Journal of Electronic Design Technology
Volume 8, Issue 1 (2017)
Published
Table of contents
-
Effect on Temperature and Efficiency on Photovoltaic Module of PV/T System with Water Based Optical Filter
Abstract: Solar radiation has ultraviolet, visible and infrared radiations, in which infrared and ultra-violet part of the solar radiation are mainly responsible for the heating of solar cell. This decreases the efficiency of the solar cell by –0.3 to –0.5% K-1. When we increase the concentration on the solar cell then the heat becomes more prominent and causes the damage of the solar cell, and also decreases the efficiency of solar …
Published in Journal of Electronic Design Technology · Vol. 8, Issue 1, 2017 · pp. 1–6 Read article
-
Wideband Bandstop Filter Using Triangular SRR-DGS
Abstract: This article presents a dumbbell shaped triangular split ring resonator (SRR) in the design of wideband bandstop filter. Initially, a conventional dumbbell shaped triangular defective ground structure (DGS) is used to realize the single bandstop filters at the frequency of 3.55 GHz. This triangular shaped DGS structure is modified to a new structure to realize a wideband bandstop filter characteristics with the frequency range of 3.3 to 4.5 GHz which …
Published in Journal of Electronic Design Technology · Vol. 8, Issue 1, 2017 · pp. 11–16 Read article
-
FPGA-based Multichannel Digital Duty-Cycle Modulation and Application to Simultaneous Generation of Analog Signals
Abstract: The DCM (duty-cycle modulation) is used in industrial electronics as a special technique for producing switching time-varying periodic waves, with variable pulse width and modulation period. As an implication, unlike the fixed period of a PWM wave, the cyclic ratio of a DCM signal changes as a function of the modulating input according to a known function. However, most existing research works related to DCM-based instrumentation systems, are limited to …
Published in Journal of Electronic Design Technology · Vol. 8, Issue 1, 2017 · pp. 23–35 Read article
-
System Preplanning Theory by using Failure vs. Reliability Analysis of DSP-270P Polycrystalline SPV System: A Comparative Approach
Abstract: A preplanning idea is always required before installing any new system. So, we present an approach for technical preplanning excluding mechanical designing and cost through this paper, to make the system more reliable as well as proper array selection scheme through the comparative analysis. It is implemented by using the comparative approach of optimized and non-optimized output for DSP270P polycrystalline SPV array through PSO, P&O and GA techniques with the …
Published in Journal of Electronic Design Technology · Vol. 8, Issue 1, 2017 · pp. 36–40 Read article
-
Hybrid Solar PV–Wind Energy System: A Performance Study
Abstract: The solar PV and, wind energy hybrid technology is based on the concept of a modular, scalable, distributed renewable energy system designed and optimized for on and off grid installations. This kind of system is fully integrated hybrid system that combines wind energy units with PV technology in a compact footprint, creating the greatest energy generation density. The hybrid concept is unique and disruptive, seamlessly utilizing wind and solar energy …
Published in Journal of Electronic Design Technology · Vol. 8, Issue 1, 2017 · pp. 7–10 Read article