Journal of Electronic Design Technology
A Suboptimal Nonlinear Duty-cycle Modulation Scheme
Abstract
The DCM (duty-cycle modulation) technique is increasingly used in industrial electronics applications, including instrumentation systems, interfacing drivers and signal transmission chains. However, in existing research works related to new applications of DCM technique, the linear approximation policy is used for the sake of structural simplicity and low implementation cost, at the expends of rigorous analysis and low approximation errors. In this paper, a suboptimal nonlinear DCM scheme is developed. It is founded on a global least square cubic fitting model of the intractable original nonlinear duty-cycle structure. The simpler nonlinear demodulation model obtained consists of a single linear low-pass filter, which is connected in series to a static amplifier with cubic input-output characteristic. The novelty of this paper results from a suboptimal tradeoff, between a simplified model of the DCM scheme and the mean square approximation error. The virtual simulation results obtained under a variety of modulating inputs with arbitrary waveforms have shown the effectiveness of the proposed suboptimal DCM architecture. Compared to a linear approximation technique, the suboptimal cubic scheme provides higher performances, including SSE (statistics sum of error), MSE (mean square error), THD (total harmonics distortions), SINAD (signal-to-noise distortion ratio), and SFDR (spurious free dynamic range). Therefore, the proposed suboptimal DCM architecture might be used to solve a variety of signal processing problems in industrial electronics.References (20)
- Roza E. Analog –to–Digital Conversion via Duty–Cycle Modulation. IEEE Trans . Circuits Syst. II: Analog Digital Signal Process. 1997; 44(11):907–914p.
- Hiorns R.E, Bowman R.G., Sandler M.B. A PWM DAC for Digit al Audio Power Conversion: From theory to performance. Paper presented at: Int. Conf. Analogue Digital Analogue Convers. Wales.1991 :142–147p.
- Cheung R.C., Pun K.P., Yuen S.C., et al. An FPGA –based re –configurable sigma – delta audio DAC. Paper presented at Proc. IEEE Int. Conf. FPT, 24–bit Tokyo, Japan, 2003;15–17:110–117p. Nonlinear Duty-cycle Modulation Mbihi et al. JoEDT (2016) 22-31 © STM Journals 2016. All Rights Reserved Page 31
- Kulka Z., Lewandowski M. An FPGA Based Sigma–Delta Dac . Paper presented at Proc. SPA, Archit., Arrangements, and Appl. Poznan, Poland , September 2008:39–42p.
- Hiorns R. E., Bowman R. G., Sandler M. B. A PWM Dac for Digital Audio Power Conversion: From Theory To Performance. Paper presented at Int. Conf. Analogue Digital Analogue Convers. , Swansea, Wales, Sep. 1991: 142–147p.
- Prodic A., Maksimovic D., Erickson R. W., Design and Implementatio n Of A Digital Pwm Controller For A High Frequency Switching DC –DC Power Converter. Paper presented at Proc. 27th Ann. Conf. IEEE Ind. Electron , 2001: 893–898p.
- Mbihi J, Ndja li B., Mbouenda M. Modeling and Simulation of a Class of Duty–Cycle Modulators for Industrial Instrumentation. Iranian Journal of Electrical and Computer Engineering. 2005; 4(2):121–128p.
- Mbihi JE., Motto AL., Informatique industrielle – Instrumentation virtuelle assistée par ordinateur : Prin cipes et techniques, cours et exercices . Paris, France, © Editions Ellipses; 2012 : 240p.
- Mbihi J., Ndjali B., Kom M., Léandre Nneme Nneme L. A Novel Analog –to– Digital Conversion Technique using Nonlinear Duty -Cycle Modulation . International Journal of Electronics and Computer Science Engineering . 2012; 1(3) :818–825p.
- Mbihi J., Nneme Nneme L., A Multi - Channel Analog -To-Digital Conversion Technique Using Parallel Duty -Cycle Modulation. International Journal of Electronics and Computer Science Engineering. 2012; 1(3):826–833p.
- Sabarinath V., Sivandan K. Design and Implementation of FPGA based High Resolution Digital Pulse Width Modulation. Int. J. Adv. Res Electron. Commun. Eng. 2013; 2(5):563–567p.
- Moffo Lonla B. , Mbihi J., Nneme Nneme L., Kom M., A Novel Digital–to–Analog Conversion Technique using Duty-Cycle Modulation. International Journal of Circuits, Systems and Signal processing . 2013; 7(1):42–49p.
- Moffo Lonla B., Mbihi J. A Novel Digital Duty–Cycle Modulation Scheme for FPGA-Based Di gital-to-Analog Conversion. IEEE Transaction on circuits and system II. 2015; 62(6):543–547p.
- Nneme Nneme L., Mbihi J., Modeling and Simulation of a New Duty –Cycle Modulation Scheme for Signal Transmission System , American Journal of Electrical and Electronic Engineering (AJEEE).2014;2(3):82–87p.
- Moffo Lonla B. , Jean M bihi, Leandre Nneme Nneme. A Low Cost and High Quality Duty –Cycle Modulation Scheme and Applications. International Journal of Electrical, Electronic Science and Engineering. 2014; 8(3):82–88p.
- Mbihi J., Nneme Nneme L., A Novel Control Scheme for Buc k Power Converters using Duty–Cycle Modulation. International Journal of Power Electronics. 2013;5(3/4):185–199p.
- Madanayake, A. Cintra, R.J., Dimitrov V., et al. Low–Power VLSI Architectures for DCT/DWT: Precision vs Approximation for HD Video, Biomedica l, and Smart Antenna Application. IEEE Circuits and Systems Magazine. 2015; 15(1):25–47p.
- Galias Z. The Dangers of Rounding Errors for Simulations and Analysis of Nonlinear Circuits and Systems? and How to Avoid Them. IEEE circuits and systems magazine. 2013; 13(3): 35–52p.
- Marek B., Maciej S. Variable Fractional Delay Filter Design Using a Symmetric Window, Circuits Systems and Signal Processing. 2014; 33:3223–3250p.
- Analog Devices . Low cost analog multiplier AD633A – Using manual. Rev. B.1–8p, Analog Devices, USA. Cite this Article Jean Mbihi, Charles Hubert Kom, Léandre Nneme Nneme . A Suboptimal Nonlinear Duty -cycle Modulation Scheme. Journal of Electronic Design and Technology. 2016; 7(1): 22–31p.