Trends in Opto-electro & Optical Communication

Evaluation of Surface Replication of Injection Molded Products Using a Diffraction Method

  1. Toshimitsu Takaoka ✉
  2. Takuya Ueno
  3. Hiroshi Owari
  4. Hiroshi Ito

Abstract

ABSTRACT An evaluation method of surface replication for molded parts, which utilizes optical diffraction phenomena, is proposed. In general, the intensity of the diffracted light increases as the replication ratio becomes large, which leads to the increase in directly transmitted light. As a result, the surface in highly replicated region appears to be darker compared with the other region. An inversely proportional relationship between the 0th-order diffraction efficiency and the grating height is observed. It is shown that the replication ratio and uniformity can be easily evaluated simply by naked eye. The effect of injection speed and cavity thickness on the replication ratio and its uniformity are examined. Our experiments show that higher injection speed yields better replication ratio. However, in the case of cavity thickness of 1 mm, the higher injection speed makes the uniformity of surface replication worse. The better uniformity is achieved when the cavity thickness is 0.3 mm, which is because the inclination angle between the melt flow front and the orientation of the grating grooves are set to be small and the cavity pressure of the filling stage is high. Those conditions are strongly dependent on the ratio of gate thickness to that of the cavity.Keywords: injection molding, diffraction, SWS, replication, optics, evaluation

References (10)

  1. Kikuta H. et al. Optical Review . 2003. 10(2). 63p.
  2. Yokoi H. et al. Polymer Engineering & Science. 2006. 46. 1140p.
  3. Sato A. et al. Polymer Engineering & Science. 2009. 49(4). 768p.
  4. Kayano Y. et al. International Polymer Processing. 2011. 03. 304p.
  5. Lin H. et al. International Communications in Heat and Mass Transfer . 2010. 37. 1477p.
  6. Chen S. C. et al. Journal of Micromechanics and Microengineering. 2006. 16. 1783p.
  7. Ito H. et al. ANTEC, Tech Papers . 2005.
  8. Moharam M. G. et al. Journal of the Optical Society of America A. 1995. 12(5). 1077p.
  9. Han X. and Yokoi H. Polymer Engineering and Science. 2006. 46(11). 1590p.
  10. Yokoi H. et al. Polymer Processing Engineering 01. Bradford UK. 2001. 2p.

Read more of it

Subscribe to one journal or build your own list of several. One invoice, one payment, access for a full year.

Subscribe to journals →

Publish your article

Peer-reviewed journals across every subject, with open access options. Send your manuscript to the right editor today.

Publish with us → Calculate your APC
Support