Journal of Materials & Metallurgical Engineering
Volume 4, Issue 2 (2014)
Published
Table of contents
-
Correlating the Damage Behaviour of Polymer Composites with the Potential Energy of the Impactor
Abstract: Design of structures using composites requires comprehensive evaluation and characterization of mechanical properties in both undamaged and damaged state. Composite laminates undergo combinations of mechanical loading resulting into microdamage accumulation in the plies. The first mode of damage is usually intralaminar cracking with the crack plane transverse to the middle plane of the laminate, spanning the whole width of the laminate. The density of cracks in a ply depends on …
Published in Journal of Materials & Metallurgical Engineering · Vol. 4, Issue 2, 2014 · pp. 1–9 Read article
-
Effect of Tool Tilt on Formation of Tunnel in Friction Stir Welded 5083 Joints: An Experimental Study
Abstract: Friction stir welding (FSW) being a solid-state joining process is immune to the various defects faced in traditional fusion welding process. However, defects such as voids, joint line remnants and tunnel defects are common imperfections in FSW. In the present study, an attempt has been made to investigate the effect of tool tilt on the formation of tunnel defect, while keeping all other process parameters constant. Tool tilt is a …
Published in Journal of Materials & Metallurgical Engineering · Vol. 4, Issue 2, 2014 · pp. 10–15 Read article
-
A Study of Improvement of Mechanical Properties of Aluminum by Conventional Casing and Deformation Process
Abstract: Nowadays, Aluminum-Zinc alloy system are the major and rapid development in the field of automotive and aerospace industries for growing demand of efficient vehicles and aircrafts to reduce energy consumption and air pollution. Aluminum is a very soft metal by nature. Different alloying elements were added in the past to increase its strength and toughness. Zinc is considered as a major alloying element in aluminum to increase its strength and …
Published in Journal of Materials & Metallurgical Engineering · Vol. 4, Issue 2, 2014 · pp. 16–20 Read article
-
Evaluation of Mechanical Property and Optimization of the Dry Sliding Wear Behavior of Carbon Black-Alumina-Epoxy-Glass Composite by using Design of Experiments
Abstract: The research work is mainly focused on investigating the effects of wear parameters: filler content (0%, 4% CB, 4% Al2O3,and 2% CB + 2% Al2O3), applied load (4.905, 9.810, 14.710, and 19.62 N), sliding distance (20, 30, 40, and 50 mm) by using Design of Experiments (DOEs) approach. The experimental results were analyzed using MINITAB V16 scientific graphical and data analysis software. Signal-to-Noise (S/N) ratio, analysis of variance (ANOVA) proved …
Published in Journal of Materials & Metallurgical Engineering · Vol. 4, Issue 2, 2014 · pp. 21–31 Read article
-
Micro Crack Formation in High Frequency-Electric Resistance Welding
Abstract: The present paper discusses about the formation of micro cracks in base metal adjacent to the weld area during High Frequency-Electric Resistance Welding (HF-ERW) of 10'' outside diameter pipe. The micro crack formation has been analyzed with respect to chemical composition, microstructure, inclusion level, welding parameters and angle of weld flow lines.
Published in Journal of Materials & Metallurgical Engineering · Vol. 4, Issue 2, 2014 · pp. 32–39 Read article