EDS
3 articles · search the full text for this term
-
Catalyst-Driven Degradation and Failure Analysis of Intergranular Cracking in 316H Studded Pipes under Refinery Heat Recovery Conditions
Abstract: A failure analysis investigation was carried out on a high-temperature studded pipe used in a convection module for heat recovery in an oil and gas refinery application after leakage was detected during pre-commissioning hydrotesting. The investigated pipe was manufactured from AISI 316H austenitic stainless steel, and carbon steel studs had been joined to its outer surface by high-frequency resistance welding. Two leaks were reported in the pipe under investigation, and …
Published in Journal of Catalyst & Catalysis · Vol. 13, Issue 1, 2026 Read article
-
Composite Fabrication by Stir-Cast for Al C355.0 With Particulates Hematite Reinforcements at Different Weight Percentages in Copper Chills with and Without Water Circulation for Mechanical and Fatigue Performance
Abstract: This study investigates the fabrication of aluminum matrix composites using the stir casting method to analyze the mechanical characterization and fatigue behavior of Al C355.0 composites reinforced with varying weight percentages of hematite particulates. The hematite content was systematically adjusted from 0 wt. % to 12 wt. % in 3 wt. % increments, with the presence of constituent elements confirmed through Energy Dispersive Spectroscopy (EDS). The incorporation of hematite reinforcement …
Published in Journal of Polymer & Composites · Vol. 13, Issue 3, 2025 · pp. 324–336 Read article
-
Experimental Study on the Wear Mechanisms of Cutting Tools in High-Performance Machining
Abstract: Because high-performance machining (HPM) may increase output and improve product quality, it is essential for modern production. The quick wear of cutting tools under high-stress circumstances, however, presents serious difficulties that affect surface smoothness, tool life, and cost-effectiveness. Through an analysis of the impacts of cutting speed, feed rate, tool material, and cooling techniques, this work explores the wear processes impacting cutting tools in HPM. Advanced spectroscopy and microscopy procedures …
Published in International Journal of Fracture Mechanics and Damage Science · Vol. 2, Issue 1, 2024 · pp. 9–14 Read article