Journal of Control & Instrumentation
Volume 7, Issue 2 (2016)
Published
Table of contents
-
Performance Comparison of IRT Method with NNMPC Method
Abstract: The continuous stirred tank reactor (CSTR) system was used for experimentation and the improved relay tuning (IRT) method was applied for design of optimum PID settings. The closed loop response was obtained using these optimum PID settings and compared with that of neural network model predictive control (NNMPC) method. The integral absolute error (IAE) criterion for the performance evaluation was used and it was found that the integral error has …
Published in Journal of Control & Instrumentation · Vol. 7, Issue 2, 2016 · pp. 1–4 Read article
-
A Review: Electrical Impedance Tomography System and Its Application
Abstract: Nowadays, the objective of medical research is to improve the diagnostic tools and instruments such as to develop new assessment methods, non-invasive and long-term monitoring method. Currently, the non-invasive technique is used for during pregnancy and labor due to its standard clinical approach. Such as ultrasound and MCG, CTG is also used during pregnancy because of its sensitivity to the mother and fetal movement but it is not used during …
Published in Journal of Control & Instrumentation · Vol. 7, Issue 2, 2016 · pp. 14–22 Read article
-
Modeling, Analysis and LQR Control of an EV Differential using IPMSM
Abstract: Recently, the mechanical differential (MD) of vehicle has been replaced by electronic differential (ED) by means of electric motor. Electronic differential ensures dynamic and robust control of the vehicle behavior. The ED has been designed for an electrical vehicle (EV) based on IPMSM due to its some inherent advantageous features. The design of speed controller of an IPMSM mainly depends on its mathematical model. The mathematical model based speed controller …
Published in Journal of Control & Instrumentation · Vol. 7, Issue 2, 2016 · pp. 23–34 Read article
-
Smart Car Parking System with ALS Sensor using myRIO
Abstract: This project deals with the design of an intelligent car parking monitoring system utilizing ultra-sonic sensor, DC motor where as an ambient light sensor using myRIO controller in LabVIEW. The system focuses on low power sensor based system, designed to monitor the number of vehicles entering the parking and to control the light intensity required for sufficient lighting in the parking area. The system is designed to be implemented in …
Published in Journal of Control & Instrumentation · Vol. 7, Issue 2, 2016 · pp. 35–41 Read article
-
110kV Primary Substation Automation Based on PLC and SCADA
Abstract: This research paper describes the automated switch control of 110kV primary substation by using SCADA and PLC ladder logic. The basic idea behind substation automation is to monitor the switchyards in substation. In substation, many relays and circuit breakers are used. When any one of the breakers are tripped, serious issues may happened and hence, it required monitoring and controlling through sophisticated system like SCADA. In this project, signals are …
Published in Journal of Control & Instrumentation · Vol. 7, Issue 2, 2016 · pp. 5–13 Read article