Dry machining
3 articles · search the full text for this term
-
A review on Methodology used for Dry Turning of AISI 52100 Steel
Abstract: Bearing steel like AISI 52100 is one of the most widely used high cutting steel in industry for manufacturing of bearing. A large amount of coolant is used for machining at high speed due to which increase there has been a significant increase in environmental hazards. So Green or Dry manufacturing with optimize cutting parameters and its effect on tool material & work piece quality need to be studied to …
Published in Journal of Polymer & Composites · Vol. 13, Special Issue 6, 2025 · pp. 467–475 Read article
-
Enhancing Cooling Efficiency in Dual Nozzle CO2-Based Vortex Tube Systems for Machining Titanium Alloys: Implications for Polymer and Composite Processing
Abstract: In machining of Titanium alloys, the cutting temperature plays a vital role that directly influences the performance and it is required to maintain as low as possible. In this study, a dual nozzle Vortex Tube Cooling System (VTCS) that supplies cool compressed CO2 gas is developed to reduce the cutting temperature in Ti-6Al-4V machining. The experiments were conducted at constant cutting and flow parameters during turning at different levels of …
Published in Journal of Polymer & Composites · Vol. 12, Special Issue 5, 2024 · pp. 284–291 Read article
-
Analysis of Surface Roughness and Material Removal Rate in Engine Valve Turning Operation of Material SUH3
Abstract: The purpose of this paper is to present an experimental work attempting to optimize the influencingprocess parameters involved in dry machining of the exhaust engine valve of material martensiticstainless steel grade SUH3. Looking at available literature it is observed that a lot of work can be donein the field dry machining related to surface integrity but no work can be reported on investigationimplementation of dry machining in engine valve manufacturing …
Published in Journal of Automobile Engineering and Applications · Vol. 8, Issue 1, 2021 · pp. 17–22 Read article