Research profile
5 papers in 3 journals, 2013–2021. Written with 10 co-authors. Corresponding author on 5.
5 publications
-
Published Subscription
Comparative Study of Future Processor Design Models for Energy EfficiencyBy Nikesh A. Shah, D. H. Ahir
Abstract: This paper describes the comparative analysis of the conceived future many core processor models not only for optimum performance but having the efficient power consumption too. There is a need of the energy efficient parallel cores along with the high throughput and higher performance sequential core to have future competent processors to meet the demand of the Moore’s law. One can have homogeneous cores structure as well as heterogeneous cores …
Published in Current Trends in Signal Processing · Vol. 4, Issue 1, 2014 · pp. 1–3 Read article →
-
Published Subscription
New Generation Nanocrystalline Silicon Carbide for Implants and ProsthesesBy Nikesh A. Shah, Kacha Pinank, K. N. Rathod, Chirag Savaliya, Davit Dhruv, D. D. Pandya, J. H. Markna, N. A. Shah
Abstract: Nanocrystalline silicon carbide (SiC) is an aspirant material for artificial heart valves primarily due to its low weight, high strength, acute hardness, wear resistance, inertness (SiC does not react with biological fluids), and deterioration resistance. Oxide ceramic materials such as alumina (Al2O3) and zirconia (ZrO2) are often used for medical applications like implants and prostheses because of their terrific biocompatibility and high wear resistance. Unfortunately, oxide ceramics cannot be used …
Published in Journal of Nanoscience, NanoEngineering & Applications · Vol. 5, Issue 3, 2015 · pp. 11–18 Read article →
-
Published Subscription
Voltage-controlled TCR (Temperature Sensitivity) in Nanostructured Y0.95Ca0.05MnO3/Si, p-n Junction DiodeBy Davit Dhurv, J. H. Markna, P. S. Solanki, Nikesh A. Shah
Abstract: The authors deposited a p-type Y0.95Ca0.05MnO3 on the n-type Si substrate using chemical solution deposition and form nanostructured Y0.95Ca0.05MnO3/n-Si, p-n junction diode with typical thickness of about 100 nm with polycrystalline in nature. The diode exhibits rectifying properties over the temperature range of 100–300 K. Voltage-dependent temperature sensitivity of Y0.95Ca0.05MnO3/n-Si, p-n junction diode has been studied in current perpendicular to film plane (CPP) geometry. The maximum percentage of TCR values …
Published in Journal of Nanoscience, NanoEngineering & Applications · Vol. 4, Issue 1, 2014 · pp. 29–32 Read article →
-
Published Subscription
Power Consumption Reduction using Microarchitecture Techniques for Modern Multicore MicroprocessorsBy Nikesh A. Shah, D. H. Ahir
Abstract: The development in the semiconductor technology is helping the designer to make the systems as compact as possible. We are moving towards 14 nm fabrication technology. The technology scaling is going much down but it is also the reason to bring several crucial issues on the surface which is very difficult to handle. The various advance processor architecture design concepts helped in increasing speed by keeping the power consumption under …
Published in Current Trends in Information Technology · Vol. 3, Issue 3, 2013 · pp. 16–20 Read article →
-
Published Subscription
Effect of Sintering Temperature on Dielectric Behavior of Y0.95Ca0.05MnO3 ManganitesBy Nikesh A. Shah
Abstract: Ca-doped mixed valent Y0.95Ca0.05MnO3 (YCMO) manganites, synthesized using cost effective acetic acid based modified sol-gel method, sintered at various temperatures, exhibit a strong effect of sintering temperature on the structure, microstructure, dielectric and activation energy (Ea). Oxygen vacancies, located at the grain boundaries of the nanostructured YCMO samples, play an important role in governing the dielectric behavior. The peak behavior, observed in imaginary part of dielectric (εʹʹ vs. T) plots, …
Published in Journal of Nanoscience, NanoEngineering & Applications · Vol. 3, Issue 2, 2013 · pp. 24–29 Read article →