Search
5 articles for “Aluminium compaction”
-
ASSESSMENT OF MECHANICAL PROPERTIES OF ALUMINIUM WITH FLY ASH REINFORCMENT
Abstract: There is always a demand for lighter but with high strength materials in many industrialapplications including automobile and aerospace industries. Reinforced aluminiumAluminium has been used for these applications for many years. Researchers worked out witha variety of reinforcements. In the present paper, use of fly ash is investigated by usingpowder metallurgy technique. Fly ash composition can raise up to hardness, and density,corrosion & wear rate can also be reduced. According …
Published in Journal of Experimental & Applied Mechanics · Vol. 14, Issue 1, 2023 · pp. 18–22 Read article
-
Development of Graphene Based Super Strong and Thermal Resistant High Nano Composite Materials
Abstract: The main goals of the research is to present the investigation in graphene based super strong and thermal resistant nano composite material and study their structural and mechanical properties after intensive severe plastic deformation. It is observed that the mechanical properties of graphene based super strong Nano composite materials show an intensive severe plastic deformation as accumulative roll bonding process was changed. Severe plastic deformation refined grains in the aluminium …
Published in Journal of Materials & Metallurgical Engineering · Vol. 10, Issue 2, 2020 · pp. 9–14 Read article
-
Effect of Ni Addition on the Hardness and Tensile Strength of Al – Cu Alloy Prepared by Powder Metallurgy Technique
Abstract: Aluminium alloys are becoming potential engineering materials offering excellent combination of properties such as high specific strength, high specific stiffness, electrical and thermal conductivities, low coefficient of thermal expansion and wear resistance. Generally, copper and nickel were used as alloying elements in aluminium alloy to increase high temperature strength.Both powder metallurgy as well as casting techniques is used to produce Al-Cu-Ni alloys.However, P/M technique is better suited for preparing this …
Published in Journal of Experimental & Applied Mechanics · Vol. 9, Issue 3, 2018 · pp. 19–23 Read article
-
Boron Nitride Nanoplatelets and Aluminium Nitride Incorporated Organic Organic Eutectic Phase Change Materials with Enhanced Thermal Conductivity with Low-Loading Nanoadditives
Abstract: Miniaturized high performance electronic appliances generate tremendous heat during the duty cycle, has led research community to explore advanced thermal management strategies. Operating electronics at high temperature may result in malfunctioning of compact appliances. Thus, phase change materials (PCM) are applied to maintain isothermal temperature by implementing phase transition through latent heat. To improve the thermal conductivity and to deduce at suitable phase transition temperature of novel eutectic PCM, nanoplatelets …
Published in Journal of Polymer & Composites · Vol. 12, Issue 2, 2024 · pp. 1–9 Read article
-
Deformation and Densification Behaviour of Sintered Aluminium Alloy and Chromium Carbide Metal Matrix Preforms
Abstract: This paper presents comprehensive experimental results focused on the deformation and densification behavior of sintered AA2618 - 2% Cr3C2 metal matrix preforms. The study specifically examines preforms with varying aspect ratios subjected to a cold upsetting process. To create the powder preforms, an initial theoretical density of 89% was achieved using a cylindrical die on a 600 kN hydraulic press. The sintering process was conducted in an electric muffle furnace, …
Published in Journal of Polymer & Composites · Vol. 13, Issue 1, 2025 · pp. 125–131 Read article