Search
3 articles for “airgap”
-
Short Circuit MAG/MIG Welding and Fast ROOT Modified Short arc Welding Process for Sheet Metals Welding with Diverse Air Gap
Abstract: The outcome of an analysis allocating with welding of sheet metals with diverse air gap using short circuit MAG welding process and Fast ROOT custom-made short arc welding methods have been presented. Welding turns were made below different conditions and through each run; the diverse process parameters were incessantly observed. It was found that fewer HAZ and maximum welding speed are reached under an exact welding condition with quick ROOT …
Published in Journal of Materials & Metallurgical Engineering · Vol. 6, Issue 1, 2016 · pp. 47–59 Read article
-
Design And Fabrication of Contactless Magnetic Gears
Abstract: Modern engineering prioritizes speed, efficiency, and reliability, spurring innovations like contactless magnetic gear systems that transmit torque through interacting magnetic fields from permanent magnets, eliminating physical contact to drastically cut friction, backlash, wear, lubrication needs, and heat—operating silently with minimal vibration and peak efficiencies up to 99% under ideal conditions, outperforming traditional gears in low-speed, high-torque direct-drive applications such as motors. The design centers on two rotors: an outer high-speed …
Published in Trends in Mechanical Engineering & Technology · Vol. 16, Issue 2, 2026 · pp. 42–49 Read article
-
Design and Fabrication of Double-sided Linear Induction Motor
Abstract: Nowadays for application like high-speed ground transportation and specific industrial application including transportation, conveyer system, actuator, material handling, etc. there is need to develop in linear induction motor. These applications require machines that can produce large forces, operate at high speeds, and can be controlled precisely to meet performance requirements. In this project, the working principle of Double-sided linear induction motor (DSLIM) is same as rotational induction motor, but the …
Published in Trends in Machine design · Vol. 7, Issue 3, 2020 · pp. 1–4 Read article