Trends in Electrical Engineering
Power Factor Correction Using Parallel Boost Converter
Abstract
Power factor, the ratio between the active or average power and the apparent power forms a very essential parameter of the power system. It is indicative of how effectively the active power of the system has been utilized. With rapid development in power semiconductor devices, the usage of power electronic systems has expanded to a new and wide application range that include residential, commercial, aerospace and many others. Power electronic interfaces e.g. switch mode power supplies (SMPS) have ended up being better over conventional direct power supplies. Be that as it may, their non-straight conduct puts a question mark on their high effectiveness. The current drawn by the SMPSs from the line is of low quality and contorted bringing about a high total harmonic distortion (THD) and low power factor (PF). Individually, a gadget with consonant current does not posture much significant issue however when it is utilized on a gigantic scale the utility power supply condition will get decayed. Other unfavorable consequences for the force framework incorporate expanded sizes of impartial streams in three-stage frameworks, overheating in transformers and instigation engines and so forth. Henceforth, there is a consistent requirement for force component change and diminishment of line current sounds; improvement of new circuit topologies and control methodologies for power factor correction. Keywords: Power factor, current control technique, hysteresis current control technique, parallel boost converterReferences (23)
- Purton KD , Lisner RP . Average Mode Control in Power Electronic Converters - Analog versus Digital. Department of Electrical and Computer System Engineering, Monash University, Australia.
- Dixon L. Average Current Mode Control of Switching Mode Power Supplies. Application Note, Unitrode U-140. Trends in Electrical Engineering Volume 5, Issue 3 ISSN: 2249-4774(online), ISSN: 2321-4260(print) TEE (2015) 71-88 © STM Journals 2015. All Rights Reserved Page 87
- Sun J , Bass RM. Modelling and Practical Design Issues for Average Current Control. Applied Power Electronics Conference and Exposition, 1999. APEC'99. 14th Annual. 1999; 2: 980–986p. Collins Rockwell Inc.
- Orabi M , Ninomiya T . Stability Performances of Two -Stage PFC Converters. Industrial Electronics IEEE . 50(6).
- Zhou C, Jovanoviac MM. Design Trade - Offs in Continuous Current Mode Controlled Boost Power Factor Correction Circuits. Power Electronics Lab, Inc.
- Attaianese C, Nardi V, Parillo F. Dual Boost High performances Power Factor Correction Systems (PFC). In Press.
- Darly S, Ranjan V , Bindu KV, et al. A Novel Dual Boost Rectifier for Power Factor Improvement . ICEES, 2011 ; 1st International Conference.
- Firuz Zare, Gerard Ledwich. A New Hysteresis Current Control for Three-phase Inverters Based on Adjacent Voltage Vectors and Time Error. Proceedings Power Electronics Specialists Conference, PESC 2007; Orlando, Florida. 431–436p.
- Azizi HZ, EL-Kholy EE, Mahmoud SA, et al. DSP Based Control of Boost PFC AC - DC Controllers using Predictive Control. Yanbu Journal of Engineering and Science (YJES). 2011; 2.
- Chen J-J, Lin Y-T, Lin H-Y, et al. On-Chip Current Sensing Techniques for Hysteresis Current C ontrolled DC –DC Converters. Electron Lett. 31 Aug 2004. #IEEE 2005; 41(2): 95–97p. doi:10.1049/el: 20056807.
- Vahedi Hani, Sheikholeslami Abdolreza, Bina Mohammad Tavakoli, et al. Review and Simulation of Fixed and Adaptive Hysteresis Current Control Consi dering Switching Losses and High -Frequency Harmonics. Hindawi Publishing Corporation; Adv Power Electron . 2011; Article ID 397872.
- Amer Mohamed R, Mahgoub Osama A, Zaid Sherif A. New Hysteresis Control Method for Three Phase Shunt Active Power Filter. Proceedings of the International Multiconference of Engineers and Computer Scientists IMECS 2011, Hong Kong. Mar 16–18, 2011; II.
- Rossetto L, Spiazzi G, Tenti P. Control Techniques for Power Factor Correction Converters. Unpublished.
- András Fehér, Zoltán Puklus. Definitions and Measurement of Power Factor. 8th International Symposium of Hungarian Researchers on Computational Intelligence and Informatics.
- Power Factor Correction (PFC) Application Notes, © 2010 Cooper Bussmann St. Louis, MO 63178 636 -394- 2877 www.cooperbussmann.com.
- Eaton Corporation. Power Factor Correction: A Guide for the Plant Engineer Handbook. Cleveland, OH 44114 USA: Eaton Corporation; 2013.
- Redl Richard. Reducing Distortion in Peak-Current-Controlled Boost Power Factor Correctors. Proc. of IEEE Applied Power Electronics Conference, APEC’94. 1994; 576–583p.
- Maksimovic Dragan. Design of the Clamped-Current High -Power-Factor Boost Rectifier. IEEE Trans Ind Appl . Sep–Oct 1995; 31(5): 986–992p.
- Canesin Carlos A, et al . Analysis and Design of Constant -Frequency Peak - Current Controlled High Power -Factor Boost Rectifier with Slope Compensation. Proc. of IEEE Applied Power Electronics Conference, APEC’96. 1996; 807–813p.
- Redl Richard, et al . Power-Factor Correction with Inte rleaved Boost Converters in Continuous -Inductor- Current Mode. Proc. of IEEE Applied Power Electronics Conference, APEC’93. 1993; 168–174p.
- Vlatkovic V, et al. Input Filter Design for Power Factor Correction Circuits. IEEE Trans Power Electron. Jan 1996; 11 (1): 199–205p.
- Loh Poh Chiang, Bode Gerwich H, Holmes Donald Grahame, et al. A Time - Based Double -Band Hysteresis Current Regulation Strategy for Single -Phase Multilevel Inverters. IEEE Trans Ind Appl. May/Jun 2003; 39(3).
- Joel Turchi, Dhaval Dalal, Patrick Wang, et al. Power Factor Correction Handbook.