Search
794 articles for “FRL Unit”
Nothing matched all of your words, so these match any of them.
-
An Experimental Study on Design and Fabrication of Sheet and Tube Type PVT Collector
Abstract: AbstractA hybrid system composed of a photovoltaic (PV) module integrated with a thermal unit is fabricated and tested in outdoor conditions. The system has been installed at MITS, Gwalior and its thermal analysis has been done experimentally. In our experimental work, water is used as a working fluid and pit coarse sand is used as an insulator. Experimentally it is observed that the thermal efficiency of the system is also …
Published in Journal of Alternate Energy Sources & Technologies · Vol. 9, Issue 2, 2018 · pp. 33–38 Read article
-
A Review of the Advancements in Geothermal Heating and Cooling System
Abstract: The increasing demand for energy and the depleting fossil fuels have fuelled explorations in new frontiers of renewable energy technology. Geothermal heating and cooling is a new advancement in HVAC industry of India. It uses earth’s heat for space heating and cooling with the use of heat pump systems, saving up to 51% electricity consumption in HVAC, and reduced CO2 emissions. The main prospects of geothermal energy are longer equipment …
Published in Journal of Alternate Energy Sources & Technologies · Vol. 8, Issue 1, 2017 · pp. 1–5 Read article
-
Vertical Axis Wind Turbine Modeling and its Analysis Using ANSYS
Abstract: Research on small wind turbine (SWT) is on the upswing in the last five years, as there is a need of energy producing machines to compensate with the fossil fuel based energy. The green technology wishes to create environment friendly energy producing devices based on wind or solar technology. In this paper, an attempt is made to make use of already existing waste wind energy produced by high speed moving …
Published in Journal of Alternate Energy Sources & Technologies · Vol. 8, Issue 1, 2017 · pp. 26–32 Read article
-
Hybrid PV-PCM System to Increase Efficiency
Abstract: AbstractThis paper studies a hybrid design for the photovoltaic industry made up of a conventional photovoltaic panel and a Phase Change Material (PCM) to increase the efficiency of the panel as well as to generate thermal energy. The system has been based on thermal transfer from the PV panel to the PCM through direct contact, thus reducing the operating temperature of the panel and improving its efficiency. The system operates …
Published in Journal of Alternate Energy Sources & Technologies · Vol. 11, Issue 2, 2020 · pp. 15–26 Read article
-
Modeling Cogeneration System in Shallow Geothermal Installations
Abstract: This paper presents a theoretical modeling of a cogeneration system using multiple heat exchangers and thermoelectric generator. The modeled system, designed for shallow geothermal energy, is a closed piping unit containing water as heat transfer fluid that circulates through a closed loop releasing thermal energy at the surface for heating and sanitary hot water. In addition, a Peltier cells array is attached to the piping system to generate electricity, thus …
Published in Journal of Alternate Energy Sources & Technologies · Vol. 11, Issue 3, 2020 · pp. 13–23 Read article
-
Inhibition of Growth of Selected Bacterial Species Through the Use of Methanolic Maceratives of Black Soldier Fly Pre-Pupae
Abstract: The attempt is dealing with of analysis of effect of maceratives of prepupal stages of black soldier fly (BSF) (Hermetia illuncens L.) in methanol on the inhibition of the growth of selected bacterial species. The bacterial species used for the study include: Salmonella typhimurium (L.); Escherichia coli (L.); Pseudomonas aeruginosa (L.); Bacillus cereus (L); Bacillus subtilis (L); Streptococcus cremoris (L); Streptococcus faecalis (L); Staphylococcus aureus (L); Klebsiella pneumoniae (L); Salmonella …
Published in Journal of Catalyst & Catalysis · Vol. 8, Issue 2, 2021 · pp. 30–44 Read article
-
Mechanism Action of Catalysis
Abstract: Catalysis is a method for speeding up the rate of a reaction. It is of three types homogeneous, biocatalysis and heterogeneous catalysis which further involve acid base catalysis, that is based on Brønsted-Lowry concept which state that any compound that can transfer a proton to any other compound is an acid, and the compound that accepts the proton is a base and in enzymatic catalysis every enzyme is specific to …
Published in Journal of Catalyst & Catalysis · Vol. 8, Issue 3, 2021 · pp. 22–28 Read article
-
Production of Pectin from Orange Peels (Citrus sinensis)
Abstract: The study on pectin manufacturing from orange peel raw material indicated the effect of operating temperature on the quality and quantity obtained at a given mass of orange peels loaded in the distillation column, as well as the influence of time. The pectin was measured at various operating temperatures, times, and pH values of acidic media namely 1, 1.5, 2, 3, and 4 with operating temperatures of 60°C, 70°C, and …
Published in Journal of Catalyst & Catalysis · Vol. 10, Issue 3, 2023 · pp. 29–40 Read article
-
Challenges of RERA: An analysis of New Reforms
Abstract: AbstractMaking it into the list with names like The United States of America, Germany, China,Singapore and UAE, India has finally received a green light. In contrast, where a developed country like US had it implemented in 1974, the time lag of 42 years in India raises a number of questions. After a long wait of 9 years, Real Estate Regulation and Development act, 2016 (RERA) has eventually come into force. …
Published in Journal of Construction Engineering, Technology & Management · Vol. 7, Issue 3, 2017 · pp. 11–16 Read article
-
A Study on Construction Labour Productivity Parameters in India
Abstract: Construction industry (CI) is one of the major pillars in economy in any country, be it developed or a developing one. CI plays a pivotal role in the capital investment. Construction labour productivity (CLP) has pivotal role to ensure CI contributes to economic growth. It is difficult to improve or even measure CLP as there is a limited comparable input and output. Normally, even the slightest improvement in CLP level …
Published in Journal of Construction Engineering, Technology & Management · Vol. 6, Issue 1, 2016 · pp. 45–52 Read article
-
Reuse of Scrap Tyre as Partial Replacement of ¾˝ Natural Coarse Aggregate in Concrete and its Impact on Properties of Concrete
Abstract: A modern lifestyle, alongside the advancement of technology has led to an increase in the amount and type of waste being generated, leading to a waste disposal crisis. This paper tackles the problem of the waste tyre, thrown after use in vehicles. In order to dispose of or at least reduce the accumulation of rubber tyre waste, it has been suggested to reuse these waste materials to substitute a percentage …
Published in Journal of Construction Engineering, Technology & Management · Vol. 5, Issue 1, 2015 · pp. 44–48 Read article
-
Microgrid System Control Identification and Evaluation for Enhanced Dynamic Operation
Abstract: Networking the distributed generators (DG) in a microgrid system involves a large number of electronic components and filters. Small changes or drifts in operating conditions as well as disturbances at the point of common coupling can excite the associated eigenvalues giving rise to slowly growing instability in the system. This article considers the stability of a microgrid system consisting of a micro alternator, wind generator, photovoltaic (PV) system, fuel cell …
Published in Journal of Control & Instrumentation · Vol. 9, Issue 1, 2018 · pp. 33–44 Read article
-
Heterogeneous Teleoperation Model for Controlling 3D Printed Humanoid Robot Arm with 5 DOF using 3 DOF Exoskeleton
Abstract: The main objectives of the present work are to model and implement a control system of five degrees of freedom (5 DOF) humanoid arm by using an exoskeleton system with 3 DOF. The exoskeleton system is used to transport the movements of the human’s arm to the controller to control the humanoid arm by using sensors at each target joint to measure the angular displacement of it. To achieve this …
Published in Journal of Control & Instrumentation · Vol. 10, Issue 2, 2019 · pp. 1–15 Read article
-
RFID BASED PROTOTYPE DEVELOPMENT OF IMMOBILIZER FOR TWO WHEELER VEHICLE SECURITY
Abstract: An immobilizer is an electronic device fitted to an automobile which prevents the engine from running unlessthe vehicle has the proper access to it. The main use of this system is to protect the vehicle from being stealthas it deactivates the engine. The immobilizer security system is mainly seen in four wheeler vehicles. Thesame idea can be implemented for 2 wheeler vehicles which are in huge number in countries like …
Published in Journal of Control & Instrumentation · Vol. 1, Issue 1-2-3, 2011 · pp. 44–49 Read article
-
A CON: EVO Reduction Technique for Uncertain Interval Systems Using Differential Evolution Algorithm
Abstract: In this paper advantage of evolutionary technique is used in combination with a reliable conventionaltechnique to reduce the dimension of high order uncertain linear interval systems into low order intervalsystems. The proposed technique is depicted by a name CON: EVO, which stands for combination ofconventional & evolutionary technique. In evolutionary method recently proposed Differential Evolution(DE) optimization technique is used with and without powerful conventional Routh approximation techniqueto minimize the integral …
Published in Journal of Control & Instrumentation · Vol. 1, Issue 1-2-3, 2011 · pp. 1–11 Read article
-
Design and Implementation of SRF-PLL for Grid Synchronization
Abstract: The existing power system stands in a peculiar spot where a lot of innovative ideas keeps on forcing it to change itself to work more efficiently and consumer friendly. The micro-grid is one such area where the involvement of consumers in the power system is much more engaging than it was before. With the emergence of dependable and reliable renewable sources of energy such as solar and wind, the need …
Published in Journal of Control & Instrumentation · Vol. 10, Issue 2, 2019 · pp. 21–27 Read article
-
Investigation of Physical Characteristics and Machining Parameters of Improved Al-SiC MMC Using Dry EDM Process for Aerospace Industries
Abstract: Aluminium-based composite is widely used in aerospace and automobile industries because it is lighter in weight; but the trouble is that it is easily worn-out and life of the components is decreased. To overcome these problems, aluminium silicon carbide composite material has been developed with good wear-resistance, hardness and lighter weight. Silicon carbide has good mechanical properties like wear resistance, hardness, toughness and high melting point. Silicon carbide weight fractions …
Published in Journal of Experimental & Applied Mechanics · Vol. 9, Issue 1, 2018 · pp. 15–32 Read article
-
Performance Analysis and Emission Study of a C.I. Engine using Butanol, Biodiesel and Diesel Blends
Abstract: Biodiesel, which has been projected as an alternative to diesel fuel, can be made an attractive and viable substitute by use of a non-glyceride type of readily available, renewable and economic resources like acid oil. The production and consumption of biodiesel will increase in future due to ecofriendly, and possibility of use of existing engines of a motor vehicle without the need for major adjustments. Biodiesel and diesel fuel are …
Published in Journal of Experimental & Applied Mechanics · Vol. 9, Issue 2, 2018 · pp. 17–22 Read article
-
Injection of Air Bubbles and its Effects into A Shell and Coiled Heat Exchanger: A Review
Abstract: The purpose of this research is to investigate the effects of air bubble injection on the performance of a horizontal helical shell and coiled tube heat exchanger in an experimental setting. The effects of air bubble injection with varied air flow rates on the number of thermal units (NTU), exergy loss, and efficacy are examined. In present review, a shell and snaked tube heat exchanger has been numerically considered. The …
Published in Journal of Experimental & Applied Mechanics · Vol. 12, Issue 3, 2021 · pp. 40–47 Read article
-
Experimental and Simulated Analysis of Hybrid Auxiliary Energy Storage System for Electric Vehicles
Abstract: Electric mobility contributing to greater extent to balance the energy and power demands, energy storage unitsas well as environment safety for current automobile sector. Electric vehicle has major efficient features of zerocombustion, longer charging and discharging cycle which plays a vital role to replace the ongoing increase in price ofpetroleum fuels and its harmful effect son environment with their degrading store. Many non-conventional energysources like solar, tidal, wind etc. Can …
Published in Journal of Experimental & Applied Mechanics · Vol. 14, Issue 1, 2023 · pp. 23–40 Read article