Journal of Electronic Design Technology
Study and Modelling of Id Allocation Scheme for Controller Area Network
Abstract
Diverse Bus standards are employed in dedicated application field considering the required safety level, data rate and costs. The Controller Area Network is a widely used communication protocol used in automotives. CAN is mostly used in real time safety critical system where the performance of communication is significant. Performance analysis of the CAN is very important and can be done either using hardware or software, using hardware is costly and time consuming. Analysis of performance using software is relatively easy and saves lot of time. This research aims in designing or modelling a bus and block for CAN for analyzing the performance of the CAN bus using the MATLAB® simulink and also compare CAN bus configurations with other dominating bus systems such as FlexRay which is presently used in automotive industry. Keywords: Controller Area Network (CAN), FlexRay, Modelling, MATLAB® , Simulink, Protocol.References (12)
- Khanwar M . Zuberi, Kang G . Shin. “Scheduling Messages on Controller Area Network for Real Time CIM Applications”. Available at: 16/02/2012.
- K. Tindell, A. Burns, A Wellings . “Calculating CAN Message Response Times.”
- “Robert Bosch CAN Specifications ”. Available at link: http://esd.cs.ucr.edu/webres/can20.pdf on 17/02/2012.
- J. Froberg, K. Sandstrom, C. Norstrom, et al. In: Handbook on Information Technology in Industrial Automation . IEEE Press. CRC Press. 2004. Journal of Electronic Design Technology Volume 3, Issue 1-3, Compilation __________________________________________________________________________ ________________ ISSN: 2229–6980© STM Journals 2012. All Rights Reserved Page 78
- Hui Shao . “Design of Simulation Framework for Automotive Network using System C”. Available at: http://www.vlsi.informatik.tu.darmstadt.de /staff/madlener/student_works/shao_diplo marbeit.pdf on 15/02/2012.
- Dominique Paret “ Multiplexed networks for Embedded Syatems ”. John Willey & Sons Ltd. ISBN: 978-0-47-003-416-3.
- S. Ouni and F. Kamoun . “An Efficient Protocol for Hard Real -time Communication on Controller Area Network,” in Proc. 6th Int. CAN Conf.’99. 1999. 4–16p.
- Michael Short and Michael J. Pont, Member, IEEE. Fault -Tolerant Time - Triggered Communication Using CAN. IEEE Transactions On Industrial Informatics. Vol. 3 (2). 131–142p. 2007.
- I. Broster , A. Burns . “Timely use of the CAN protocol in critical hard real -time systems with faults,” in Proc. 13th Euromicro Conf. R eal-Time Systems (ECRTS 2001) . Delft The Netherlands . Jun. 13–15, 2001. 95–102p.
- Jakob Axelsson, Joakim Fröberg, Hans Hansson, et al. A Comparative Case Study of Distributed Network Architectures for Different Automotive Applications . Technical Report, No 478 MRTC, 2003 - 01-28 [Online]. Available at: http://www.mrtc.mdh.se/publications/0478 .pdf
- T. Nolte, M. Nolin, and H. A. Hansson . “Real-time server -based communication with CAN” . IEEE Trans. Ind. Informat. Vol. 1 (3). 192–201p. 2005.
- FlexRay. FlexRay Communication System Protocol Specification Version 2.0 . FlexRay Consortium. 2004.