Search
1570 articles for “Point”
-
Modelling of Grid Tied 3-Level Diode Clamped Inverter Using Sinusoidal PWM for Solar Application
Abstract: AbstractIn this paper the AC Loads are fed from solar energy by means of Three-level Diode Clamped Inverter. The entire system is three phase supply system. To make the system more efficient Maximum Power Point Tracking (MPPT) is used. The Perturb & Observe method is used to obtain voltage at maximum power. In this work Sinusoidal Pulse Width Modulation (SPWM) technique is implemented to generate gate pulses to make the …
Published in Journal of Power Electronics and Power Systems · Vol. 5, Issue 3, 2015 · pp. 9–16 Read article
-
Modeling and Control of A Grid Connected Wind Turbine Power System Under Variable Wind Speeds Using Doubly-Fed Induction Machine
Abstract: This paper focuses on the development of wind turbine system and extracting maximum power for variable speed constant frequency grid connected wind turbine power system with doubly fed induction generator. A voltage oriented control scheme is used for the control of both rotor side and grid side circuit. Pitch control mechanism is implemented for the power limitation at a wind speed greater than the rated speed. The DFIM stator side …
Published in Journal of Power Electronics and Power Systems · Vol. 5, Issue 3, 2015 · pp. 108–124 Read article
-
Real Time Stability Index for Angle Stability Assessment Using Synchrophasor Data
Abstract: The stress on the power transmission network has been increasing in recent time due to deregulated energy market, environmental constraints and limited investment in the transmission system. Hence, the power system is enforced to operate nearer to the stability limit and due to which it is required to estimate the system operating point as fast as possible with higher accuracy to maintain the system stability. The objective of this paper …
Published in Journal of Power Electronics and Power Systems · Vol. 5, Issue 3, 2015 · pp. 65–75 Read article
-
Genetic Algorithm Based Optimal Volt/Var Control of Distribution Systems with Distributed Generation
Abstract: In this paper, new voltage regulation algorithms have been proposed for Distribution System (DS) equippedwith Distributed Generation (DG). Due to the ever increasing power demand, the power system sector isfacing too many challenges to fulfill that demand and also to supply power with proper acceptable quality.Distributed generation is one of the most efficient solutions to meet the increasing demand. When integratedwith the grid, it has its own technical as well …
Published in Journal of Power Electronics and Power Systems · Vol. 1, Issue 1-2-3, 2011 · pp. 28–46 Read article
-
Paper Battery for Portable Electronics: A Review
Abstract: This paper depicts about paper battery. A paper battery is an adaptable, ultrathin vitality stockpiling and generation gadget framed by consolidating Carbon Nanotubes with a customary sheet of cellulose based paper. A paper battery can work both as a high vitality battery and super capacitor. The battery produces power similarly as the traditional lithium-particle batteries however every one of the segments has been consolidated into a light weight adaptable sheet …
Published in Journal of Power Electronics and Power Systems · Vol. 7, Issue 2, 2017 · pp. 28–32 Read article
-
Modeling of Transformer Windings having Non-uniform Inductance Distribution
Abstract: A direct analytical procedure for analyzing power transformer windings with location-dependent series inductance is presented. This dependence is typically introduced in order to take the inter-turn mutual inductive coupling into consideration. The paper addresses the frequency domain analysis conducted in the complex s- or the jω-domains. Results for the frequency-dependent winding’s input impedance with different treatments of the transformer’s neutral point will be available. The frequency characteristics including the resonance …
Published in Journal of Power Electronics and Power Systems · Vol. 4, Issue 3, 2014 · pp. 12–25 Read article
-
Design and Analysis of a Solar-Wind Hybrid System
Abstract: Renewable energy sources like wind and solar energies can be combined to increase the totalpower generation and thereby increase the efficiency of the system. The combination alsoprovides a means to overcome the intermittent nature of the solar and wind renewable energysources, since one source can be used for power generation when the other is not available.AC-DC converters are used to convert the alternating voltage of the wind generator to aconstant …
Published in Journal of Power Electronics and Power Systems · Vol. 10, Issue 1, 2020 · pp. 1–8 Read article
-
Improvement of Voltage Profile and Loss Reduction using Optimized Soft Computing Based Capacitor Placement Methodology
Abstract: Significant exploration has been done on the arrangement of ideal capacitor arranging in the appropriation frameworks for the assignments of power factor adjustment, voltage profile improvement and misfortune decrease. Particularly, mechanical plant with variable load conditions has huge inductive loads and its power factor is exceptionally poor. These ventures advantage most capacitor banks. This bank gives improved power factor, expanded voltage level on the load and lessen the electric service …
Published in Journal of Power Electronics and Power Systems · Vol. 10, Issue 2, 2020 · pp. 11–21 Read article
-
Image Processing in Face Recognition Attendance System
Abstract: The uniqueness or individuality of a person's face is the example of 1’s identification. On this project face of a person is used for the cause of attendance making robotically. Attendance of the pupil could be very essential for every college, university, and college. Conventional methodology for taking attendance is by calling the call or roll a wide variety of the scholar and the attendance is recorded. Time intake for …
Published in Journal of Power Electronics and Power Systems · Vol. 10, Issue 2, 2020 · pp. 28–33 Read article
-
Efficient Transmission Pricing using Power Flow Tracing
Abstract: The evolution of transmission pricing philosophies in deregulated power markets has introduced various techniques for efficient and accurate cost estimation of power exchanges. Earlier methods of postage stamp cost estimation failed to provide accurate cost signals. Point of Connection (POC) method is a technique through which a considerable sunk cost can be recovered but is still inefficient if applied alone. In addition to this, the POC method along with the …
Published in Journal of Power Electronics and Power Systems · Vol. 13, Issue 1, 2023 · pp. 6–15 Read article
-
Optimizing the Integration of Photovoltaic and Wind Energy Systems for Enhanced Efficiency
Abstract: This work provides a novel approach for integrating a large-capacity doubly excited induction generator (DFIG)-based wind energy system with solarphotovoltaic (PV). The suggested plan offers a practical PV-grid integration solution by utilising DFIG’s grid and rotor side power converters to pump PV power into the grid. This eliminates the requirement for a separate converter for PV power processing. Compared to a comparable rated inverter utilised in traditional PV-grid systems, the …
Published in Journal of Power Electronics and Power Systems · Vol. 13, Issue 2, 2023 · pp. 34–52 Read article
-
Modeling and Simulation of a Hybrid Solar-Wind System with Adaptive Neural Network MPPT Control in MATLAB/SIMULINK
Abstract: Over the last ten years, there has been an increasing demand for the electrical powersupply. The installation of power generators (PGs) is expensive and time-consuming. Solar powerplants are therefore thought to be a practical substitute for supplying the present demand forelectricity. The primary challenges with solar plants, however, are output power balancing andcritical maintenance. A proper technique is needed to lessen output power balance andmaintenance issues in solar facilities. For …
Published in Journal of Power Electronics and Power Systems · Vol. 13, Issue 2, 2023 · pp. 53–61 Read article
-
A Study of a Non-Isolated DC-DC Converter Based on High Voltage Gain
Abstract: This article implements a best non-isolated DC-DCConverter for solar photovoltaic system-driven DC MicroGridapplications through high voltage gain methodology. At first, ahybrid boosting converter with bipolar voltage multiplier method isproposed and studied for photovoltaic-based DC MicroGrids. Butthe cost and functionality of this converter are a big problem. Toeradicate these problems with a proposed modified SEPICconverter and this converter is studied for producing high voltagegain. Formerly performance of hybrid boosting converter andmodified …
Published in Journal of Power Electronics and Power Systems · Vol. 13, Issue 3, 2023 · pp. 17–29 Read article
-
Numerical Investigation of the Osmatic Flow Impact on the Load Recovery and Early Well Performance
Abstract: The complexity of shale system coupled with the mystery of low fracturing fluid recovery has puzzled many researchers. Field reports from hydraulic fracturing operations performed on shale formation have highlighted the low recovery of the fracturing fluid. The fate of the hydraulic fracturing fluid is still controversial issue. However, literature has attributed the low load recovery to either trapping into the natural or created micro-fracture or imbibition to the matrix. …
Published in Journal of Petroleum Engineering & Technology · Vol. 5, Issue 3, 2015 · pp. 52–64 Read article
-
Study on Effect of Insulation Design on Thermal-Hydraulic Analysis: An Important Aspect in Subsea Pipeline Designing
Abstract: The most imperative and challenging operational hazards for oil and gas pipelines are the risks associated with the transportation of fluids. When water, oil and gas flow simultaneously inside the pipeline, there are quite high chances that, water and hydrocarbon fluids can form and deposit hydrate such as wax and asphaltene on the inner surfaces of the pipeline and gradually blocking it. In this paper we explore and compare the …
Published in Journal of Petroleum Engineering & Technology · Vol. 4, Issue 1, 2014 · pp. 33–44 Read article
-
Wax Deposition Profile Estimation in Production Pipeline Review
Abstract: Wax deposition has been a major challenge in flow assurance of paraffinic crude oils. A major problem occurs because of a decrease in the bulk oil flowing and pipe wall temperatures. Wax deposits form when the temperature of the produced fluid falls below the wax appearance temperature or the cloud point temperature. Problems like pipeline plugging, increased pumping pressure and reduction in production rates are very common. Sophisticated mechanical and …
Published in Journal of Petroleum Engineering & Technology · Vol. 4, Issue 3, 2014 · pp. 18–26 Read article
-
Thermodynamic modelling of the effects of high temperatures on brine fluid density
Abstract: Current trends in oil discoveries points to deep water zones characterized by temperatures ranging from 150oC to 350oC which needs good prediction of the fracture pressure and pore pressure hence imperative to continually understand temperature-density relationships of the fluids which are pumped downhole for well control. This paper seeks to propose a new, cost effective and easier method of estimating the reduction in density of brine completion fluid as it …
Published in Journal of Petroleum Engineering & Technology · Vol. 9, Issue 1, 2019 · pp. 26–35 Read article
-
Solutions to Problems Faced in Well Log Analysis in fractured metamorphic Reservoir Systems Due To Multiple Porosities and Lithology’s
Abstract: Metamorphic rocks are the most bottomless non-terrigenous sedimentary rock and are made essentially out of transformative minerals. Most metamorphic rocks shape from calcareous stores that collect in marine conditions running from salt marshes to reefs to profound sea bowls. Unmistakable and one of a kind parts of transformative rocks are their dominatingly intrabasinal starting point, their essential reliance on natural exercises for their constituents and their powerlessness to change by …
Published in Journal of Petroleum Engineering & Technology · Vol. 9, Issue 1, 2019 · pp. 36–42 Read article
-
Fitting Relative Permeability’s Curves Based on Laboratory Production Data for A Thermal Composite Core Flooding Experiment
Abstract: Numerical simulators are effective tools for an adequate understanding of models geological and dynamic properties under which enhanced oil recovery techniques are investigated. Core flooding experiments are usually conducted for calibrating simulated rock and fluid properties against actual test results at micro-scales, and for further scaling up processes to the reservoir scale. In this paper, laboratory experiments data were used as input for a numerical simulator to study the effect …
Published in Journal of Petroleum Engineering & Technology · Vol. 9, Issue 3, 2019 · pp. 41–56 Read article
-
Polystyrene Plastic Waste into Liquid Fuel Using Silica-Alumina Catalyst, Extracted from Rice Husk
Abstract: Catalytic Pyrolysis of Polystyrene (PS) into fuel like products using silica alumina catalyst that was extracted from rice husk was investigated over temperature range of 430–470°C. The output of catalytic pyrolysis was liquid oil, solid residues (char) and gaseous fraction. The product yields as a function of temperature, time and catalyst amount were studied. High conversion of liquid (48.8%) was achieved at 430 and 450ºC in the presence of 12.5 …
Published in Journal of Petroleum Engineering & Technology · Vol. 10, Issue 3, 2020 · pp. 15–31 Read article