concentrations which range from 0.0024 -0.0771, …
Published in Journal of Water Resource Engineering and Management · Vol. 5, Issue 1, 2018 · pp. 25–32 Read article
-
Climate Change and Water Flow Relationship: Shigar Basin Pakistan
Abstract: Glacier melting leading to its fluctuation, in one way indicates change in the climate whereas in another way poses water resource management problems for the policy makers and disaster managers. Pakistan is drained by Indus River, whose upper basin runs across Hindukash-Karakorum-Himalayan Range which houses the largest cryosphere after both the poles. From hydro-climatological data for period from 1985 to 1997, the analysis show very weak relationship between precipitation and …
Published in Journal of Water Resource Engineering and Management · Vol. 2, Issue 1, 2015 · pp. 22–37 Read article
-
Examining the Influence of DEM Resolution in Flood Hazard Assessment using the Flood Modeller Pro 2D Solver
Abstract: Floods are the most frequent natural hazards that threat the human life, environment and infrastructure. The flood prediction models that have wide use in the recent years represent important tools for flood management decisions aiming to mitigate the impacts of the flood events. The accuracy of the constructed prediction models is based on the quality of the primary data, such as the terrain’s resolution. This study examines the effect of …
Published in Journal of Water Resource Engineering and Management · Vol. 4, Issue 1, 2017 · pp. 14–24 Read article
-
Damage Assessment in Reinforced Concrete Structures
Abstract: Reinforced concrete structures are subjected to a pattern of loading in addition to deterioration with age during their service life, which lead to damage of the structure. Damage assessment is an integral part of structural health monitoring (SHM) which aims to detect, locate and quantify the damage as well as predict the remaining service ability of the structure. Damage assessment technique can be classified into either global or local methods. …
Published in Recent Trends in Civil Engineering & Technology · Vol. 6, Issue 1, 2016 · pp. 29–35 Read article
-
Studies on Effect of Various Curing Methods in Glass Fibre Reinforced Geopolymer Concrete with 12 Molarity Alkaline Solutions
Abstract: Due to the increasing environmental impacts associated with ordinary Portland cement, need to develop alternative binders to make concrete, is steadily increasing. Geopolymer concrete is the result of the reaction of materials containing Alumino-silicate with concentrated alkaline solution to produce an inorganic polymer binder. Alkaline solutions used were Sodium Hydroxide and Sodium Silicate. This paper presents results of an experimental study on the compressive strength, flexural strength and split tensile …
Published in Recent Trends in Civil Engineering & Technology · Vol. 5, Issue 2, 2015 · pp. 1–7 Read article
-
Study of Mechanical Properties of Self-compacting Concrete
Abstract: Self-Compacting Concrete (SCC) is a high performance concrete, it is able to flow under its own weight, completely filling formwork and achieving full compaction, even in the presence of congested reinforcement. Self Compacting Concrete has excellent high resistance to segregation and fluidity ensures a high level of homogeneity, minimal concrete voids and uniform concrete strength, providing the potential for a superior level of finish and durability to the structure. This …
Published in Recent Trends in Civil Engineering & Technology · Vol. 5, Issue 1, 2015 · pp. 12–18 Read article