Search
6 articles for “Oil based drilling mud”
-
SYNTHESIS OF LOCAL OIL-BASED MUD FOR NIGER DELTA WELLS USING ELAEIS GUINEENSIS
Abstract: Abstract Edible oil is produced from palm kernel (Elaeis Guineensis), a widespread tropical fruit that has a specific gravity of approximately 0.9°C, a flash point of 242°C, a flash point of 251°C, and a pour point of 22°C. This experiment was conducted by replacing liquid paraffin oil, a known component of conventional oil-based mud, with palm kernel oil (PKO) in the synthesis of a new oil-based mud from local materials. …
Published in Journal of Petroleum Engineering & Technology · Vol. 13, Issue 2, 2023 · pp. 1–12 Read article
-
Kick Tolerance Modeling in Well Design and Drilling: A Comprehensive Technical Review
Abstract: Kick and blowout events in drilling operations can lead to significant losses of equipment, and in some cases, human lives. Oil and gas companies, along with oilfield service providers involved in drilling operations, face severe penalties and sanctions following such incidents. Research has demonstrated that incorporating kick tolerance models during the well planning and drilling stages can mitigate the risk of blowouts during secondary well control operations. This study reviews …
Published in Journal of Petroleum Engineering & Technology · Vol. 15, Issue 3, 2025 · pp. 33–58 Read article
-
Utilization of Egg Yolk as A Non-Toxic Emulsifier in Environmentally Friendly Invert Emulsion Drilling Mud
Abstract: Vegetable oil such as Jatropha has been shown to be a comparable alternative to diesel and mineral oils for environmentally friendly oil based drilling mud. However compatibility of the vegetable oils with the usual chemical additives is still a major challenge that calls for compatible and non-toxic substitutes. This study examined the suitability of hen egg yolk as a non-toxic emulsifier in invert emulsion drilling mud using vegetable oil continuous …
Published in Journal of Petroleum Engineering & Technology · Vol. 6, Issue 1, 2016 · pp. 41–49 Read article
-
Drilling Fluid Characterization (Filtration Test)
Abstract: This report explores the formulation and testing of a water-based drilling mud used in drilling operations, where fluid circulates through the drillstring and returns to the surface. The study mixes 315 ml of water with 35 ml of corn oil to create the drilling mud and investigates the role of barite in increasing mud density to maintain a hydrostatic pressure capable of managing formation pressure. The findings reveal that increasing …
Published in Journal of Petroleum Engineering & Technology · Vol. 14, Issue 2, 2024 · pp. 17–26 Read article
-
A Ponder & Sedulousness Of Legion Shale Stabilizing Materials In Aqueous Based Drilling Fluid During The Process Of Borehole Strengthening
Abstract: Drilling fluid used while drilling the layers of shale will have the potential of reacting with water which tends to increase stickiness, induce swelling and promote sloughing of the borehole. This results in the reduction of drilling fluid circulation, increased mud loss, increase in torque and drag, reduction in lubricity. This will ultimately result in the increase of Non-Productive Time (NPT) during drilling which in turn increases Capital Expenditure (CAPEX) …
Published in International Journal of Pollution: Prevention & Control · Vol. 1, Issue 2, 2023 · pp. 35–40 Read article
-
Estimation of Dulling Rate and Bit Tooth Wear Using Drilling Parameters and Rock Abrasiveness
Abstract: Optimisation of the drilling operations is becoming increasingly important as it can significantly reduce the oil well development cost. One of the major objectives in oil well drilling is to increase the penetration rate by selecting the optimum drilling bit based on offset wells data, and adjust the drilling factors to keep the bit in good condition during the operation. At the same time it is important to predict the …
Published in Journal of Petroleum Engineering & Technology · Vol. 9, Issue 3, 2019 · pp. 1–20 Read article