Journal of Instrumentation Technology & Innovations

Manufacturing Process Optimization by using New Cutting Method in Turning Centre

  1. Vivek K Patnasetty ✉
  2. Bharath M.R.
  3. D.T. Venkatesh

Abstract

Abstract: The paper is about the effects from a new cutting method. The constant depth of cut is commonly used in a turning centre for machining purpose. The new method has gradually increasing depth of cut nearer to the chuck of the machine. The workpiece is divided into sections and different depths of cuts are given at the sections. By using this method, the overall cut length decreases, the cycle time decreases, tool life increases, and complete machine utilization is possible. This method is first analyzed in software and then same conditions are taken to real turning centre. The effects with table of values, figure and graphs are explained in detail in this paper Keywords: Cutting method; CAPSTURN; Cycle time; MachiningCite this Article: Vivek K. Patnasetty, Bharath M.R., D.T. Venkatesh. Manufacturing process optimization by using new cutting method in turning centre. Journal of Instrumentation Technology & Innovations. 2019; 9(1), 7–11p

References (5)

  1. Swapnil Y Shende, Achal S Shahare. Design and Analysis of Special Purpose Fixture for Cutting Gears on Milling Machine . International Journal for Scientific Research & Development. 2016; 4(9).
  2. Prakash N Parmar, Vikas R Gondalia, Niraj C Mehta . Review on Advance Automation of Conventional Lathe Machine. IJEDR. 2014; 2(2).
  3. Aslam Hirani, Shohin Naik, Toufik Pathan, Vaibhav Patil, Swarupanand Lugade . Increase in productivity by attachment of grinding setup on lathe machine . International Journal of Recent Advancement in Engineering & Research. 2017;3(5).
  4. Olugboji Oluwaf emi Ayodeji, Matthew Sunday Abolarin, Jiya Jonathan Yisa, Popoola Solomon Olaoluwa, Ajani Clement Kehinde. Effect of Cutting Speed and Feed Rate on Tool Wear Rate and Surface Roughness in Lathe Turning Process . International Journal of Engineering Trends and Technology. 2015;22(4).
  5. Jadhav JS, Jadhav BR. Experimental study of Effect of Cutting Parameters on Cutting Force in Turning Process . International Journal of Innovative Research in Advanced Engineering. July 2014; 1(6). Cite this Article Vivek K. Patnasetty, Bharath M.R., D.T. Venkatesh. Manufacturing process optimization by using n ew cutting method in turning centre. Journal of Instrumentation Technology & Innovations. 2019; 9(1), 7–11p

Read more of it

Subscribe to one journal or build your own list of several. One invoice, one payment, access for a full year.

Subscribe to journals →

Publish your article

Peer-reviewed journals across every subject, with open access options. Send your manuscript to the right editor today.

Publish with us → Calculate your APC
Support