Journal of Electronic Design Technology
Volume 9, Issue 2 (2018)
Published
Table of contents
-
Stability Analysis in SRAM Cell for Deep Submicron Design
Abstract: AbstractMemory is an integral part of present day battery operated and hand held electronic gadgets. As the size of devices shrinks so does the size of memory used in these devices also, this increases the demand for low power devices. Leakage current is one of the prominent factors that contribute to significant portion of the total power dissipation; in fact at lower technologies it becomes comparable to switching component. Device …
Published in Journal of Electronic Design Technology · Vol. 9, Issue 2, 2018 · pp. 1–6 Read article
-
Design of Photonic Sensor for Driver Assistance
Abstract: AbstractA report from National Highway Traffic Safety Association, USA, states that 100000 police reported crashes are a result of driver fatigue. This figure would be quite mind boggling for developing nations, where work periods are usually extended without conducting detailed scrutiny. Sophisticated vehicles are equipped with sensors for assisting drivers and providing them with time-critical accident alerts. However, there is a need to develop cheap and reliable sensors for 24x7 …
Published in Journal of Electronic Design Technology · Vol. 9, Issue 2, 2018 · pp. 14–23 Read article
-
Preparation of Fe/Ti/Al Nano-particles and Mixed Nano-composites from Aluminium Industrial Wastes
Abstract: AbstractIndian alumina refineries produce over 6 million tonnes of alumina generating about 9 million tonnes of bauxite residue commonly (known as red mud) per annum, typically containing 50–60% Fe2O3, 15–20% Al2O3 and 3–5% SiO2, TiO2 and Na2O. Efforts have been made to synthesize nano-particles (Fe/Al/Ti) and nano-composites (Al-Fe-Ti/Al-Fe/Al-Ti) using red mud for chemical precipitation and mechanical milling. XRF was used to check the chemical composition of red mud processed at …
Published in Journal of Electronic Design Technology · Vol. 9, Issue 2, 2018 · pp. 24–29 Read article
-
Optimization of a Digital Adder Design Using MOSFET and FinFET Technology
Abstract: AbstractIn this study, a very low power high speed Adder is presented by using short gate mode technique and voltage scaling system for FinFET. MOSFET and FinFET technique is used on 32 nm by adders which compare delay and average power. Parametric study of fins vs. power is also performed in the study. Synopsys HSPICE software is used for obtaining the simulation results. Simulation results show that low power is …
Published in Journal of Electronic Design Technology · Vol. 9, Issue 2, 2018 · pp. 30–33 Read article
-
Comparative Analysis of Perturb & Observe and Incremental & Conductance MPPT Algorithms
Abstract: AbstractMaximum power point tracking (MPPT) technique implemented on a Photo-Voltaic (PV) system is meant for increasing its efficiency. In literature may research work claims MPPT technique as one of the most efficient way in enhancing output power generated. The output electrical parameters (V-I curve) of PV (photovoltaic) system depends on the irradiance, temperature, configuration, environmental conditions and analogy of a PV system. MPPT regulates the system at the reference voltage …
Published in Journal of Electronic Design Technology · Vol. 9, Issue 2, 2018 · pp. 7–13 Read article