3 publications
-
Published Subscription
Power Supply Design Issues for Personnel Computers Application: A ReviewBy sanjeev jain
Abstract: A power supply should meet various requirements for proper functioning of a PC. Electromagnetic Interface (EMI) causes catastrophic failures resulting in malfunctioning of PC's. It is therefore essential to meet the Electromagnetic Compatibility (EMC) requirements in addition to other design considerations demanded in a high technology system. The computer is operating and transmitting the signal with low voltage, so it is sensitive to Electromagnetic interference of leakage. Since the PC …
Published in Journal of Power Electronics and Power Systems · Vol. 3, Issue 2, 2013 · pp. 37–40 Read article →
-
Published Subscription
A Survey: A Low EMI Approach to Electronic Circuit DesignBy sanjeev jain
Abstract: This paper describes techniques to meet national and International standards in the area of electromagnetic interference (EMI) which are becoming very important for users and equipment manufacturers of electrical/electronic equipment. EMI sources are identified & classified into either natural or manmade. Normal sources of EMI are further classified as terrestrial, emanating on or near the Earth’s surface or non terrestrial, emanating from cosmic or solar bodies. Techniques to reduce EMI …
Published in Journal of Power Electronics and Power Systems · Vol. 3, Issue 1, 2013 · pp. 1–4 Read article →
-
Published Subscription
Comparison of Ultra Wide Band Indoor Multipath IEEE 802.15.3 Channel ModelBy sanjeev jain, Indrasen Singh
Abstract: ABSTRACT A very large bandwidth of frequency (3.1–10.6 GHz) has been allocated to UWB systems. A single-band UWB signal propagates differently in the lower and upper bands of the spectrum due to the size of its bandwidth. The lower part of the signal can be obstructed more easily and the man-made interferences are not homogeneously distributed over the whole spectrum. The first experimental results obtained for a UWB channel show …
Published in Journal of Communication Engineering & Systems · Vol. 2, Issue 3, 2012 · pp. 20–25 Read article →