Journal of Power Electronics and Power Systems
High Gain High Efficiency Single Switch DC–DC Converter for Green Power Source Conversion
Abstract
Efficiency of solar cell is very low and it is preferred to be operated at low voltages; so it is difficult to supply power to a certain load. Conventional boost converter offers limited gain. So a high voltage boosting is needed. Proposed converter consists of coupled inductor and switched capacitor technique to achieve high gain without high duty ratio and turns ratio. In the magnetic field of coupled inductor and intermediate capacitor, input energy is first stored and passed to next stage for load consumption. Passive clamp network reduces voltage stress and conduction losses on the switch; therefore a low voltage switch is needed. Reverse recovery problem of diode is alleviated by coupled inductor. MPPT technique is used to obtain maximum power from a varying source. This is done by varying the duty ratio of the boost converter by using MPPT algorithm. In perturb and observe algorithm, array terminal voltage or current is periodically perturbing. Operating point is moving in the increasing power direction in order to track maximum available power.Keywords: Coupled inductor, high gain converter, passive clamp, switched capacitor, MPPT, solar photovoltaics (PV)Cite this ArticleSinimol Salim, Abraham Peter K. High Gain High Efficiency Single Switch DC–DC Converter for Green Power Source Conversion. Journal of Power Electronics & Power Systems. 2018; 8(3): 46–56p.References (13)
- Xu J. Modeling and Analysis of Switching DC-DC Converters with Coupled Inductor. In Proc IEEE Int Conf Circuits Syst (CICC). May 12–15, 1991; 717–720p.
- Garcia FS, Pomilio JA, Spiazzi G. Modeling and Control Design of an Interleaved Double Dual Boost Converter. IEEE Trans Ind Electron. Aug 2013; 60(8): 3283–3290p.
- Tseng KC, Huang CC. High Step-Up High Efficiency Interleaved Converter with Voltage Multiplier Module for Renewable Energy System. IEEE Trans Ind Electron . Mar 2014; 61(3): 1311–1319p.
- Prudente M, Pfitscher LL, Emmendoerfer G, et al. Voltage Multiplier Cells Applied to Non Isolated DC -DC Converters. IEEE Trans Power Electron. Mar 2008; 23(2): 871–887p.
- Lee PW, Lee YS, Cheng DKW, et al. Steady-State Analysis of an Interleaved Boost Converte r with Coupled Inductors. IEEE Trans Ind Electron. Aug 2000; 47(4): 787–795p.
- Choi CT, Li CK, Kzok SK. Modeling of an Active Clamp Discontinuous Conduction Mode Flyback Converter under Variation of Operating Conditions. In Proc IEEE Int Power Electron Dri ve Syst (PEDS). 1999; 2: 730–733p.
- Das M, Agarwal V. A Novel High - Efficiency, High Gain, Front End DC -DC Converter for Low Input Voltage Solar Photovoltaic Applications. In Proc 38th Annu Conf IEEE Ind Electron Soc (IECON). Oct 25–28, 2012; 5744–5749p.
- Sridhar R, Jeevananthan S, Selvan NT, et al. Performance Improvement of a Photovoltaic Array Using MPPT PO Technique. IEEE Int Conf Commun Control and Comput Technol . 2010; 191 – 195p.
- Zhao Q, Lee FC. High-Efficiency, High Step-Up dc -dc Converters. IEEE Trans Power Electron. Jan 2003; 18(I): 65–73p.
- Li W, He X. Review of Non -isolated High-Step-Up DC/DC Converters in Photovoltaic Grid -Connected Applications. IEEE Trans Ind Electron . Apr 2011; 58(4): 1239–1250p.
- Yang LS, Liang TJ. Transformer-less dc - dc Converter with High Voltage Gain. IEEE Trans Ind Electron. Aug 2009; 56(8): 3144–3152p.
- Witulski AF. Introduction to Modeling of Transformers and Coupled Indu ctors. IEEE Trans Power Electron. May 1995; 10(3): 349–357p.
- Kwon M, Kwon BH. High Step-Up Active-Clamp Convert er with Input- Current Do ubler and Output-Voltage Doubler for Fuel Cell Power System s. IEEE Trans Power Electron. Jan 2009; 24(1): 108–115p. Cite this Article Sinimol Salim, Abraham Peter K. High Gain High Efficiency Single Switch DC – DC Converter for Green Power Source Conversion. Journal of Power Electronics & Power Systems. 2018; 8(3): 46–56p.