Journal of Experimental & Applied Mechanics
Volume 13, Issue 2 (2022)
Published
Table of contents
-
Design and Analysis of Aerodynamics on Wind Turbine
Abstract: The design and analysis of aerodynamics on a horizontal axis wind turbine rotor blade are explained in this research. A method for selecting materials for wind turbine design is described, followed by the design of the solid works. . The science and study of the physical rules that control the behaviour of objects in airflows, as well as the forces that these airflows produce, is known as aerodynamics. This article …
Published in Journal of Experimental & Applied Mechanics · Vol. 13, Issue 2, 2022 · pp. 1–5 Read article
-
Concrete Compressive Stress-Induced Crack Analysis and the Main Causes of Concrete Cracks in Construction
Abstract: The findings of experimental investigations into the micromechanical behaviour of concrete under various loading scenarios are presented in this work. Concrete specimens with normal and high strengths were examined under uniaxial compression in constrained spaces. Injection of a low melting point alloy was done into the concrete specimens' pores and fissures. To preserve the load-induced stress microcracks and the pictures from the cross sections of the concrete specimens photographed by …
Published in Journal of Experimental & Applied Mechanics · Vol. 13, Issue 2, 2022 · pp. 11–15 Read article
-
Mohr's circle for stress in planes and Stress-Strain Relation for Elasticity Equations and Stress-Strain Analysis
Abstract: The distribution of stress and strain in thin films and substrates resulting from inhomogeneous plane stresses created in the film during deposition is calculated and reported. The findings can be used to determine the unknown stresses in a film using the "bending plate method," which measures the deformation of the substrate surface By doing this, Theoretically, the local values of the stress tensor within the film plane and the centre …
Published in Journal of Experimental & Applied Mechanics · Vol. 13, Issue 2, 2022 · pp. 16–21 Read article
-
Using digital holographic interferometry to monitor symmetrical temperature fields in liquids and an interference technique for simultaneous heat and mass transfer
Abstract: In this work, we offer a technique for off-axis digital holographic interferometry to measure dynamic temperature change quantitatively in real-time and visualise volumetric temperature fields formed by a 2D axial-symmetric heated fluid from a pulsatile jet in a water tank. For the experimental examination, a portable Mach-Zehnder interferometer was constructed. The pulsatile jet was supplied with hotter water and submerged in a tank of water. Results that have been averaged, …
Published in Journal of Experimental & Applied Mechanics · Vol. 13, Issue 2, 2022 · pp. 22–26 Read article
-
RADAR IMAGING THEORIES AND PRINCIPLES OF OCEAN WAVES CAPILLARY WAVES AND TYPES OF RADAR
Abstract: Capillary waves caused by the wind were measured in a wave tank. The capillary waves' height, slope, and frequency composition were all measured. The wave heights (from trough to crest) were found to be between 0.06 and 8.8 mm for winds between 2.2 and 7.6 m/sec. Wind speed affects the distribution of frequencies (wavelengths), with more high frequency waves occurring at faster wind speeds. An S-shaped curve with the sharply …
Published in Journal of Experimental & Applied Mechanics · Vol. 13, Issue 2, 2022 · pp. 6–10 Read article