STM Journals Peer-reviewed research from Consortium e-Learning Network

4 publications

  • Published Subscription

    Optimal Selection of Control Factors in Abrasive Water Jet Cutting of Titanium Grade 5

    By Panchal Vivek Mahendra, Paramjit Thakur, Panchal Deven Ashok, Patil Avishkar Vijay, Shetty Akshay Satish

    Abstract: The Technique for Order Preference by Similarity Ideal Solution (TOPSIS) approach was used to carry out optimization studies on an abrasive water jet (AWJ) cutting process with multiweapon characteristics based on Multi Criteria Decision Making Methodology (MCDM). The process parameters water jet pressure, traverse rate and standoff distance are optimized with multiresponse characteristics, including the depth of penetration (DOP) smooth zone (SR) . The optimized results obtained from this approach …

    Published in Recent Trends in Fluid Mechanics · Vol. 9, Issue 1, 2022 · pp. 38–42 Read article

  • Published Subscription

    Design and Fabrication of Biofilter and Piping in Soilless Farming

    By Paramjit Thakur

    Abstract: The most prevailing problems with the modern world are food and water Crises. It is neither possibleto consume the chemically contaminated food nor grow own plants, thanks to scarcity of water andland. Under such Conditions, there arises a requirement for portable agricultural system which Usesless water, space and is only organic. One such solution may be a small scale aquaponic system.Aquaponics uses fish waste to supply nutrients for plants, the …

    Published in Trends in Machine design · Vol. 8, Issue 3, 2021 · pp. 1–6 Read article

  • Published Subscription

    Equipment Used in Aquaponic Farming

    By Prajakta Mahadik, Ketan Shimpi, Yash Mhatre, Sairaj Kanse, Paramjit Thakur

    Abstract: The United Nations predicts the global population to increase from 7.2 million in 2013 to 9 billion by 2050. There are various ways to increase the production of a single food that combines the combination of aquaponics with the farm itself. Food production and its impact on the environment are a major concern in the current human and global climate change. Promoting food production by combining aquaponics with traditional vertical …

    Published in Trends in Mechanical Engineering & Technology · Vol. 10, Issue 2, 2020 · pp. 11–13 Read article

  • Published Subscription

    A Review on Waterjet Cutting of Difficult to Cut Material (Titanium, Inconel)

    By Yogesh Yadav, Mayur Patil, Paramjit Thakur, Krishnapal Singh, Dheeraj Singh

    Abstract: The AWJ is among the modern type of machining with significant advantages over the previously used type machining. The measuring of the cutting depth is very important in progress abrasive waterjet (AWJ) machining system. While cutting Ti-6Al-4V under waterjet, it is important to measure the cutting depth of the required material at the instant of cutting.

    Published in Journal of Production Research & Management · Vol. 10, Issue 2, 2020 · pp. 1–2 Read article

Support